Permeability and Porosity Studies of the Cut Bank Oil Sand

In studying the Cut Bank field and its numerous wells, it is found that dry holes are surrounded by producing wells, and also that the field as a whole is very irregular; water, oil, and gas zones in many cases following no definite pattern. In some instances, this phenomenon may be due to the lensing and thinning of the producing sands, but it is evident that this is not the only factor. There­fore, the controlling factors must be porosity and permeability.

Spectrographic Analysis of Montana Limestones

Spectrographic analysis of limestones as a possible method of correlation of geologic formations is an altogether new line of investigation. As far as known the only previous work consists of a few analyses made by Fred Lines in his bachelor thesis work at Montana School of mines in the spring of 1942.

Subsurface to Surface Correlation of the Tensleep Sandstone in the West Flank of the Pryor Mountains in Carbon County, Montana

The Pennsylvanian Tensleep Sandstone is an eolian and nearshore marine/sabka quartz arenite unit with prominent outcrops along the western Pryor/Bighorn Mountain front east of Red Lodge, MT. Regionally, the formation represents one of the largest ergs in the global geologic record. High permeability makes it an important oil and gas reservoir and aquifer in south central Montana and throughout much of Wyoming. The Tensleep Sandstone’s high percentage of quartz content and grain roundness, due to its eolian origin, makes it a prospective source for natural proppant sand. Three continuous 4-inch cores were obtained during a cooperative project between Montana Tech and industry partners. Using stratigraphic sections, cores, thin sections, and x-ray fluorescence (XRF) analysis, the usefulness and economic feasibility of the Tensleep Sandstone as a minable hydraulic fracture proppant was explored. Usefulness depends on cementation, grain shape, grain size, and depth from surface of the prospective zone. Grain shape and size were determined by thin sections, sieving, and stereomicroscope analysis. Analysis of 20 disaggregated sand samples has shown that as much as 30 percent of the grain sizes fall between 30-50 mesh (medium- to finegrained sand size) and about 45 percent of the grain sizes fall between 70–140 mesh (very fine-grained sand to coarse silt), grain sizes appropriate for some hydraulic fracture operations. Core descriptions and XRF data display the distribution of lithology and cementation. Core descriptions and XRF data display the distribution of lithology and cementation. Elemental (XRF) analyses help to delineate more pure quartz sands from those with grain fractions reflecting fine-grained clastic and evaporitic inputs. The core and nearby stratigraphic sections are used to quantify the amount of overburden and the 3 amount of resource in the area. Initial results show favorable crush strength and useable grain size and shape.

Laboratory Model Shaking Table; An Investigation of Defects and Suggested Improvements

The laboratory model is considered in this thesis. Information gained from this investigation has not been trans­ferred to the larger industrial machines. Some of the factors noted concerning the efficiency of the laboratory shaking table are inherent in this small scale model only.

Distribution and Lithology of Sedimentary Rocks in Montana and Adjacent Areas

The general features of the sedimentary rocks in a region, their distribution, and the relationships of these rocks to other rocks of the area and of adjacent areas, are some of the things in which most geologists are interested, for reasons of general curiosity or for obtaining a better understanding of their specific prob­lems

Geology and Mineral Deposits of Idaho: A Summary

The great diversity on mineral wealth in Idaho establishes it as one of the principle mining states in the union. Mining first began in the state with the discovery of placer gold in the Pierce City district in 1861, and since that date has become one of the leading industries of the state.

Geology of the Renova-Bone Basin and Mayflower Mine Areas

This report has been compiled from the data collected during the September, 1947, geologic field trip of the Montana School of Mines. The trip, under the direction of Dr. E. S. Perry, consisted of two weeks of field mapping and observation near Whitehall, Montana, and one week at the Montana School of Mines preparing this report.

Rugose Corals of the Madison Group

One of the best types of index fossils, and one which occurs most plentifully in the Madison group of formations in Montana, and yet, one which has been little studied, is the group of rugose, or cup, corals. Perhaps this group of fossils has not been studied in detail because their distinguishing characteristics are mainly internal, and labo­ratory preparation in the form of thin section or polished surfaces is necessary to bring out these characteristics.

Geology of a Kyanite Deposit Near Ennis, Montana

A deposit of kyanite, an aluminum silicate mineral used in the ceramic industry, occurs in the low foothills of the Gravelly range about 10 miles south of Ennis, Montana. This study deals primarily with the character and origin of the deposit, and its relationship to the surrounding rocks.

A Discussion of the Geology and an Isopach Map of the Pennsylvanian System in Wyoming and Adjacent Areas

Pennsylvanian strata in Wyoming and adjacent areas have been the subject of much work and discussion. Most of the work has been due to the economic importance of the system as an oil producer in this region. Oil production from strata of Pennsylvanian age is rather recent history; and therefore, much of the available information is local­ized and incomplete.

An Isopach Map and a Discussion of the Permian in Wyoming and Adjacent Areas

The accelerated post-war demand for petroleum products with resultant high prices and dwindling reserves has spurred producers to an extensive search for new fields and for ad­ditional production in known fields. Exploration and discov­ery is dependent on the collection and correlation of vast amounts of data both in the field and that found in liter­ature.

Sulfatizing Roasting of a Copper Sulfide Ore

At present copper sulfide ores are recovered by pyrometallurgical processes. While the recovery of cop­per from sulfide ores by hydrometallurgical means has long been considered attractive, the impurities, low re­covery and mechanical difficulties have kept this process from becoming commercial.

Geology and Geological Structure of the Alberta and Saskatchewan Plains

Alberta, responsible for ninety per cent of Canada's output, had, by 1947 entered into her fifth year of production decline. Only ten per cent of Canada's oil requirements were secured from home fields. Ninety per cent had to be imported, mainly from the United States. How long could imports be maintained on present levels? During the year, the United States had started rationing; in one sector of its domain. Would this become general? If so, what was the answer for Canada?

Geology of the Lost Creek-Modesty Creek Area Deerlodge County, Montana

In 1915 the United States Geological Survey published a folio by Calkins and Emmons on the geology of the Philipsburg Quadrangle, which ad­joins the area now under study to the west. Geology of this portion of Montana had not been mapped previously; consequently the purpose of this thesis is to make a geological reconnais­sance of the stratigraphy and structure of the area.

The Geology and Ore Deposits of the Ermont Mines

The Ermont Mines are located sixteen miles northwest of Dillon, Montana, in section 35 of T.6S., R.11W. This is in the central part of Beaverhead County. They are considered to be in the Argenta min­ing district, the town of Argenta lying three miles to the northeast.