alpha- and gamma-Hexachlorocyclohexane concentrations in brine, bulk sea-ice, water and air during a CCGS Amundsen cruise to the Canadian western Arctic

We used holes augered partially into first-year sea ice (sumps) to determine a- and g-HCH concentrations in sea-ice brine. The overwintering of the CCGS Amundsen in the Canadian western Arctic, as part of the Circumpolar Flaw Lead (CFL) System Study, provided the circumstances to allow brine to accumulate in sumps sufficiently to test the methodology. We show, for the first time, that as much as 50% of total HCHs in seawater can become entrapped within the ice crystal matrix. On average, in the winter first-year sea ice HCH brine concentrations reached 4.013 ± 0.307 ng/L and 0.423 ± 0.013 ng/L for the a- and g-isomer, respectively. In the spring, HCHs decreased gradually with time, with increasing brine volume fraction and decreasing brine salinity. These decreasing concentrations could be accounted for by both the dilution with the ice crystal matrix and under-ice seawater. We propose that the former process plays a more significant role considering brine volume fractions calculated in this study were below 20%. Levels of HCHs in the brine exceed under-ice water concentrations by approximately a factor of 3, a circumstance suggesting that the brine ecosystem has been, and continues to be, the most exposed to HCHs.

Wet-bulk densities, mean atomic weights, effective porosities, grain densities, and compressional-wave velocities at DSDP Leg 58 Holes

The effects of water saturation and open pore space on the seismic velocities of crystalline rocks are extremely important when comparing laboratory data to in situ geophysical observations (e.g., Dortman and Magid, 1969; Nur and Simmons, 1969; Christensen and Salisbury, 1975). The existence of fractured rocks, flow breccias and drained pillows in oceanic crustal layer 2a, for instance, may appreciably reduce seismic velocities in that layer (Hyndman, 1976). Laboratory data assessing the influence of porosity and water saturation on seismic velocities of oceanic crustal rocks would certainly aid interpretation of marine geophysical data. Igneous rocks recovered during Leg 58 of the Deep Sea Drilling Project, in the Shikoku Basin and Daito Basin in the North Philippine Sea, are extremely vesicular, as evidenced by shipboard measurements of porosities, which range from 0 to 30 per cent (see reports on Sites 442, 443, 444, and 446, this volume). Samples with this range of porosities afford an excellent opportunity to examine the influence of porosity and water saturation on seismic velocities of oceanic basalts. This paper presents compressional-wave velocities to confining pressures of 1.5 kbars for water-saturated and air-dried basalt samples from the North Philippine Sea. Samples used in this study are from sites 442, 443 and 444 in the Shikoku Basin and Site 446 in the Daito Basin. Excellent negative correlation between porosity and compressional-wave velocity demonstrates that waterfilled pore space can significantly reduce compressionalwave velocities in porous basalts. Velocities measured in air-dried samples indicate that the velocity difference between dry samples and saturated samples is small for porosities exceeding 10 per cent, and very large for lower porosities.

Calcareous nannofossil stratigraphy, mass accumulation rates and bulk density of sediments from ODP Leg 173 sites

Drilling on the Iberia Abyssal Plain during Ocean Drilling Program Leg 173 allowed us to recover Upper Cretaceous through Paleocene sediments at Sites 1068 and 1069 and only upper Paleocene sediments at Site 1067, which expands considerably the Upper Cretaceous to Paleocene record for this region. Of these three sites, Site 1068 recovered uppermost Cretaceous sediments as well as the most complete Paleocene record, whereas Site 1067 yielded only uppermost Paleocene sediments (Zone CP8). Site 1069 provided a rather complete upper Campanian through Maastrichtian section but a discontinuous Paleocene record. After a detailed calcareous nannofossil biostratigraphy was documented in distribution charts, we calculated mass accumulation rates for Holes 1068A and 1069A. Sediments in Hole 1068A apparently record the final stages of burial of a high basement block by turbidity flows. Accumulation rates through the Upper Cretaceous indicate relatively high rates, 0.95 g/cm**2/k.y., but may be unreliable because of the lack of datum points and/or possible hiatuses. Accumulation rates in the Paleocene section of Hole 1068A fluctuated every few million years from lower (~0.35 g/cm**2/k.y.) to higher rates (~0.85 g/cm**2/k.y.) until the latest Paleocene, when rates increased to an average of ~2.0 g/cm**2/k.y. Mass accumulation rates for the Upper Cretaceous in Hole 1069A indicate a steady rate of ~0.60 g/cm**2/k.y. from 75 to 72 Ma. There may have been one or more hiatuses between 72 and 68 Ma (combined Zone CC24 through Subzone CC25b), as indicated by the very low accumulation rate of 0.15 g/cm**2/k.y. The Paleocene section of Hole 1069A does not show the same continuous record, which may result from fluctuations in the carbonate compensation depth and poor recovery (average = 40%). Zones CP4 and CP5 are missing within a barren interval; this and numerous other barren intervals affect the precision of the nannofossil zonation and calculation of mass accumulation rates. However, in spite of these missing zones, mass accumulation rates do not seem to indicate the presence of hiatuses as the rates for this barren interval average ~1.0 g/cm**2/k.y. This study set out to test the hypothesis that a reliable biostratigraphic record could be constructed from sediments derived from turbidity flows deposited below the carbonate compensation depth. As illustrated here, not only could a reliable biostratigraphic record be determined from these sediments, but sedimentation and mass accumulation rates could also be determined, allowing inferences to be drawn concerning the sedimentary history of this passive margin. The reliability of this record is confirmed by independent verification by the establishment of a magnetostratigraphy for the same cores.

Bulk and clay mineral composition of ODP Leg 189 sites

Bulk and clay mineral investigations were conducted on ~750 samples from four sites drilled during Ocean Drilling Program Leg 189 on the western Tasmanian margin (Site 1168), the South Tasman Rise (Sites 1170 and 1171), and the East Tasman Plateau (Site 1172). The mineralogy of the bulk sediment is very similar at all sites, and major changes coincide with the boundaries of the three main lithologic units described in the Leg 189 Initial Reports volume. The clay mineral assemblages show significant regional differences, but their major variations coincide at all sites and with major changes in regional tectonics and climate.