A comparison of worker risk of injury while working on fully automated side loaders and other residential collection trucks at a large solid waste collection company

The study aim was to determine whether using automated side loader (ASL) trucks in higher proportions compared to other types of trucks for residential waste collection results in lower injury rates (from all causes). The primary hypothesis was that the risk of injury to workers was lower for those who work with ASL trucks than for workers who work with other types of trucks used in residential waste collection. To test this hypothesis, data were collected from one of the nation’s largest companies in the solid waste management industry. Different local operating units (i.e. facilities) in the company used different types of trucks to varying degrees, which created a special opportunity to examine refuse collection injuries and illnesses and the risk reduction potential of ASL trucks.^ The study design was ecological and analyzed end-of-year data provided by the company for calendar year 2007. During 2007, there were a total of 345 facilities which provided residential services. Each facility represented one observation.^ The dependent variable – injury and illness rate, was defined as a facility’s total case incidence rate (TCIR) recorded in accordance with federal OSHA requirements for the year 2007. The TCIR is the rate of total recordable injury and illness cases per 100 full-time workers. The independent variable, percent of ASL trucks, was calculated by dividing the number of ASL trucks by the total number of residential trucks at each facility.^ Multiple linear regression models were estimated for the impact of the percent of ASL trucks on TCIR per facility. Adjusted analyses included three covariates: median number of hours worked per week for residential workers; median number of months of work experience for residential workers; and median age of residential workers. All analyses were performed with the statistical software, Stata IC (version 11.0).^ The analyses included three approaches to classifying exposure, percent of ASL trucks. The first approach included two levels of exposure: (1) 0% and (2) >0 - <100%. The second approach included three levels of exposure: (1) 0%, (2) ≥ 1 - < 100%, and (3) 100%. The third approach included six levels of exposure to improve detection of a dose-response relationship: (1) 0%, (2) 1 to <25%, (3) 25 to <50%, (4) 50 to <75%, (5) 75 to <100%, and (6) 100%. None of the relationships between injury and illness rate and percent ASL trucks exposure levels was statistically significant (i.e., p<0.05), even after adjustment for all three covariates.^ In summary, the present study shows that there is some risk reduction impact of ASL trucks but not statistically significant. The covariates demonstrated a varied yet more modest impact on the injury and illness rate but again, none of the relationships between injury and illness rate and the covariates were statistically significant (i.e., p<0.05). However, as an ecological study, the present study also has the limitations inherent in such designs and warrants replication in an individual level cohort design. Any stronger conclusions are not suggested.^

The medical malpractice insurance "crises" and federal medical malpractice tort reform: Collection and analysis of bills passed by the United States House of Representatives from 1995--2005

There have been three medical malpractice insurance "crises" in the United States over a time spanning roughly the past three decades (Poisson, 2004, p. 759-760). Each crisis is characterized by a number of common features, including rapidly increasing medical malpractice insurance premiums, cancellation of existing insurance policies, and a decreased willingness of insurers to offer or renew medical malpractice insurance policies (Poisson, 2004, p. 759-760). Given the recurrent "crises," many sources argue that medical malpractice insurance coverage has become too expensive a commodity—one that many physicians simply cannot afford (U.S. Department of Health and Human Services [HHS], 2002, p. 1-2; Physician Insurers Association of America [PIAA], 2003, p. 1; Jackiw, 2004, p. 506; Glassman, 2004, p. 417; Padget, 2003, p. 216). ^ The prohibitively high cost of medical liability insurance is said to limit the geographical areas and medical specializations in which physicians are willing to practice. As a result, the high costs of medical liability insurance are ultimately said to affect whether or not people have access to health care services. ^ In an effort to control the medical liability insurance crises—and to preserve or restore peoples' access to health care—every state in the United States has passed "at least some laws designed to reduce medical malpractice premium rates" (GAO, 2003, p.5-6). More recently, however, the United States has witnessed a push to implement federal reform of the medical malpractice tort system. Accordingly, this project focuses on federal medical malpractice tort reform. This project was designed to investigate the following specific question: Do the federal medical malpractice tort reform bills which passed in the House of Representatives between 1995 and 2005 differ in respect to their principle features? To answer this question, the text of the bills, law review articles, and reports from government and private agencies were analyzed. Further, a matrix was compiled to concisely summarize the principle features of the proposed federal medical malpractice tort reform bills. Insight gleaned from this investigation and matrix compilation informs discussion about the potential ramifications of enacting federal medical malpractice tort reform legislation. ^

PRODUCTION, DEGRADATION AND ACCUMULATION OF ORGANICS BY WASTE STABILIZATION POND MICROORGANISMS

The objectives of this research were: to determine the contribution of algae to commonly run water quality variables, to evaluate waste pond micoorganisms' capacity to degrade and accumulate ten EPA priority pollutants, and to determine the environmental fate of those compounds in a laboratory

An evaluation of the impact of Inner City Development's Cooperative Home School: An educational alternative program to increase the quality and level of education in San Antonio's West Side community

The research study was intended to evaluate the effectiveness of Inner City Development's (I.C.D.) Cooperative Home School, an educational alternative program to the Title I public schools of San Antonio's West Side community. The study investigated students', parents' and tutors' perception of parental involvement and educational resources. The study also investigated each student's academic achievement. ^ The study found that students progressed toward expected math proficiency at a faster rate than they did in reading proficiency. However, because the target population size was small and a comparison group was not used, the results of this study are only suggestive. This research also indicated that study subjects believed students' quality and level of education increased substantially since program exposure. Study subjects mainly attributed the students' strides in academic performance to the increased amount of individualized attention students received in the small twelve-student class size. Study subjects were more satisfied with the home school's educational resources than those of the Title I public schools. Study subjects also perceived that parental involvement both at home and at school increased since enrollment in the home school program because: (1) there were more opportunities for involvement in the home school; and (2) parents felt closer to the tutors than the teachers in public school. ^ This evaluation also suggested improvements to program operations. With the help of additional volunteers, I.C.D. program operators could improve collection and organization of academic records. Furthermore, as suggested by program participants, science could be added to the curriculum. Lastly, a formal tutor orientation could be implemented to familiarize and train tutors on classroom management procedures. ^

Texas electronics waste management: A policy analysis for the 21st century

Electronic waste is a fairly new and largely unknown phenomenon. Accordingly, governments have only recently acknowledged electronic waste as a threat to the environment and public health. In attempting to mitigate the hazards associated with this rapidly growing toxic waste stream, governments at all levels have started to implement e-waste management programs. The legislation enacted to create these programs is based on extended producer responsibility or EPR policy. ^ EPR shifts the burden of final disposal of e-waste from the consumer or municipal solid waste system to the manufacturer of electronic equipment. Applying an EPR policy is intended to send signals up the production chain to the manufacturer. The desired outcome is to change the methods of production in order to reduce production outputs/inputs with the ultimate goal of changing product design. This thesis performs a policy analysis of the current e-waste policies at the federal and state level of government, focusing specifically on Texas e-waste policies. ^ The Texas e-waste law known, as HB 2714 or the Texas Computer TakeBack Law, requires manufacturers to provide individual consumers with a free and convenient method for returning their used computers to manufacturers. The law is based on individual producer responsibility and shared responsibility among consumer, retailers, recyclers, and the TCEQ. ^ Using a set of evaluation criteria created by the Organization for Economic Co-operation and Development, the Texas e-waste law was examined to determine its effectiveness at reducing the threat of e-waste in Texas. Based on the outcomes of the analysis certain recommendations were made for the legislature to incorporate into HB 2714. ^ The results of the policy analysis show that HB 2714 is a poorly constructed law and does not provide the desired results seen in other states with EPR policies. The TakeBack Law does little to change the collection methods of manufacturers and even less to change their production habits. If the e-waste problem is to be taken seriously, HB 2714 must be amended to reflect the proposed changes in this thesis.^

Evaluation of a solid phase microextraction method for community-based monitoring of 1,3-butadiene and benzene in Houston, Texas

The Houston region is home to arguably the largest petrochemical and refining complex anywhere. The effluent of this complex includes many potentially hazardous compounds. Study of some of these compounds has led to recognition that a number of known and probable carcinogens are at elevated levels in ambient air. Two of these, benzene and 1,3-butadiene, have been found in concentrations which may pose health risk for residents of Houston.^ Recent popular journalism and publications by local research institutions has increased the interest of the public in Houston's air quality. Much of the literature has been critical of local regulatory agencies' oversight of industrial pollution. A number of citizens in the region have begun to volunteer with air quality advocacy groups in the testing of community air. Inexpensive methods exist for monitoring of ozone, particulate matter and airborne toxic ambient concentrations. This study is an evaluation of a technique that has been successfully applied to airborne toxics.^ This technique, solid phase microextraction (SPME), has been used to measure airborne volatile organic hydrocarbons at community-level concentrations. It is has yielded accurate and rapid concentration estimates at a relatively low cost per sample. Examples of its application to measurement of airborne benzene exist in the literature. None have been found for airborne 1,3-butadiene. These compounds were selected for an evaluation of SPME as a community-deployed technique, to replicate previous application to benzene, to expand application to 1,3-butadiene and due to the salience of these compounds in this community. ^ This study demonstrates that SPME is a useful technique for quantification of 1,3-butadiene at concentrations observed in Houston. Laboratory background levels precluded recommendation of the technique for benzene. One type of SPME fiber, 85 μm Carboxen/PDMS, was found to be a sensitive sampling device for 1,3-butadiene under temperature and humidity conditions common in Houston. This study indicates that these variables affect instrument response. This suggests the necessity of calibration within specific conditions of these variables. While deployment of this technique was less expensive than other methods of quantification of 1,3-butadiene, the complexity of calibration may exclude an SPME method from broad deployment by community groups.^

STRATEGIES FOR THE TRANSFER OF APPROPRIATE TECHNOLOGY TO DEVELOPING COUNTRIES: THE IMPLEMENTATION AND DEVELOPMENT OF ENVIRONMENTAL HEALTH PROGRAMS IN TUNISIA

This dissertation focuses on Project HOPE, an American medical aid agency, and its work in Tunisia. More specifically this is a study of the implementation strategies of those HOPE sponsored projects and programs designed to solve the problems of high morbidity and infant mortality rates due to environmentally related diarrheal and enteric diseases. Several environmental health programs and projects developed in cooperation with Tunisian counterparts are described and analyzed. These include (1) a paramedical manpower training program; (2) a national hospital sanitation and infection control program; (3) a community sewage disposal project; (4) a well reconstruction project; and (5) a solid-waste disposal project for a hospital.^ After independence, Tunisia, like many developing countries, encountered several difficulties which hindered progress toward solving basic environmental health problems and prompted a request for aid. This study discusses the need for all who work in development programs to recognize and assess those difficulties or constraints which affect the program planning process, including those latent cultural and political constraints which not only exist within the host country but within the aid agency as well. For example, failure to recognize cultural differences may adversely affect the attitudes of the host staff towards their work and towards the aid agency and its task. These factors, therefore, play a significant role in influencing program development decisions and must be taken into account in order to maximize the probability of successful outcomes.^ In 1969 Project HOPE was asked by the Tunisian government to assist the Ministry of Health in solving its health manpower problems. HOPE responded with several programs, one of which concerned the training of public health nurses, sanitary technicians, and aids at Tunisia's school of public health in Nabeul. The outcome of that program as well as the strategies used in its development are analyzed. Also, certain questions are addressed such as, what should the indicators of success be, and when is the time right to phase out?^ Another HOPE program analyzed involved hospital sanitation and infection control. Certain generic aspects of basic hospital sanitation procedures were documented and presented in the form of a process model which was later used as a "microplan" in setting up similar programs in other Tunisian hospitals. In this study the details of the "microplan" are discussed. The development of a nation-wide program without any further need of external assistance illustrated the success of HOPE's implementation strategies.^ Finally, although it is known that the high incidence of enteric disease in developing countries is due to poor environmental sanitation and poor hygiene practices, efforts by aid agencies to correct these conditions have often resulted in failure. Project HOPE's strategy was to maximize limited resources by using a systems approach to program development and by becoming actively involved in the design and implementation of environmental health projects utilizing "appropriate" technology. Three innovative projects and their implementation strategies (including technical specifications) are described.^ It is advocated that if aid agencies are to make any progress in helping developing countries basic sanitation problems, they must take an interdisciplinary approach to progrm development and play an active role in helping counterparts seek and identify appropriate technologies which are socially and economically acceptable. ^

A comparative analysis of Texas and Louisiana Oil-field NORM Waste Policy

NORM (Naturally Occurring Radioactive Material) Waste Policies for the nation's oil and gas producing states have been in existence since the 1980's, when Louisiana was the first state to develop a NORM regulatory program in 1989. Since that time, expectations for NORM Waste Policies have evolved, as Health, Safety, Environment, and Social responsibility (HSE & SR) grows increasingly important to the public. Therefore, the oil and gas industry's safety and environmental performance record will face challenges in the future, about its best practices for managing the co-production of NORM wastes. ^ Within the United States, NORM is not federally regulated. The U.S. EPA claims it regulates NORM under CERCLA (superfund) and the Clean Water Act. Though, there are no universally applicable regulations for radium-based NORM waste. Therefore, individual states have taken responsibility for developing NORM regulatory programs, because of the potential radiological risk it can pose to man (bone and lung cancer) and his environment. This has led to inconsistencies in NORM Waste Policies as well as a NORM management gap in both state and federal regulatory structures. ^ Fourteen different NORM regulations and guidelines were compared between Louisiana and Texas, the nation's top two petroleum producing states. Louisiana is the country's top crude oil producer when production from its Federal offshore waters are included, and fourth in crude oil production, behind Texas, Alaska, and California when Federal offshore areas are excluded. Louisiana produces more petroleum products than any state but Texas. For these reasons, a comparative analysis between Louisiana and Texas was undertaken to identify differences in their NORM regulations and guidelines for managing, handling and disposing NORM wastes. Moreover, this analysis was undertaken because Texas is the most explored and drilled worldwide and yet appears to lag behind its neighboring state in terms of its NORM Waste Policy and developing an industry standard for handling, managing and disposing NORM. As a result of this analysis, fourteen recommendations were identified.^