Physical properties of sediment core AND-2A

Whole-core measurements of Wet Bulk Density (WBD), compressional (P)-wave velocity (Vp), and Magnetic Susceptibility were measured at a sampling interval of 1 or 2 centimetres (cm) throughout the AND-2A drill core for initial core characterisation and on-site correlation with seismic modeling to predict target-reflector depth. Measurements were made using a GEOTEK (Multi-Sensor-Core-Logger MSCL). Density and velocity standards were measured together with core runs of 3-6 metres (m) (and occasionally up to 18 m) throughout the entire depth range to monitor data quality. Drift of the magnetic susceptibility sensor was also monitored and corrected where necessary. These physical properties show a large range of values, reflecting the different nature of the various lithologies including extremely high velocity and density values in individual clasts, and the effects of cementation on porosity. A downcore increase in WBD and Vp occurs in the upper 200 m, however, no systematic trend exists at greater depths although large fluctuations on a m-decimetre- (dm) scale occur. Magnetic susceptibility is generally low (<100 x 10-5 SI), however, four intervals of high (>600 x 10-5 SI) susceptibility occur at 560, 800, 980 and 1 080 mbsf, indicating a relatively greater contribution of volcanic-derived material to the core site in the lower half of the AND-2A core.

Semiquantitative occurence of various minerals in sediment core CRP-2A

The mineralogy of the lower Oligocene to Quaternary sediments of core CRP-2/2A drilled on the continental shelf of McMurdo Sound in Ross Sea, Antarctica, was examined by the X-ray diffraction method. Quartz, plagioclase feldspar and K-feldspar are the most important non-clay minerals. Pyroxene and amphibole occur in minor amounts throughout the core. The composition of the sediments points to an origin in the Transantarctic Mountains for the majority of the detrital components. There, the plutonic and metamorphic rocks of the basement, the sediments of the Beacon Supergroup and the volcanic rocks of the Ferrar Group could serve as possible source lithologies. The distribution of the detrital minerals reflects a long-term history of successive erosion and valley incision. During the deposition of the lower part of the core, the detrital minerals were probably mainly derived from the sediments of the Beacon Supergroup, as indicated by the high quartz but relatively low feldspar abundances. In the upper c. 350 m of the core, the influence of a source in the basement became stronger and results in lower quartz contents but increasing abundance of feldspar. Some diagenetic alteration of the sediments is indicated by the occurrence of zeolites below c. 320 mbsf and of opal-CT above c. 320 mbsf.