NEW TARGET GENES FOR TUMOR SUPPRESSORS p53 AND p73 IN REGENERATING LIVER

The p53-family of proteins regulates expression of target genes during tissue development and differentiation. Within the p53-family, p53 and p73 have hepatic-specific functions in development and tumor suppression. Despite a growing list of p53/p73 target genes, very few of these have been studied in vivo, and the knowledge regarding functions of p53 and p73 in normal tissues remains limited. p53+/-p73+/- mice develop hepatocellular carcinoma (HCC), whereas overexpression of p53 in human HCC leads to tumor regression. However, the mechanism of p53/p73 function in liver remains poorly characterized. Here, the model of mouse liver regeneration is used to identify new target genes for p53/p73 in normal quiescent vs. proliferating cells. In response to surgical removal of ~2/3 of liver mass (partial hepatectomy, PH), the remaining hepatocytes exit G0 of cell cycle and undergo proliferation to reestablish liver mass. The hypothesis tested in this work is that p53/p73 functions in cell cycle arrest, apoptosis and senescence are repressed during liver regeneration, and reactivated at the end of the regenerative response. Chromatin immunoprecipitation (ChIP), with a p73-antibody, was used to probe arrayed genomic sequences (ChIP-chip) and uncover 158 potential targets of p73-regulation in normal liver. Global microarray analysis of mRNA levels, at T=0-48h following PH, revealed sets of genes that change expression during regeneration. Eighteen p73-bound genes changed expression after PH. Four of these genes, Foxo3, Jak1, Pea15, and Tuba1 have p53 response elements (p53REs), identified in silico within the upstream regulatory region. Forkhead transcription factor Foxo3 is the most responsive gene among transcription factors with altered expression during regenerative, cellular proliferation. p53 and p73 bind a Foxo3 p53RE and maintain active expression in quiescent liver. During liver regeneration, binding of p53 and p73, recruitment of acetyltransferase p300, and an active chromatin structure of Foxo3 are disrupted, alongside loss of Foxo3 expression. These parameters of Foxo3 regulation are reestablished at completion of liver growth and regeneration, supporting a temporary suspension of p53 and p73 regulatory functions in normal cells during tissue regeneration.

Evaluation of PRESAGE® dosimeters for brachytherapy sources and the 3D dosimetry and characterization of the new AgX100 125I seed model

With continuous new improvements in brachytherapy source designs and techniques, method of 3D dosimetry for treatment dose verifications would better ensure accurate patient radiotherapy treatment. This study was aimed to first evaluate the 3D dose distributions of the low-dose rate (LDR) Amersham 6711 OncoseedTM using PRESAGE® dosimeters to establish PRESAGE® as a suitable brachytherapy dosimeter. The new AgX100 125I seed model (Theragenics Corporation) was then characterized using PRESAGE® following the TG-43 protocol. PRESAGE® dosimeters are solid, polyurethane-based, 3D dosimeters doped with radiochromic leuco dyes that produce a linear optical density response to radiation dose. For this project, the radiochromic response in PRESAGE® was captured using optical-CT scanning (632 nm) and the final 3D dose matrix was reconstructed using the MATLAB software. An Amersham 6711 seed with an air-kerma strength of approximately 9 U was used to irradiate two dosimeters to 2 Gy and 11 Gy at 1 cm to evaluate dose rates in the r=1 cm to r=5 cm region. The dosimetry parameters were compared to the values published in the updated AAPM Report No. 51 (TG-43U1). An AgX100 seed with an air-kerma strength of about 6 U was used to irradiate two dosimeters to 3.6 Gy and 12.5 Gy at 1 cm. The dosimetry parameters for the AgX100 were compared to the values measured from previous Monte-Carlo and experimental studies. In general, the measured dose rate constant, anisotropy function, and radial dose function for the Amersham 6711 showed agreements better than 5% compared to consensus values in the r=1 to r=3 cm region. The dose rates and radial dose functions measured for the AgX100 agreed with the MCNPX and TLD-measured values within 3% in the r=1 to r=3 cm region. The measured anisotropy function in PRESAGE® showed relative differences of up to 9% with the MCNPX calculated values. It was determined that post-irradiation optical density change over several days was non-linear in different dose regions, and therefore the dose values in the r=4 to r=5 cm regions had higher uncertainty due to this effect. This study demonstrated that within the radial distance of 3 cm, brachytherapy dosimetry in PRESAGE® can be accurate within 5% as long as irradiation times are within 48 hours.