Crosslinking Studies To Probe Substrate Binding By Soybean Lipoxygenase-1

Soybean lipoxygenase-1 (SBLO-1) catalyzes the oxygenation of polyunsaturated fatty acids into conjugated diene hydroperoxides. The three dimensional structure of SBLO-1 is known, but it is not certain how substrates bind. One hypothesis involves the transient separation of helix-2 and helix-11 located on the exterior of the molecule in front of the active site iron. A second hypothesis involves a conformational change in the side chains of residues leucine 541 and threonine 259. To test these hypotheses, site directed mutagenesis was used to create a cysteine mutation on each helix, which could allow for the formation of a disulfide linkage. Disulfide formation between the two cysteines in the T259C,S545C mutant was found to be unfavorable, but later shown to be present at higher pH values using SDS-PAGE. Treatment of the T259C,S545C with the crosslinker 2,3-dibromomaleimide (DBM) resulted in a 50% reduction in catalytic activity. No loss of activity was observed when the single mutant, S545C, or the wild type was treated with DBM. Single mutants T259C and L541C both showed approximately 20% reduction in the rate after addition of DBM. Double mutants T259C,L541C and S263C,S545C showed approximately 30% reduction in the rate after addition of DBM. Single mutants T259C and L541C showed an increase in activity after incubation with NEM. Double mutants T259C,S545C and T259C,L541C showed an increase in activity after incubation with NEM. The S263C,S545C double mutant showed a slight decrease in activity in the presence of NEM. It is unclear how the NEM and DBM are interacting with the molecule, but this can easily be determined through mass spectrometry experiments.

Development of Solid Oxide Fuel Cell Electrodes with High Conductivity and Enhanced Redox Stability

The intent of this study was the development of new ceramic SOFC anode materials which possess electrical conductivity as well as redox stability.

Enzymatic Activity of Soybean Lipoxygenase-1 on Linoleoyl-Derivatized Agarose

Soybean lipoxygenase-1 (SBLO-1) catalyzes the oxygenation of linoleic acid to form 13(S) and 9(R) hydroperoxides. The manner in which substrates bind to the lipoxygenase family of enzymes is not known. It is believed fatty acid substrates may bind either with the aliphatic end first or with the carboxylate group facing the interior of the protein. This thesis tested a potential methyl-end first substrate binding mechanism by studying the activity of SBLO-1 to oxygenate immobilized linoleoyl residues attached to an insoluble polymer. Linoleic acid was attached to aminohexyl agarose in the presence of N-(3- dimethylaminopropyl)-N’-ethylcarbodiimide hydrochloride (EDC) and Nhydroxysuccinimide (NHS). The concentration of the covalently attached residues was facilitated by enriching linoleic acid with a small amount of the radioactive 14C-isotope. Functionalization yields of 3% available primary amines on the resin were obtained. Enzymatic oxygenation of the linoleoyl-residues was verified using the ferrous oxidation in xylenol orange (FOX) assay. Approximately 30% of the attached linoleoyl moieties were converted to hydroperoxides in the presence of SBLO-1. A disulfide-containing cleavable linker, cystamine, was used as part of an improved method to isolate the product in a facile manner. Cystamine was attached to NHS-activated agarose with approximately 5% overall functionalization yield of available functional groups. 14C-linoleic acid was successfully covalently linked to the cystamine moieties in the presence of EDC and NHS. The FOX assay verified the enzymatic oxygenation of the linoleoyl residues attached to cystamine-derivatized agarose. The isolation of the peroxide product was attempted in a series of extractions in organic solvents. The product was analyzed using GC/MS which did not show a new peak indicative of product. Further work is needed to successfully analyze the stereoand regiochemistry of the oxygenated product. The presence of the peroxides in this study indicated the linoleoyl residues behave as substrates of SBLO-1. It is unknown how bulky substrates bind to the active site; however, it is difficult to rationalize a carboxylate group-first binding mode. Discovery of the 13(S)-hydroperoxide product on the linoleoyl-agarose would support the claim of a potential methyl-end first binding mechanism.