AN EXPERIMENTAL INVESTIGATION INTO THE EFFECTS OF BIODIESEL BLENDS ON PARTICULATE MATTER OXIDATION IN A CATALYZED PARTICULATE FILTER DURING ACTIVE REGENERATION

Active regeneration experiments were carried out on a production 2007 Cummins 8.9L ISL engine and associated DOC and CPF aftertreatment system. The effects of SME biodiesel blends were investigated in this study in order to determine the PM oxidation kinetics associated with active regeneration, and to determine the effect of biodiesel on them. The experimental data from this study will also be used to calibrate the MTU-1D CPF model. Accurately predicting the PM mass retained in the CPF and the oxidation characteristics will provide the basis for computation in the ECU that will minimize the fuel penalty associated with active regeneration. An active regeneration test procedure was developed based on previous experimentation at MTU. During each experiment, the PM mass in the CPF is determined by weighing the filter at various phases. In addition, DOC and CPF pressure drop, particle size distribution, gaseous emissions, temperature, and PM concentration data are collected and recorded throughout each experiment. The experiments covered a range of CPF inlet temperatures using ULSD, B10, and B20 blends of biodiesel. The majority of the tests were performed at CPF PM loading of 2.2 g/L with in-cylinder dosing, although 4.1 g/L and a post-turbo dosing injector were also used. The PM oxidation characteristics at different test conditions were studied in order to determine the effects of biodiesel on PM oxidation during active regeneration. A PM reaction rate calculation method was developed to determine the global activation energy and the corresponding pre-exponential factor for all test fuels. The changing sum of the total flow resistance of the wall, cake, and channels was also determined as part of the data analysis process in order to check on the integrity of the data and to correct input data to be consistent with the expected trends of the resistance based on the engine conditions used in the test procedure. It was determined that increasing the percent biodiesel content in the test fuel tends to increase the PM reaction rate and the regeneration efficiency of fuel dosing, i.e., at a constant CPF inlet temperature, B20 test fuel resulted in the highest PM reaction rate and regeneration efficiency of fuel dosing. Increasing the CPF inlet temperature also increases PM reaction rate and regeneration efficiency of fuel dosing. Performing active regeneration with B20 as opposed to ULSD allows for a lower CPF temperature to be used to reach the same level of regeneration efficiency, or it allows for a shorter regeneration time at a constant CPF temperature, resulting in decreased fuel consumption for the engine during active regeneration in either scenario.

USING MOSSES TO ASSESS CONDITIONS IN NORTHERN WHITE CEDAR SWAMPS

Northern white cedar (Thuja occidentalis L.) (NWC) swamps are valuable both commercially and ecologically. Unfortunately, many NWC swamps are degraded and information about them is not abundant. Especially there have been no definitive studies about mosses in northern white cedar swamps and how they react to disturbances. Mosses are sensitive to changes in their environment and thus they could be used to assess ecosystem conditions of NWC swamps. The objective of this study was to determine if mosses could be used to asses conditions in NWC swamps and if there are differences between moss communities in disturbed and undisturbed sites. Seventeen sample plots were taken from 12 disturbed and undisturbed sites around upper Michigan and northern Minnesota in the summer of 2012. All mosses occurring on the plots were identified and several associated environmental parameters were measured. The main environmental conditions affecting moss communities were identified with non-metric multidimensional scaling (NMS). Multiple response permutation procedures (MRPP) were run to ascertain if there were significant differences in community composition between disturbances. Indicator species analysis was then done to identify species that are related to different types of disturbances. A one-way ANOVA was used to check for significant differences between species richness and moss cover of undisturbed and disturbed sites. Over all sixty-two moss species were identified. The results indicate that there was no significant difference in species richness or moss cover between disturbed and undisturbed sites. However, moss community composition was affected by disturbance and strongly divided by a wetness gradient. Dicranum fuscescens was found to indicate undisturbed conditions. Calliergon cordifolium and Climacium dendroides indicated disturbed sites with wet conditions. Brotherella recurvans and Eurhynchium pulchellum indicated swamps with other disturbances.