Tab. 6+7: Altitudes and variations of altitudes in the area of the Filchner and Neumayer Stations

The determination of the strain and velocity behaviour of the ice surface near the two German Antarctic Stations on Filchner/Ronne and Ekström ice shelves was performed by the use of various geodetic measuring techniques. The relative positions and heights of control points valid for reference data were deduced from terrestrial observations (horizontal and vertical angle selectro optical distances). After a second sampling of data, these values served as the basis for the deformation analyses. Doppler-Satellite-observations (Navy Navigation Satellite System) made absolute positioning (latitude, longitude, height) of special points possible. These Doppler observations, supported by azimuth measurements (gyro-theodolite and sun observations) provided the datum of control networks (translations and orientation). After the repetition of these observations, the drift rates and azimuths of the control points as wenas the rotanon rates of the surface elements could be given. From vertical angles and horizontal distances differences in height end refraction coefficients were calculated. On days without clouds the refraction coefflcients increased by arnounts of up to 3.0 (in extreme cases up to 5.0). Distances over 1 km have to be subdivided to reach a standard deviation level of an heigh: difference better than 0.05 m. In order to determine the heterögeneity of refraction, some height differences should be measured with higher accuracy end-by subdivision of distances.

(Table 1) Zoobenthos from the gas-hydrate seep area near the Paramushir Island and its chemical composition

Distributions of Mn, Fe, Cu, Cd, Cr, Co and Ni in sea water are investigated (42 samples, dissolved and particulate forms) in the vicinity of the underwater gas vent field on the northwestern slope of the Paramushir Island. While regular background distributions of the elements occur in the shore zone, there is a column of elevated concentrations of particulate matter, particulate Mn, and dissolved Mn, Fe, Cu, Cd, Cr, Co and Ni that coincides with location of the gas plume. This column can be traced as high as 780 m above the bottom. High metal concentrations in water of the plume are attributable to physico-chemical concentration at the phase interface; the source of elevated mineral concentrations is obviously flux of dissolved minerals from interstitial waters, which extends to considerable distances in vertical direction.

(Table 2) Production parameters of phytoplankton and some associated parameters in the area of the Titanic Polygon

Studies were carried out mostly in the area of RMS Titanic wreck site (41°44'N, 49°57'W) located above the continental slope and the south of the Grand Banks of Newfoundland. In a period from 18.06 to 24.09.2001 five surveys of production characteristics of surface phytoplankton were conducted over 5-9 days. Mean values of these characteristics obtained during the surveys were 9.2-11.7 mg C/m**3 per day for primary production (C_phs), 0.102-0.188 mg/m**3 for chlorophyll a (C_chls), and 4.44-7.42 mg C/mg chl. a per hour for assimilation number (AN). The main reason for low C_phs variability was a significant inverse relationship (R=-0.66) between AN and C_chls found over the research area. When cold shelf waters dominated in the area (27.07 to 19.08.2001), C_chls values for the slope region (0.125+/-0.031 µg/l) and for the outer shelf (0.130+/-0.040 µg/l) were similar. During strengthening of influence of warmer slope waters within area (from 29.08 to 13.09.2001), C_chls concentration within surface waters of the outer shelf was 0.152+/-0.039 µg/l and exceeded one for the slope region (0.094+/-0.004 µg/l) by factor 1.6. Against the background of low Cchls values, the High values of integral primary production in the water column (510-1010 mg C/m**2 per day) at low C_chls values measured within the area were determined both by high assimilation activity of phytoplankton and by the deep (30-40 m) maximum of primary production. Main reasons for formation of such a maximum were high chlorophyll concentration within the layer of the deep chlorophyll maximum (up to 0.5-2.5 µg/l) and in the relatively high solar irradiance within this layer varying from 1.4 to 8.6% of subsurface PAR.

Mineralogical assemblage in sediment core GeoB12309-5 and in area samples from the Makran subduction zone

In order to study late Holocene changes in sediment supply into the northern Arabian Sea, a 5.3 m long gravity core was investigated by high-resolution geochemical and mineralogical techniques. The sediment core was recovered at a water depth of 956 m from the continental slope off Pakistan and covers a time span of 5 kyr. During the late Holocene source areas delivering material to the sampling site did, however, not change and were active throughout the year.