Petrology and isotope characteristics of basalts from ODP Hole 111-504B

Petrography and isotope geochemical characteristics of H, O, S, Sr, and Nd have been described for basalts recovered from Hole 504B during Leg 111 of the Ocean Drilling Program. The petrographic and chemical features of the recovered basalts are similar to those obtained previously (DSDP Legs 69, 70, and 83); they can be divided into phyric (plagioclase-rich) and aphyric (Plagioclase- and clinopyroxene-rich) basalts and show low abundances of TiO2, Na2O, K2O, and Sr. This indicates that the basalts belong to Group D, comprising the majority of the upper section of the Hole 504B. The diopside-rich nature of the clinopyroxene phenocrysts and Ca-rich nature of the Plagioclase phenocrysts are also consistent with the preceding statement. The Sr and Nd isotope systematics (average 87Sr/86Sr = 0.70267 ± 0.00007 and average 143Nd/144Nd = 0.513157 ± 0.000041) indicate that the magma sources are isotopically heterogeneous, although the analyzed samples represent only the lowermost 200-m section of Hole 504B. The rocks were subjected to moderate hydrothermal alteration throughout the section recovered during Leg 111. Alteration is limited to interstices, microfractures, and grain boundaries of the primary minerals, forming chlorite, actinolite, talc, smectite, quartz, sphene, and pyrite. In harmony with the moderate alteration, the following alteration-sensitive parameters show rather limited ranges of variation: H2O = 1.1 ±0.2 wt%, dD = - 38 per mil ± 4 per mil, d180 = 5.4 per mil ± 0.3 per mil, total S = 562 ± 181 ppm, and d34S = 0.8 per mil ± 0.3 per mil. Based on these data, it was estimated that the hydrothermal fluids had dD and d180 values only slightly higher than those of seawater, the water/rock ratios were as low as 0.02-0.2, and the temperature of alteration was 300°-400°C. Sulfur exists predominantly as pyrite and in minor quantities as chalcopyrite. No primary monosulfide was detected. This and the d34S values of pyrite (d34S = 0.8 per mil) suggest that primary pyrrhotite was almost completely oxidized to pyrite by reaction with hydrothermal fluids containing very little sulfate.

Petrology of basalts from DSDP Hole 83-504B

Basalts from Hole 504B, Leg 83, exhibit remarkable uniformity in major and trace element composition throughout the 1075.5 m of basement drilled. The majority of the basalts, Group D', have unusual compositions relative to normal (Type I) mid-ocean ridge basalts (MORB). These basalts have relatively high mg values (0.60-0.70) and CaO abundances (11.7-13.7%; Ca/Al = 0.78-0.89), but exhibit a marked depletion in compatible trace elements (Cr and Ni); moderately incompatible trace elements (Zr, Y, Ti, etc.); and highly incompatible trace elements (Nb, LREE, etc.). Petrographic and compositional data indicate that most of these basalts are evolved, having fractionated significant amounts of plagioclase, olivine, and clinopyroxene. Melting experiments on similar basalt compositions from the upper portion of Hole 504B (Leg 70; Autio and Rhodes, 1983) indicate that the basalts are co-saturated with olivine and plagioclase and often clinopyroxene on the 1-atm. liquidus. Two rarely occurring groups, M' and T, are compositionally distinct from Group D' basalts. Group T is strongly depleted in all magmaphile elements except the highly incompatible ones (Nb, La, etc.), while Group M' has moderate concentrations of both moderately and highly incompatible trace elements and is similar to Type I MORB. Groups M' and T cannot be related to Group D' nor to each other by crystal fractionation, crystal accumulation, or magma mixing. The large differences in magmaphile element ratios (Zr/Nb, La/Yb) among these three chemical groups may be accounted for by complex melting models and/or local heterogeneity of the mantle beneath the Costa Rica Ridge. Xenocrysts and xenoliths of plagioclase and clinopyroxene similar in texture and mineral composition to crystals in coarse-grained basalts from the lower portion of the hole are common in Hole 504B basalts. These suggest that addition of solid components either from conduit or magma chamber walls has occurred and may be a common source of disequilibrium crystals in these basalts. However, mixing of plagioclase-laden depleted melts (similar to the Costa Rica Ridge Zone basalts) with normal MORB magmas could provide an alternate source for some refractory plagioclase crystals found out of equilibrium in many phyric MORB. The uniformity of major element compositions in Hole 504B basalts affords an ideal situation for investigating the effects of alteration on some major and trace elements in oceanic basalts. Alteration observed in whole-rock samples records primarily two events - a high-temperature and a low-temperature phase. High-temperature phases include: chlorite, talc, albite, actinolite, sphene, quartz, and pyrite. The low-temperature phases include smectite (saponite), epistilbite or laumontite, and minor calcite. Laumontite may actually straddle the gap between the low- and high-temperature mineral assemblages. Alteration is restricted primarily to partial replacement of primary phases. Metamorphic grade, in general, increases from the top to the bottom of Hole 504B (Legs 69, 70, and 83) as seen in the change from a smectiteto- chlorite-dominated secondary mineral assemblage. However, a systematic progression for the interval recovered during Leg 83 is not apparent. Rather, the extent of alteration appears to be a function of the initial texture and fracture density. Variations in whole-rock major and trace element concentrations cannot be attributed convincingly to any differences in alteration observed. Compositional characteristics of the secondary minerals indicated that extensive remobilization of elements has not occurred; local redistribution is suggested in most cases. Thus, the major and trace element signature of these basalts remains effectively the same as the original composition prior to alteration.

Geochemical compositions of minerals from chilled dike margins of ODP Hole 140-504B

Mineral and whole-rock geochemical data are presented for chilled dike margins from the lower sheeted dike complex of Deep Sea Drilling Project/Ocean Drilling Program (DSDP/ODP) Hole 504B. Compositions of phenocrystic plagioclase (An80-89); olivine (Fo82-86); clinopyroxene (Wo52En40Fs8, with Cr2O3 up to 1.2%); and rare chromian spinel (Cr# 43) are consistent with those from the lavas and the upper dike complex recovered previously (DSDP Legs 69, 70, 83, and ODP Leg 111). Major and trace element compositions fall in group D of Autio and Rhodes (1983) and have high CaO/Na2O, and low TiO2, K2O, and (La/Sm)N values consistent with previous analyses from this site.

(Table 1) B content, d11B, d18O, degree of alteration, and lithology of basalts from ODP Hole 504B

Boron contents and boron isotopic compositions were determined for the uppermost 1.3 km section of typical 6.2 Ma oceanic crust from DSDP/ODP Hole 504B, Costa Rica Rift, Galapagos Spreading Center. Both the boron content and the d11B value in the oceanic crust are controlled by two types of alteration: 1. (1) low-temperature alteration (0 to 60°C; Zones I and II) and 2. (2) high-temperature hydrothermal alteration (200 to 400°C; Zones III and IV). Basalts subjected to the low-temperature alteration are characterized by their relatively high boron contents (0.69 to 19.3 ppm) and high d11B values (+2.2 to +10.6?), indicating uptake of boron into secondary phases in equilibrium with seawater or evolved seawater. Hydrothermally altered basalts contain less abundant boron (0.17 to 0.52 ppm) and relatively constant d11B values (?0.1 to +1.0?). Although basalts from the upper part of these hydrothermal zones (<1300 mbsf) show equilibrated boron content and d11B value with aqueous fluid, effective leaching of boron from basalt is predominant in the lower part (>1300 mbsf). Original boron content and d11B value of the Hole 504B MORB were 0.35 ppm and +0.2?, respectively. The present data provide fundamental information in understanding of the distribution of boron and boron isotopes in the oceanic crust.

(Table 1) Strontium concentrations and isotope ratios of anhydrite from DSDP/ODP Hole 504B

In samples from 1575 to 1982 mbsf anhydrite leached from whole-rock powders. 87Sr/86Sr and Sr/Ca determined following methods described in (Teagle et al., 1996, doi:10.2973/odp.proc.sr.148.113.1996, Teagle et al., 1998, doi:10.2973/odp.proc.sr.158.223.1998). For the period of the analysis (Jan. 1994-Dec. 1995) NIST SRM 987 gave 87Sr/86Srs0.710244 +/- 0.000018 (2 sigma, n = 115). Full analytical procedural blanks were <50 pg for Sr. delta18O following (Pickthorn and O´Neil, 1985). Repeated extractions and measurements of samples and standards were reproducible within +/- 0.5.