Investigations Concerning Bentonite Deposits Near Ramsay, Montana

The purpose of Part I of this report is to determine the origin of the bentonite deposits, also to locate them with reference to section corners in the vicinity and to determine their extent. The field work for this report was done in the fall of 1933 and during the spring of 1934. The roads, geologic contacts, and culture in general were mapped with the use of an open sight alidade and plane table. Distances were determined on the roads by the speedometer on the automo­bile; the detailed survey in the immediate vicinity of the deposits was done with use of the Brunton compass and pac­ing. The purpose of Part II in this report is to determine if the bentonite deposits immediately west of Butte, Montana are of com­mercial importance and also to determine the use to which they are best suited.

Geology of a Portion of the Bull Mountain Range Jefferson County, Montana

Work was first done on a known section, the south Boulder Section, in order to familiarize the student with the formations. Most of the area was mapped by plane table and telescopic alidade, general features being surveyed by automobile traverse and a pacing traverse.

A Measurement System Experiment to Evaluate the Nosing-to-nosing Method for Measuring Dimensions of Steps

Non-uniformity of steps within a flight is a major risk factor for falls. Guidelines and requirements for uniformity of step risers and tread depths assume the measurement system provides precise dimensional values. The state-of-the-art measurement system is a relatively new method, known as the nosing-to-nosing method. It involves measuring the distance between the noses of adjacent steps and the angle formed with the horizontal. From these measurements, the effective riser height and tread depth are calculated. This study was undertaken for the purpose of evaluating the measurement system to determine how much of total measurement variability comes from the step variations versus that due to repeatability and reproducibility (R&R) associated with the measurers. Using an experimental design quality control professionals call a measurement system experiment, two measurers measured all steps in six randomly selected flights, and repeated the process on a subsequent day. After marking each step in a flight in three lateral places (left, center, and right), the measurers took their measurement. This process yielded 774 values of riser height and 672 values of tread depth. Results of applying the Gage R&R ANOVA procedure in Minitab software indicated that the R&R contribution to riser height variability was 1.42%; and to tread depth was 0.50%. All remaining variability was attributed to actual step-to-step differences. These results may be compared with guidelines used in the automobile industry for measurement systems that consider R&R less than 1% as an acceptable measurement system; and R&R between 1% and 9% as acceptable depending on the application, the cost of the measuring device, cost of repair, or other factors.

Geological Report of Conrow Wood Creek Area 8 Miles N.E. of Whitehall, Montana

Plane table and pacing methods were used in the mapping of the individual areas, but an automobile traverse was used to tie the independent areas into a composite group that would be useful for the entire zone. All land marks, section corners, roads, fence lines, drainage, and geologic features were plotted in the field and later transferred to a master map.