Composition of surface layer bottom sediments from the Kem' River estuary, White Sea

Based on grain-size, mineralogical and chemical analyses of samples collected in cruises of R/V Ekolog (Institute of Northern Water Problems, Karelian Research Centre of RAS, Petrozavodsk) in 2001 and 2003 regularities of chemical element distribution in surface layer bottom sediments of the Kem' River Estuary in the White Sea were studied. For some toxic elements labile and refractory forms were determined. Correlation analysis was carried out and ratios Me/Al were calculated as proxies of terrigenous contribution. Distribution of such elements as Fe, Mn, Zn, Cr, Ti was revealed to be influenced by natural factors, mainly by grain size composition of bottom sediments. These metals have a tendency for accumulation in fine-grained sediments with elevated organic carbon contents. Distribution of Ni is different from one of Fe, Mn, Zn, Cr, Ti. An assumption was made that these distinctions were caused by anthropogenic influence.

Sulfur concentrations and isotopic composition of serpentinized oceanic peridotites

The mineralogy, contents, and isotopic compositions of sulfur in oceanic serpentinites reflect variations in temperatures and fluid fluxes. Serpentinization of <1 Ma peridotites at Hess Deep occurred at high temperatures (200°-400°C) and low water/rock ratios. Oxidation of ferrous iron to magnetite maintained low fO2 and produced a reduced, low-sulfur assemblage including NiFe alloy. Small amounts of sulfate reduction by thermophilic microbes occurred as the system cooled, producing low-delta34S sulfide (1.5? to -23.7?). In contrast, serpentinization of Iberian Margin peridotites occurred at low temperatures(~20°-200°C) and high water/rock ratios. Complete serpentinization and consumption of ferrous iron allowed evolution to higher fO2. Microbial reduction of seawater sulfate resulted in addition of low-delta34S sulfide (~15 to ~43?) and formation of higher-sulfur assemblages that include valleriite and pyrite. The high SO4/total S ratio of Hess Deep serpentinites (0.89) results in an increase of total sulfur and high delta34S of total sulfur (mean ~8?). In contrast, Iberian Margin serpentinites gained large amounts of 34S-poor sulfide (mean total S = 3800 ppm), and the high sulfide/total S ratio (0.61) results in a net decrease in delta34S of total sulfur (mean ~ -5?). Thus serpentinization is a net sink for seawater sulfur, but the amount fixed and its isotopic composition vary significantly. Serpentinization may result in uptake of 0.4-14 * 10**12 g S/yr from the oceans, comparable to isotopic exchange in mafic rocks of seafloor hydrothermal systems and approaching global fluxes of riverine sulfate input and sedimentary sulfide output.

Geochemistry of rocks from Palmer Archipel

During the antarctic summer season in 1984 and 1986 field studies and laboratory investigations of the Mesozoic Intrusive Suite of the Palmer Archipel were carried out in cooperation with the Chilean Antarctic Institute and the University of Concepcion, Volcanic formations and intrusive series are the dominant exposed rocks together with very subordinate metasediments. Different petrological and isotopic data allow to divide the Antarctic Intrusive Suite into two intrusive types: a) Palmer Batholith (Lower Cenozoic) b) Costa Danco intrusive rocks (Upper Cretaceous). Both types belong to a calc-alkaline series. The granitoid rocks show an I-type-affinity. Ore minerals (pyrite, chalcopyrite, bornite, covellite, cuprite, pyrrhotite, magnetite and ilmenite) are mainly restricted to the intermediate rock types (e. g. granodiorites}. Propylitisation and kaolinisation are the observed alteration types, which suggest, together with the disseminated and vein-like ore fabrics the comparison with the andean Porphyry-Copper- and vein-type-deposits. The volcanic formations are subdivided into a) the Upper Cretaceous Wiencke Formation, which is composed of andesites and andesitic breccias, and b) into the Jurassic Lautaro Formation with basaltic, andesitic, dacitic and some rhyolitic rocks together with volcanic breccias. These calc-alkaline volcanic rocks apparently are part of an island are. A strong alteration of primary minerals is very common; however, the low ore mineral content does not change significantly within the different alteration types.

Oxidation rate of thiosulfate and elemental sulfur in the Black Sea

Oxidation rate of 35S-thiosulfate under simulated natural conditions and abundance of thiosulfate-oxidizing bacteria in a redox zone of the Black Sea are lower during winter and spring than in summer, especially in halistatic regions. Oxidation of thiosulfate under natural conditions is performed chiefly by lithotropic thionic bacteria, whose activity is limited by low temperatures. Adding thiosulfate and readily available organic matter to water samples from the redox zone and raising temperature of water stimulated activity of heterotrophic thiosulfate-oxidizing bacteria. Oxidation of elemental sulfur tagged with 35S apparently invovled two stages: abiotic oxidation of thiosulfate and subsequent bacterial oxidation of thiosulfate to sulfate.

Composition of Fe-Mn micronodules, nodules and host bottom sediments from the Northeast Pacific Basin

Authigenic ferromanganese manifestations in bottom sediments from two horizons (0-10 and 240-250 cm) located in the low/high bioproductive transitional zone of the Pacific Ocean were studied. In addition two compositionally different types of micronodules, crusts and ferromanganese nodules were detected in the surface horizon (0-1 cm). Three size fractions (50-100, 100-250, and 250-500 µm) of manganese micronodules were investigated. In terms of surface morphology, color, and shape, the micronodules are divided into dull round (MN1) and angular lustrous (MN2) varieties with different mineral and chemical compositions. MN1 are enriched in Mn and depleted in Fe as compared with MN2. Mn/Fe ratio in MN1 varies from 13 to 14. Asbolane-buserite and birnessite are the major manganese minerals in them. MN2 is mainly composed of vernadite with Mn/Fe ratio from 4.3 to 4.8. Relative to MN1, fraction 50-100 µm of MN2 is enriched in Fe (2.6 times), W (1.8), Mo (3.2), Th (2.3), Ce (5.8), and REE (from 1.2 to 1.8). Relative to counterparts from MN1, separate fractions of MN2 are characterized by greater compositional difference. For example, increase in size of micronodules leads to decrease in contents of Fe (by 10 rel. %), Ce (2 times), W (2.1 times), Mo (2.2 times), and Co (1.5 times). At the same time one can see increase in contents of other elements: Th and Cu (2.1 times), Ni (1.9 times), and REE (from 1.2 to 1.6 times). Differences in chemical and mineral compositions of MN1 and MN2 fractions can be related to alternation of oxidative and suboxidative conditions in the sediments owing to input of labile organic matter, which acts as the major reducer, and allochthonous genesis of MN2.

Chemical composition of hydrothermal deposits and vulcanites from the Menez Gwen vent field, Mid-Atlantic Ridge

Surface hydrothermal deposits of the shallow-water Menez Gwen vent field located in the rift zone of the Mid-Atlantic Ridge are mostly composed of nonmetalliferous minerals in contrast to sulfide deposits of deep-water fields. Here sulfide minerals occur only in dispersed form. High-temperature sulfide deposits strongly enriched in copper and zinc occur only immediately below the surface of the bottom. This is related to subsurface boiling and phase separation of initial high-temperature hydrothermal ore-bearing solution that ascends from the interior to the floor surface.

Rare earth elements in bottom sediments from the deeps of the Red Sea rift zone

Analysis of rare earth element (REE) distribution and behavior in ore-bearing hydrothermal-sedimentary deposits from the Red Sea is carried out. Geochemical patterns and mechanisms of REE accumulation in metalliferous sediments of the open ocean and in deposits adjoined to areas of hydrothermal discharge are shown. Main factors, which determine composition of REE and the level of their accumulation in hydrothermal occurrences of the Red Sea, are considered.

Mineralogy, chemistry and stable isotope composition of hydrothermal altered sheeted dikes of ODP Hole 111-504B

During ODP Leg 111 Hole 504B was extended 212 m deeper into the sheeted dikes of oceanic Layer 2, for a total penetration of 1288 m within basement. Study of the mineralogy, chemistry, and stable isotopic compositions of the rocks recovered on Leg 111 has confirmed and extended the previous model for hydrothermal alteration at the site: axial greenschist hydrothermal metamorphism was followed by seawater recharge and subsequent off-axis alteration. The dikes are depleted in 18O (mean delta18O = +5.1 ? +/- 0.6 ?) relative to fresh mid-ocean ridge basalt. Oxygen isotopic data on whole rocks and isolated secondary minerals indicate temperatures during axial metamorphism of 250°-350°C and water/rock ratios about one. Increasing amounts of actinolite with depth in the dike section, however, suggest that temperatures increased downward in the dikes. Pyrite + pyrrhotite + chalcopyrite + magnetite was the stable sulfide + oxide mineral assemblage during axial alteration, but these minerals partly re-equilibrated later at temperatures less than 200°C. The dikes sampled on Leg 111 contain an average of 500 ppm sulfur, slightly lower than igneous values. The delta34S values of sulfide average 0?, which indicates the presence of basaltic sulfide and incorporation of little or no seawater-derived sulfide into the rocks. These data are consistent with models for the presence of rock-dominated sulfur in deep hydrothermal fluids. The presence of anhydrite at 1176 m within basement indicates that unaltered seawater can penetrate to significant depths in the crust during recharge.

Contencentrations of reduced inorganic sulfur forms in Mediterranean Sea waters

The first data on content of inorganic reduced sulfur compounds [H2S, S°, S2O3(2-), SO3(2-)] were obtained at two stations in the northeastern Levant Sea (Mediterranean Basin). With lower detection limit for the mentioned sulfur forms of 30 nM, sulfide forms were not found, while thiosulfate concentration varied from 178 to 890 nM (from 24 to 78 % of total reduced S), and S° varied from 156 to 1090 nM. Vertical distribution of these compounds showed irregular character; correlation between total reduced S maxima, fluorescence, and increase of nutrient element content near the lower pycnocline boundary was observed. The maximum total sulfur concentration in the surface layer was likely due an anthropogenic influence. The ''starting'' mechanism that controls appearance and distribution of sulfur compounds in oxygen-containing water is the process of bacterial sulfate reduction in micropatches of fresh organic detritus. Reduced sulfur forms participate further in a series of chemical and biochemical processes. Contribution of hydrolysis of organic sulfur-containing compounds is insignificant for the region in study.

Chemistry of sulfide deposits from ODP Site 106-649

In Snake Pit massive sulfide fragments and friable, unconsolidated material recovered during ODP Leg 106, isocubanite and pyrite are generally the predominant phases, followed by marcasite, chalcopyrite, sphalerite, and pyrrhotite. Detailed analyses of paragenetic relations of minerals indicate that isocubanite first precipitated together with pyrrhotite. With decreasing temperature, chalcopyrite and sphalerite precipitated, and at the latest stage colloform sphalerite-pyrite (or colloform marcasite) formed. Isocubanite usually has exsolution lamellae of chalcopyrite and less commonly of pyrrhotite. The average bulk chemical composition of the friable, unconsolidated material indicates that it is rich in copper, reflecting the dominance of isocubanite in the specimens, and is characterized by high Co, low Pb, and Ag contents. Sulfur isotope ratios are very uniform, ranging in d34S from +1.2 to +2.8 per mil. The obtained values are apparently low, compared to those for the eastern Pacific sulfide samples, reflecting a smaller contribution of seawater sulfate in the Snake Pit sulfide deposit.