(Table 1) Chemical element contents in ferromanganese encrustations from the Sierra Leone Rise

A detailed study of chemical and mineral compositions of ferromanganese encrustations indicated that their variability dependent on composition of host substrate and on geological and oceanological processes.

Geochemical composition and atomic formulas of saponites, celadonites and carbonates from ODP Leg 168 sites

With this study, we investigate the mineralogical variations associated with the low-temperature (<100°C) alteration of normal tholeiitic pillow basalts varying in age from 0.8 to 3.5 Ma. Their alteration intensity varies systematically and is related to several factors, including (1) the aging of the igneous crust, (2) the increase of temperatures from the younger to the older sites, measured at the sediment/basement interface, (3) the local and regional variations in lithology and primary porosity, and (4) the degree of pillow fracturing. Fractures represent the most important pathways that allow significant penetration of fluids into the rock and are virtually the only factor controlling the alteration of the glassy rim and the early stages of pillow alteration. Three different alteration stages have been recognized: alteration of glassy margin, oxidizing alteration through fluid circulation in fracture systems, and reducing alteration through diffusion. All the observed mineralogical and chemical variations occurring during the early stages of alteration are interpreted as the result of the rock interaction with "normal," alkaline, and oxidizing seawater, along preferential pathways represented by the concentric and radial crack systems. The chemical composition of the fluid progressively evolves while moving into the basalt, leading to a reducing alteration stage, which is initially responsible for the precipitation of Fe-rich saponite and minor sulfides and subsequently for the widespread formation of carbonates. At the same time, the system evolved from being "water dominated" to being "rock dominated." No alteration effects in pillow basalts were observed that must have occurred at temperatures higher than those measured during Leg 168 at the basement/sediment interface (e.g., between 15° and 64°C).

Concentrations and accumulation rates of chemical elements and sediment components in sediments of central equatorial Pacific, DSDP data

Accumulation rates of Mg, Al, Si, Mn, Fe, Ni, Cu, Zn, opal, and calcium carbonate have been calculated from their concentrations in samples from equatorial Deep Sea Drilling Project sites. Maps of element accumulation rates and of Q-mode factors derived from raw data indicate that the flux of trace metals to equatorial Pacific sediments has varied markedly through time and space in response to changes in the relative and absolute influence of several depositional influences: biogenic, detrital, authigenic, and hydrothermal sedimentation. Biologically derived material dominates the sediment of the equatorial Pacific. The distributions of Cu and Zn are most influenced by surface-water biological activity, but Ni, Al, Fe, and Mn are also incorporated into biological material. All of these elements have equatorial accumulation maxima similar to those of opal and calcium carbonate at times during the past 50 m.y. Detritus distributed by trade winds and equatorial surface circulation contributes Al, non-biogenic Si, Fe, and Mg to the region. Detrital sediment is most important in areas with a small supply of biogenic debris and low bulk-accumulation rates. Al accumulation generally increases toward the north and east, indicating its continental source and distribution by the northeast trade winds. Maxima in biological productivity during middle Eocene and latest Miocene to early Pliocene time and concomitant well-developed surface circulation contributed toward temporal maxima in the accumulation rates of Cu, Zn, Ni, and Al in sediments of those ages. Authigenic material is also important only where bulk-sediment accumulation rates are low. Ni, Cu, Zn, and sometimes Mn are associated with this sediment. Fe is almost entirely of hydrothermal origin. Mn is primarily hydrothermal, but some is probably scavenged from sea water by amorphous iron hydroxide floes along with other elements concentrated in hydrothermal sediments, Ni, Cu, and Zn. During the past 50 m.y. all of these elements accumulated over the East Pacific Rise at rates nearly an order of magnitude higher than those at non-rise-crest sites. In addition, factor analysis indicates that some of this material is carried substantial distances to the west of the rise crest. Accumulation rates of Fe in basal metalliferous sediments indicate that the hydrothermal activity that supplied amorphous Fe oxides to the East Pacific Rise areas was most intense during middle Eocene and late Miocene to early Pliocene time.

(Table 2, page 725) Solid phase chemistry of ferromanganese precipitates from Nova Scotian lakes

Sediments associated with freshwater ferromanganese concretions in Lake Charlotte, Nova Scotia, contained microscopic precipitates of manganese and iron. These precipitates were dispersed throughout the sediment and were as rich in nickel, cobalt, and copper as deep sea concretions. In addition, the development of the precipitates appeared to be associated with the microbial oxidation of manganese. Results from the deployment of poisoned and unpoisoned dialysis probes or peepers demonstrated that microbial manganese oxidation and nickel binding were closely associated, causing a fivefold enhancement of abiotic processes such as adsorption.

Amino acid data of catchment and sediment core samples of four Indian lakes

In the present study, we report the results of comprehensive amino acid (AA) analyses of four Indian lakes from different climate regimes. We focus on the investigation of sediment cores retrieved from the lakes but data of modern sediment as well as vascular plant, soil, and suspended particulate matter samples from individual lakes are also presented. Commonly used degradation and organic matter source indices are tested for their applicability to the lake sediments, and we discuss potential reasons for possible limitations. A principal component analysis including the monomeric AA composition of organic matter of all analysed samples indicates that differences in organic matter sources and the environmental properties of the individual lakes are responsible for the major variability in monomeric AA distribution of the different samples. However, the PCA also gives a factor that most probably separates the samples according to their state of organic matter degradation. Using the factor loadings of the individual AA monomers, we calculate a lake sediment degradation index (LI) that might be applicable to other palaeo-lake investigations.

Abundance of nodules, chemical and mineral compositions of nodules and sediments from the Central Pacific

The monograph considers facial conditions of ore-formation in the Central Equatorial Pacific, as well as lithostratigraphy and local variability of bottom sediments. Mineral composition of nodules, forms of occurrence of chemical elements in sediments and nodules, composition of interstitial waters, age of nodules, regularities and processes of ore formation in the radiolarian belt of the Pacific Ocean zone are also under consideration.

Chemical and germanium isotopic compositions of sediments and sedimentary rocks from ODP Sites 129-801 and 185-1149

A new technique for the precise and accurate determination of Ge stable isotope compositions has been developed and applied to silicate rocks and biogenic opal. The analyses were performed using a continuous flow hydride generation system coupled to a MC-ICP-MS. Samples have been purified through anion- and cation-exchange resins to separate Ge from matrix elements and eliminate potential isobaric interferences. Variations of 74Ge/70Ge ratios are expressed as d74Ge values relative to our internal standard and the long-term external reproducibility of the data is better than 0.2? for sample size as low as 15 ng of Ge. Data are presented for igneous and sedimentary rocks, and the overall variation is 2.4? in d74Ge, representing 12 times the uncertainty of the measurements and demonstrating that the terrestrial isotopic composition of Ge is not unique. Co-variations of 74Ge/70Ge, 73Ge/70Ge and 72Ge/70Ge ratios follow a mass-dependent behaviour and imply natural isotopic fractionation of Ge by physicochemical processes. The range of d74Ge in igneous rocks is only 0.25? without systematic differences among continental crust, oceanic crust or mantle material. On this basis, a Bulk Silicate Earth reservoir with a d74Ge of 1.3+/-0.2? can be defined. In contrast, modern biogenic opal such as marine sponges and authigenic glauconite displayed higher d74Ge values between 2.0? and 3.0?. This suggests that biogenic opal may be significantly enriched in light isotopes with respect to seawater and places a lower bound on the d74Ge of the seawater to +3.0?.This suggests that seawater is isotopically heavy relative to Bulk Silicate Earth and that biogenic opal may be significantly fractionated with respect to seawater. Deep-sea sediments are within the range of the Bulk Silicate Earth while Mesozoic deep-sea cherts (opal and quartz) have d74Ge values ranging from 0.7? to 2.0?. The variable values of the cherts cannot be explained by binary mixing between a biogenic component and a detrital component and are suggestive of enrichment in the light isotope of diagenetic quartz. Further work is now required to determine Ge isotope fractionation by siliceous organisms and to investigate the effect of diagenetic processes during chert lithification.

Chemical and isotopic compositions of deep-sea carbonate sediments and interstitial waters from DSDP Sites 30-288 and 30-289

Interstitial waters and sediments from DSDP sites 288 and 289 contain information on the chemistry and diagenesis of carbonate in deep-sea sediments and on the role of volcanic matter alteration processes. Sr/Ca ratios are species dependent in unaltered foraminifera from site 289 and atom ratios (0.0012-0.0016) exceed those predicted by distribution coefficent data (~0.0004). During diagenesis Sr/Ca ratios of carbonates decrease and reach the theoretical distribution at a depth which is identical to the depth of Sr isotopic equilibration, where 87Sr/86Sr ratios of interstitial waters and carbonates converge. Mg/Ca ratios in the carbonates do not increase with depth as found in some other DSDP sites, possibly because of diagenetic re-equilibration with interstitial waters showing decreasing Mg(2+)/Ca(2+) ratios with depth due to Ca input and Mg removal by alteration of volcanic matter. Interstitial 18O/16O ratios increase with depth at site 289 to d18O = 0.67? (SMOW), reflecting carbonate recrystallization at elevated temperatures (>/= 20°C), the first recorded evidence of this effect in interstitial waters. Interstitial Sr2+ concentrations reach high levels, up to 1 mM, chiefly because of carbonate recrystallization. However, 87Sr/86Sr ratios decrease from 0.7092 to less than 0.7078, lower than for contemporaneous sea water, showing that there is a volcanic input of strontium at depth. This volcanic component is recorded in the Sr isotopic composition of recrystallized calcites. Isotopic compositions of the unrecrystallized calcites suggests that the rate of increase of the 87Sr/86Sr ratio of sea water with time has been faster since 3 my ago than in the preceding 13 my.

Sulfur in oceans and seas

The book summarizes results of long-term studies of sulfur geochemistry in bottom sediments of seas and oceans. Processes of hydrogen sulfide formation in bacterial reduction of sulfates, its transformation into transient and stable compounds of reduced sulfur in liquid and solid phases of sediments are under consideration. Regularities of distribution of sulfate and reduced sulfur in ocean sediments are shown. Problems of sulfur budget in the modern oceans are discussed.