Brain fiber tract plasticity in experimental spinal cord injury: diffusion tensor imaging.

Diffusion tensor imaging (DTI) and immunohistochemistry were performed in spinal cord injured rats to understand the basis for activation of multiple regions in the brain observed in functional magnetic resonance imaging (fMRI) studies. The measured fractional anisotropy (FA), a scalar measure of diffusion anisotropy, along the region encompassing corticospinal tracts (CST) indicates significant differences between control and injured groups in the 3 to 4 mm area posterior to bregma that correspond to internal capsule and cerebral peduncle. Additionally, DTI-based tractography in injured animals showed increased number of fibers that extend towards the cortex terminating in the regions that were activated in fMRI. Both the internal capsule and cerebral peduncle demonstrated an increase in GFAP-immunoreactivity compared to control animals. GAP-43 expression also indicates plasticity in the internal capsule. These studies suggest that the previously observed multiple regions of activation in spinal cord injury are, at least in part, due to the formation of new fibers.

Influence of blood contamination on bond strength of a self-etching system.

OBJECTIVES: To detect the influence of blood contamination (BC) on the bond strength (BS) of a self-etching bonding system (SES) to enamel and dentine. METHODS: 25 human molars were longitudinally sectioned on the mesio-distal axis in order to obtain 50 specimens, which were embedded in acrylic resin. At first, the specimens were ground to expose a flat surface of enamel, and a bond strength test was performed. Afterwards, the samples were ground again in order to obtain a flat surface of dentine. Ten groups (total: n=100) were assigned according to substrate (enamel and dentine), step in the bonding sequence when contamination occurred (before the acidic primer and after the bonding resin), and contamination treatment (dry or rinse and dry procedure). Fresh human blood was introduced either before or after SES application (Clearfil SE Bond) and treated with air drying, or by rinsing and drying following application. Composite resin (Filtek Z-250,3M ESPE) was applied as inverted, truncated cured cones that were debonded in tension. RESULTS: The mean tensile BS values (MPa) for enamel/dentine were 19.4/23.0 and 17.1/10.0 for rinse-and-dry treatment (contamination before and after SES, respectively); while the measurements for the dry treatment, 16.2/23.3 and 0.0/0.0 contamination before and after SES, respectively. CONCLUSIONS: It was determined that blood contamination impaired adhesion to enamel and dentine when it occurred after bond light curing. Among the tested contamination treatments, the rinse-and-dry treatment produced the highest bond strength with BC after SES application, but it was not sufficient to recover the BS in the contamination-free group.

Diversity of neuronal connexins in the mammalian retina

Many neurons in the mammalian retina are electrically coupled by intercellular channels or gap junctions, which are assembled from a family of proteins called connexins. Numerous studies indicate that gap junctions differ in properties such as conductance and tracer permeability. For example, A-type horizontal cell gap junctions are permeable to Lucifer Yellow, but B-type horizontal cell gap junctions are not. This suggests the two cell types express different connexins. My hypothesis is that multiple neuronal connexins are expressed in the mammalian retina in a cell type specific manner. Immunohistochemical techniques and confocal microscopy were used to localize certain connexins within well-defined neuronal circuits. The results of this study can be summarized as follows: AII amacrine cells, which receive direct input from rod bipolar cells, are well-coupled to neighboring AIIs. In addition, AII amacrine cells also form gap junctions with ON cone bipolar cells. This is a complex heterocellular network. In both rabbit and primate retina, connexin36 occurs at dendritic crossings in the AII matrix as well as between AIIs and ON cone bipolar cells. Coupling in the AII network is thought to reduce noise in the rod pathway while AII/bipolar gap junctions are required for the transmission of rod signals to ON ganglion cells. In the outer plexiform layer, connexin36 forms gap junctions between cones and between rods and cones via cone telodendria. Cone to cone coupling is thought to reduce noise and is partly color selective. Rod to cone coupling forms an alternative rod pathway thought to operate at intermediate light intensity. A-type horizontal cells in the rabbit retina are strongly coupled via massive low resistance gap junctions composed from Cx50. Coupling dramatically extends the receptive field of horizontal cells and the modulation of coupling is thought to change the strength of the feedback signal from horizontal cells to cones. Finally, there are other coupled networks, such as B-type horizontal cells and S1/S2 amacrine cells, which do not use either connexin36 or Cx50. These results confirm the hypothesis that multiple neuronal connexins are expressed in the mammalian retina and these connexins are localized to particular retinal circuits. ^

Functional architecture of mammalian horizontal cells

In the rabbit retina, there are two kinds of horizontal cells (HCs). The A-type HC is a large axonless cell which contacts cones exclusively. The B-type HC is an axon bearing cell. While the somatic dendrites of B-type HCs also contact cones, the axon expands into an elaborately branched structure, the axon terminal (AT), which contacts a large number of rods. It is difficult to label the different HCs selectively by immunochemical methods. Therefore, we developed dye injection methods to label each type of HC. Then it was possible, (1) to describe the detailed structure of the AT (2) to identify the glutamate receptors mediating cone input to A and B-type HCs and rod input to ATs and (3) to test the hypothesis that the B-type HCs are coupled via Cx57 gap junctions. ^ To obtain well filled examples of single HCs, it was necessary to block gap junction coupling to stop the spread of Neurobiotin through the network. We used dye coupling in A-type HCs to screen a series of potential gap junction antagonists. One of these compounds, meclofenamic acid (MFA), was potent, water soluble and easily reversible. This compound may be a useful tool to manipulate gap junction coupling. ^ In the presence of MFA, Neurobiotin passed down the axon of B-type HCs to reveal the detailed structure of the AT. We observed that only one AT ending entered each rod spherule invagination. This observation was confirmed by calculation and two dye injections. ^ Glutamate is the neurotransmitter used by both rods and cones. AMPA receptors were colocalized with the dendrites of A and B-type HCs at each cone pedicle. In addition, AMPA receptors were located on the AT ending at each rod spherule. Thus rod and cone input to HCs is mediated by AMPA receptors. ^ A-type and B-type HCs may express different connexins because they have different dye-coupling properties. Recently, we found that connexin50 (Cx50) is expressed by A-type HCs. B-type HCs and B-type ATs are also independently coupled. Cx57 was expressed in the OPL and double label studies showed that Cx 57 was colocalized with the AT matrix but not with the somatic dendrites of B-type HCs. ^ In summary, we have identified a useful gap junction antagonist, MFA. There is one AT ending at each rod spherule, rods inputs to ATs is mediated by AMPA receptors and coupling in the AT matrix is mediated by Cx57. This confirms that HCs with different properties use distinct connexins. The properties of ATs described in this research are consistent. The connections and properties reported here suggest that ATs functions as rod HCs and provide a negative feedback signal to rods. ^