XRD mineralogy of sediments from the Greenland east coast

Quantitative X-Ray Diffraction (qXRD) analysis of the <2 mm sediment fraction from surface (sea floor) samples, and marine sediment cores that span the last 10-12 cal ka BP, are used to describe spatial and temporal variations in non-clay mineral compositions for an area between Kangerlussuaq Trough and Scoresby Sund (?67°-70°N), East Greenland. Bedrock consists primarily of an early Tertiary alkaline complex with high weight% of pyroxene and plagioclase. Farther inland and to the north, the bedrock is dominantly felsic with a high fraction of quartz and potassium feldspars. Principal Component (PC) analysis of the non-clay sediment compositions indicates the importance of quartz and pyroxene as compositional end members, with an abrupt shift from quartz and k-feldspar dominated sediments north of Scoresby Sund to sediments rich in pyroxene and plagioclase feldspars offshore from the early Tertiary basaltic outcrop. Coarse (<2 mm or <1 mm) ice-rafted sediments are largely absent from the trough sediments between ?8 and 5 cal ka BP, but then increase in the last 4 cal ka BP. Compositional unmixing of the sediments in Grivel Basin and Kangerlussuaq Trough indicate the dominance of local over long distance sediment sources, with pulses of sediment from tidewater glaciers in Kangerlussuaq and Nansen fjords reaching the inner shelf during the Neoglaciation. The change in IRD is more dramatic in the sediment grain-size proxies than in the quartz wt%. Forty to seventy percent of the variance in the quartz records from either side of Denmark Strait is explained by low frequency trends, but the data from the Grivel Basin, East Greenland, are distinctly different, with an approximate 2500 yr periodicity.

Density of 9 sediment cores from the Weddell Sea

The wet bulk density is one of the most important parameters of the physical and geological properties of marine sediments. The density is connected directly with sedimentation history and a few sedirnent properties. Knowledge of the fine scale density-depth structure is the base for many model calculations, for both sedimentological and palaeoclimatic research. A density measurement system was designed and built at the Alfred Wegener Institute in Bremerhaven for measuring the wet buk density of sediment cores with high resolution in a non-destructive way. The density is deterrnined by measuring the absorption of Gamma-rays in the sediment. This principle has been used since the 50's in materials research and in the geosciences. In the present case, Cs137 is used as the radioactive source and the intensity is measured by a detector system (scintillator and photomultiplier). Density values are obtainable in both longitudinal core sections and planar cross-sections (the latter are a function of the axial rotation angle). Special studies on inhomogenity can be applied with core rotation. Detection of ice rafted debris (IRD) is made possible with this option. The processes that run the density measurement system are computer controlled. Besides the absorption measurement the core diameter at every measurement point is determined with a potentiometric system. The data values taken are stored on a personal computer. Before starting routine measurements on the sediment cores, a few experiments conceming the statistical aspects of the gamma-ray signal and its accuracy were carried out. These experiments led to such things as the optimum operational parameters. A high spatial resolution in the mm-range is possible with the 4mm-thin gamma-ray measurements. Within five seconds the wet bulk density can be deterrnined with an absolute accuracy of 1%. A comparison between data measured with the new system and conventional measurements on core samples after core splitting shows an agreement within +I- 5% for most of the values. For this thesis, density determinations were carried out on ten sediment cores. A few sediment characteristics are obtainable from using just the standard measurement results without core rotation. In addition to differentes and steps in the absolute density range, variations in the "frequency" of the density-depth structure can be detected due to the close spatial measurement interval and high resolution. Examples from measurements with small (9°) and great (90°) angle increments show that abrupt and smooth transitional changes of sedirnent layers as well as ice rafted debris of several dimensions can be detected and distiflguished clearly. After the presentation of the wet bulk density results, a comparison with data from other investigations was made. Measurements of the electrical resistivity correlated very well with the density data because both parameters are closely related to the porosity of the sedirnent. Additionally, results from measurements of the magnetic susceptibility and from ultra-sonic wave velocity investigations were considered for a integrative interpretation. The correlation of these both parameters and wet bulk density data is strongly dependent on the local (environmental) conditions. Finally, the densities were compared with recordings from sediment-echographic soundings and an X-ray computer tomography analysis. The individual results of all investigations were then finally combined into an accurate picture of the core. Problems of ambiguity, which exist when just one Parameter is determined alone, can be reduced more or less according to the number of parameters and sedimentary characteristics measured. The important role of the density data among other parameters of such an integrated interpretation is evident. Evidence of this role include the high resolution of the measurement, the excellent accuracy and the key position within methods and parameters concerning marine sediments.

(Table 2) d13C from the Lusklint section

The carbon isotope composition (d13C) of bulk organic matter and two palynomorph groups (scolecodonts and chitinozoans) from the Llandovery-Wenlock strata of Gotland (E Sweden) are compared to gain knowledge about carbon cycling in the Silurian (sub)tropical shelf environment. The d13C values of the palynomorphs are mostly lower than the d13C values of the bulk organic matter, and the d13C values of the benthic scolecodonts are lower than those of the planktonic chitinozoans. While the difference between bulk and palynomorph d13C may be in part a function of trophic state, the lower values of the scolecodonts relative to those of chitinozoans, which are assumed to live in the well-mixed water column, might imply an infaunal mode of life for the polychaetes that carried the scolecodonts. Lower d13C for the scolecodonts in the middle of the section may represent variations in primary marine productivity (supported by acritarch abundance data), oxidation of organic matter in the bottom waters, or genera effects. In general, however, trends between the three data sets are parallel, indicating similarities in the low frequency, environmentally forced controls. The d13C data show a decreasing trend from the base of the section, up to a horizon well below the base of the Upper Visby Formation. At this level, and therefore probably several 10 kyr before the d13C increase in the carbonates, the d13C organic values increase by ~1 per mil. This perhaps is an expression of a changed composition of the bulk organic matter associated with the extinction events prior to the Llandovery-Wenlock boundary.

Radiogenic lead and neodymium composition of surface sediments from the Arctic Ocean

Dolomite-rich layers of distinct pinkish colour are used as lithostratigraphic markers in the Amerasian Basin of the Arctic Ocean. However, origin of dolomite present in these sediment units has not been investigated in detail. In this study, lead (Pb) and neodymium (Nd) isotope composition of detrital clay-size fraction from different lithofacies was investigated in core PS72/340-5 recovered at the eastern flank of the Mendeleev Ridge. Prior to the geochemical analyses, grain-size distribution in sediments was analyzed in order to minimize the grain-size effect on the provenance signature. For provenance discrimination, results of isotope measurements were compared with marine surface sediment data and values for the circum-Arctic subaerial provinces. Late Quaternary sediment supply variability in core PS72/340-5 was analysed using the mixing model constrained by two tracers: 207Pb/206Pb and eNd. Variations of sediment isotopic composition are inferred to be due to mixing of volcanic and plutonic components. Usage of Pb isotopic ratios alone does not allow distinction between the volcanic and plutonic sources. Results confirm that, in the frame of the existing age model, over the last 200 ka dolomite-rich pink layers at the southern Mendeleev Ridge were deposited during events associated with intensified iceberg transport from North America. In general, however, late Quaternary sedimentation was mostly controlled by terrigenous input from the Chukchi and East Siberian Seas whereas sediment supply from the Laptev Sea area remained less important and relatively constant at the studied location.

Pollen analysis of soil samples from the A.D. 79 level. Boscoreale, Oplontis, and Pompeii

Fifty samples of Roman time soil preserved under the thick ash layer of the A.D.79 eruption of Mt Vesuvius were studied by pollen analysis: 33 samples from a former vineyard surrounding a Villa Rustica at Boscoreale (excavation site 40 x 50 m), 13 samples taken along the 60 m long swimming pool in the sculpture garden of the Villa of Poppaea at Oplontis, and four samples from the formal garden (12.4 x 17.5 m) of the House of the Gold Bracelet in Pompeii. To avoid contamination with modern pollen all samples were taken immediately after uncovering a new portion of the A.D. 79 soil. For comparison also samples of modern Italian soils were studied. Using standard methods for pollen preparation the pollen content of 15 of the archaeological samples proved to be too little to reach a pollen sum of more than 100 grains. The pollen spectra of these samples are not shown in the pollen tables. (Flotation with a sodium tungstate solution, Na2WO4, D = 2.05, following treatment with HCl and NaOH would probably have given a somewhat better result. This method was, however, not available as too expensive at that time.) Although the archaeological samples were taken a few meters apart their pollen values differ very much from one sample to the other. E.g., at Boscoreale (SW quarter). the pollen values of Pinus range from 1.5 to 54.5% resp. from 1 to 244 pine pollen grains per 1 gram of soil, the extremes even found under pine trees. Vitis pollen was present in 7 of the 11 vineyard samples from Boscoreale (NE quarter) only. Although a maximum of 21.7% is reached, the values of Vitis are mostly below 1.5%. Even the values of common weeds differ very much, not only at Boscoreale, but also at the other two sites. The pollen concentration values show similar variations: 3 to 3053 grains and spores were found in 1 g of soil. The mean value (290) is much less than the number of pollen grains, which would fall on 1 cm2 of soil surface during one year. In contrast, the pollen and spore concentrations of the recent soil samples, treated in exactly the same manner, range from 9313 to almost 80000 grains per 1 g of soil. Evidently most of the Roman time pollen has disappeared since its deposition, the reasons not being clear. Not even species which are known to have been cultivated in the garden of Oplontis, like Citrus and Nerium, plant species with easily distinguishable pollen grains, could be traced by pollen analysis. The loss of most of the pollen grains originally contained in the soil prohibits any detailed interpretation of the Pompeian pollen data. The pollen counts merely name plant species which grew in the region, but not necessarily on the excavated plots.