Development of a model-based transient calibration process for diesel engine electronic control module tables – Part 2: modelling and optimization

This is the second part of a study investigating a model-based transient calibration process for diesel engines. The first part addressed the data requirements and data processing required for empirical transient emission and torque models. The current work focuses on modelling and optimization. The unexpected result of this investigation is that when trained on transient data, simple regression models perform better than more powerful methods such as neural networks or localized regression. This result has been attributed to extrapolation over data that have estimated rather than measured transient air-handling parameters. The challenges of detecting and preventing extrapolation using statistical methods that work well with steady-state data have been explained. The concept of constraining the distribution of statistical leverage relative to the distribution of the starting solution to prevent extrapolation during the optimization process has been proposed and demonstrated. Separate from the issue of extrapolation is preventing the search from being quasi-static. Second-order linear dynamic constraint models have been proposed to prevent the search from returning solutions that are feasible if each point were run at steady state, but which are unrealistic in a transient sense. Dynamic constraint models translate commanded parameters to actually achieved parameters that then feed into the transient emission and torque models. Combined model inaccuracies have been used to adjust the optimized solutions. To frame the optimization problem within reasonable dimensionality, the coefficients of commanded surfaces that approximate engine tables are adjusted during search iterations, each of which involves simulating the entire transient cycle. The resulting strategy, different from the corresponding manual calibration strategy and resulting in lower emissions and efficiency, is intended to improve rather than replace the manual calibration process.

Behavioral and neural correlates of perceived and imagined musical timbre

The generality of findings implicating secondary auditory areas in auditory imagery was tested by using a timbre imagery task with fMRI. Another aim was to test whether activity in supplementary motor area (SMA) seen in prior studies might have been related to subvocalization. Participants with moderate musical background were scanned while making similarity judgments about the timbre of heard or imagined musical instrument sounds. The critical control condition was a visual imagery task. The pattern of judgments in perceived and imagined conditions was similar, suggesting that perception and imagery access similar cognitive representations of timbre. As expected, judgments of heard timbres, relative to the visual imagery control, activated primary and secondary auditory areas with some right-sided asymmetry. Timbre imagery also activated secondary auditory areas relative to the visual imagery control, although less strongly, in accord with previous data. Significant overlap was observed in these regions between perceptual and imagery conditions. Because the visual control task resulted in deactivation of auditory areas relative to a silent baseline, we interpret the timbre imagery effect as a reversal of that deactivation. Despite the lack of an obvious subvocalization component to timbre imagery, some activity in SMA was observed, suggesting that SMA may have a more general role in imagery beyond any motor component.