Turbulent flux and meteorological measurements during ARCTEX-2006 campaign

This dataset present result from the DFG- funded Arctic-Turbulence-Experiment (ARCTEX-2006) performed by the University of Bayreuth on the island of Svalbard, Norway, during the winter/spring transition 2006. From May 5 to May 19, 2006 turbulent flux and meteorological measurements were performed on the monitoring field near Ny-Ålesund, at 78°55'24'' N, 11°55'15'' E Kongsfjord, Svalbard (Spitsbergen), Norway. The ARCTEX-2006 campaign site was located about 200 m southeast of the settlement on flat snow covered tundra, 11 m to 14 m above sea level. The permanent sites used for this study consisted of the 10 m meteorological tower of the Alfred Wegener Institute for Polar- and Marine Research (AWI), the international standardized radiation measurement site of the Baseline Surface Radiation Network (BSRN), the radiosonde launch site and the AWI tethered balloon launch sites. The temporary sites - set up by the University of Bayreuth - were a 6 m meteorological gradient tower, an eddy-flux measurement complex (EF), and a laser-scintillometer section (SLS). A quality assessment and data correction was applied to detect and eliminate specific measurement errors common at a high arctic landscape. In addition, the quality checked sensible heat flux measurements are compared with bulk aerodynamic formulas that are widely used in atmosphere-ocean/land-ice models for polar regions as described in Ebert and Curry (1993, doi:10.1029/93JC00656) and Launiainen and Cheng (1995). These parameterization approaches easily allow estimation of the turbulent surface fluxes from routine meteorological measurements. The data show: - the role of the intermittency of the turbulent atmospheric fluctuation of momentum and scalars, - the existence of a disturbed vertical temperature profile (sharp inversion layer) close to the surface, - the relevance of possible free convection events for the snow or ice melt in the Arctic spring at Svalbard, and - the relevance of meso-scale atmospheric circulation pattern and air-mass advection for the near-surface turbulent heat exchange in the Arctic spring at Svalbard. Recommendations and improvements regarding the interpretation of eddy-flux and laser-scintillometer data as well as the arrangement of the instrumentation under polar distinct exchange conditions and (extreme) weather situations could be derived.

Seawater carbonate chemistry and net dissolution rate for experiment of Shiraho reef

Acidification of the oceans by increasing anthropogenic CO2 emissions will cause a decrease in biogenic calcification and an increase in carbonate dissolution. Previous studies have suggested that carbonate dissolution will occur in polar regions and in the deep sea where saturation state with respect to carbonate minerals (Omega) will be <1 by 2100. Recent reports demonstrate nocturnal carbonate dissolution of reefs, despite a Omega a (aragonite saturation state) value of >1. This is probably related to the dissolution of reef carbonate (Mg-calcite), which is more soluble than aragonite. However, the threshold of Omega for the dissolution of natural sediments has not been clearly determined. We designed an experimental dissolution system with conditions mimicking those of a natural coral reef, and measured the dissolution rates of aragonite in corals, and of Mg-calcite excreted by other marine organisms, under conditions of Omega a > 1, with controlled seawater pCO2. The experimental data show that dissolution of bulk carbonate sediments sampled from a coral reef occurs at Omega a values of 3.7 to 3.8. Mg-calcite derived from foraminifera and coralline algae dissolves at Omega a values between 3.0 and 3.2, and coralline aragonite starts to dissolve when Omega a = 1.0. We show that nocturnal carbonate dissolution of coral reefs occurs mainly by the dissolution of foraminiferans and coralline algae in reef sediments.

Temperature-dependent phenology of Plutella xylostella (Lepidoptera: Plutellidae)

Temperature-dependent population growth of diamondback moth (DBM) Plutella xylostella (L.), a prolific insect pest of crucifer vegetables, was studied under six constant temperatures in the laboratory. The objective of the study was to predict the impacts of temperature changes on the population of DBM at high-resolution scales along altitudinal gradients and under climate change scenarios. Non-linear functions were fitted on the data for modeling the development, mortality, longevity and oviposition of the pest. The best-fitted functions for each life stage were compiled for estimating the life table parameters of the species by stochastic simulations. To quantify the impacts on the pest, three indices (establishment, generation and activity) were computed using the estimates of life table parameters and temperature data obtained at local scale (current scenario 2013) and downscaled climate change data (future scenario 2055) from the AFRICLIM database. To measure and represent the impacts of temperature change along the altitude on the pest; the indices were mapped along the altitudinal gradients of Kilimanjaro and Taita Hills, in Tanzania and Kenya, respectively. Potential impact of the changes between climate scenarios 2013 and 2055 was assessed. The data files included in this database were utilized for the above analysis to develop temperature dependent phenology of Plutella xylostella to assess current and future distribution along eastern African Afromontanes.

Temperature tolerance of western Baltic Sea Fucus vesiculosus - growth, photosynthesis and survival

Fucus vesiculosus L. (Phaeophyceae) is the most abundant and hence ecologically most important primary producer, carbon sink and habitat provider in the western Baltic Sea. All F. vesiculosus L. specimens were collected on 23 April 2014 from a depth of 0.2-1 m in the non-tidal Kiel Fjord, western Baltic Sea (54°27'N; 10°12'E), where this species forms dense and almost monospecific stands on stones. After sampling the algal thalli were stored in a refrigerator box with water from the sampling site, transported to Bremerhaven and stored at 10 °C for one day in filtered seawater. Experiments were conducted with vegetative apical tips (6.7±0.5 cm length), the actively growing region of F. vesiculosus, which were randomly selected and cut from 144 different individuals prior to the experiments. These tips were acclimated to laboratory conditions for three days in filtered seawater at 10 °C before the start of the experiment. Furthermore, 30 additional vegetative apices were freeze-dried to document the initial biochemical status of F. vesiculosus in its native habitat. A temperature gradient was installed in a walk-in constant cooling chamber (15 °C) in nine water baths (5, 10, 15, 20, 24, 26, 27, 28 and 29 °C ± 0.1 °C) which were tempered by thermostats (5, 10 and 15 °C: Huber Variostat CC + Pilot ONE, Peter Huber Kältemaschinen GmbH, Offenburg, Germany; 20 and 28 °C: Haake DC3, Thermo Fisher Scientific Inc., Waltham, USA; 24, 26, 27 and 29 °C: Haake DC10). Every temperature treatment consisted of four 2 L glass beakers (n = 4). In each beaker four F. vesiculosus apices were grown in 2 µm-filtered North Sea water diluted with demineralized water in a ratio of 1:1 and enriched with nutrients after Provasoli (1968; 1/10 enrichment), leading to a salinity of about 15.6 which equaled habitat conditions. The algae were exposed to an irradiance of 130 µmol photons m-2 s-1 ±10 % (Powerstar HGI-TS 150 W, OSRAM GmbH, Bad Homburg, Germany) measured at the top of the beaker under a 16:8 h L:D cycle. The media in the beakers was changed every third or fourth day and aerated with artificial air containing 380 ppm CO2 (gas mixing device; HTK Hamburg GmbH, Hamburg, Germany). Before the experiment, the algae were acclimated to the final temperatures in steps of 5 °C for 2 days each, beginning at 10 °C. After 21 days exposure time, three out of four samples per replicate were freeze-dried for further biochemical analyses, and afterwards the thermostats were turned off to reduce the temperature to 16±0.4 °C for another 10 days permitting growth under post-culture conditions.

Pyrolyzable carbon, temperature maximum, production index and lithology for DSDP Leg 96 holes

Sediments from Deep Sea Drilling Project Sites 615, 617, 618, 619, and 620-623 were subjected to pyrolysis. The sediments are immature with respect to petroleum generation as determined by production index values of less than 0.1 and Tmax values of 460-480°C. The amount of pyrolyzable organic matter was moderately low as compared to typical petroleum source rocks. The immature organic matter present does not appear to contain a significant proportion of woody material as shown by the low gas-generating potential. Typical overbank sediments from Sites 617 and 620 generally show higher P2 values (500-800 µg hydrocarbon per g dry weight sediment) than typical channel-fill sediments from Sites 621 and 622 (P2 = 450-560 µg/g). Tmax for both types of sediment remained very constant (462-468 °C) with a slight elevation (+ 15°C) occurring in samples containing lignite. The highest P2 values occurred in sections described as turbidites. Very low P2 values (about 50 µg/g) occurred in sands. P2 values for shallower sections of basin Sites 618 and 619 tended to be higher (900-1000 µg/g) and decreased in deeper, more terrigenous sections of Site 619. Preliminary experiments indicate that microbiological degradation of sediment organic matter causes a decrease in P2. Pyrolyzable organic matter from lower fan Site 623 appears to increase with depth in two different sediment sequences (40-85 and 95-125 m sub-bottom). Organic matter type, as shown by pyrolysis capillary gas chromatography (GC) patterns, was generally the same throughout the well, with much more scatter occurring in the deepest sections (130-155 m sub-bottom). One major and two minor organic matter types could be recognized in both fan and basin sites drilled on Leg 96.

Marine meso-herbivore consumption scales faster with temperature than seaweed primary production, supplementary material

Respiration of ectotherms is predicted to increase faster with rising environmental temperature than photosynthesis of primary producers because of the differential temperature dependent kinetics of the key enzymes involved. Accordingly, if biological processes at higher levels of complexity are constrained by underlying metabolic functions food consumption by heterotrophs should increase more rapidly with rising temperature than photo-autoptrophic primary production. We compared rates of photosynthesis and growth of the benthic seaweed Fucus vesiculosus with respiration and consumption of the isopod Idotea baltica to achieve a mechanistic understanding why warming strengthens marine plant-herbivore interactions. In laboratory experiments thallus pieces of the seaweed and individuals of the grazer were exposed to constant temperatures at a range from 10 to 20°C. Photosynthesis of F. vesiculosus did not vary with temperature indicating efficient thermal acclimation whereas growth of the algae clearly increased with temperature. Respiration and food consumption of I. baltica also increased with temperature. Grazer consumption scaled about 2.5 times faster with temperature than seaweed production. The resulting mismatch between algal production and herbivore consumption may result in a net loss of algal tissue at elevated temperatures. Our study provides an explanation for faster decomposition of seaweeds at elevated temperatures despite the positive effects of high temperatures on algal growth.