Concentration by Flotation of a Complex Galena - Sphalerite - Chalcopyrite Ore from the Nine Mile District Near Missoula, Montana

At the present time ore bodies being mined are becoming more and more complex in mineral association, thus presenting a more difficult problem in their concentration. Lead-zinc sulphide ores are among the more common ores which present such difficulties.

Voltammetric Investigation of Xanthate Chemisorption on a Chalcopyrite Surface

Cyclic Voltammetry experiments have been conducted on copper, iron, and chalcopyrite (CuFeS2) and compared to mass-balanced EH-pH Diagrams. Potassium ethyl xanthate (KEX) was added to solution and additional voltammetry experiments were performed to determine the surface chemistry reactions of flotation collector in solution with these minerals. The ultimate goal of this research was to investigate the possibility of xanthate chemisorption onto the chalcopyrite mineral surface. Results of the copper mineral testing confirm previous literature studies and corroborate published isotherm data. Results of the iron mineral testing showed changes in surface reactions with the addition of potassium ethyl xanthate to solution, however, these results were not attributed to the chemisorption of xanthate. Results of the chalcopyrite mineral testing indicate that the surface of the mineral oxidizes to chalcocite (Cu2S). In the presence of ethyl xanthate, small currents were observed and attributed to chemisorption of the potassium ethyl xanthate at the chalcocite surface, suggesting that the mineral's hydrophobicity is induced by more than dixanthogen. This phenomenon was found to be pH-dependent under a range of alkaline conditions (i.e., pH 7-12) at narrow potentials (i.e., 0 to -200mV).

The Recovery of Copper in Sulphide Ores by Roasting, Leaching, and Electrolysis

Sulphide ores of copper are insoluble in dilute sulphuric acid leaching solutions, but a very high extraction can be obtained if the copper ore is in the oxidized condition. The problem is to convert the sulphide into the oxide form. This can be done by giving the sulphide ore an oxidizing-sulphatizing roast. Copper sulphate is soluble in water, so acid will be saved in the leaching process if copper sulphate is present. The iron in the copper sulphide ores is present as pyrite, or in combinations as bornite, or chalcopyrite.

The Testing and Concentration of a Low Grade Copper-Nickel Ore.

The purpose of this thesis is to investigate the possi­bility of concentrating a low grade copper-nickel ore, to determine the most effective method of concentration, and to attempt to draw some conclusions to determine whether or not the concentrates produced would be of sufficient high grade to make the recovery of nickel and copper a profit­able enterprise.

Flotation of a Complex Sulphide Ore Containing Tetrahedrite

The ore investigated in this thesis is a zinc-copper-lead ore. Microscopic analysis of this complex sulphide ore showed it to contain pyrite, sphalerite, arsenopyrite, galena, chalcopyrite, tetrahedrite, and covellite, with quartz as the gangue constituent.

A Preliminary Study of the Separation of the Copper Sulfides from Sphalerite and the Effect of Certain Reagents on Some of the Pure Copper Minerals in Synthetic Mixtures

The problem of separating the copper sulfide minerals from sphalerite, in copper - zinc ores, has been a difficult one. This is largely due to the lack of adequate research and the small amount of data obtainable on the behavior of copper and zinc sulfide minerals in flotation circuits.