Yolk Androstenedione in Domestic Chicks (Gallus Gallus Domesticus): Uptake and Sex-Dependent Alteration of Growth and Behavior

In birds, causes and consequences of variation in maternally-derived steroids in egg yolk have been the subject of intense experimentation. Many studies have quantified or manipulated testosterone ("T") and one of its immediate precursors, androstenedione ("A4") - often lumping the two steroids as "androgens" and treating them as functionally equivalent. However, yolk A4 is deposited in substantially higher concentrations than T, binds only weakly to the androgen receptor, and is readily converted into either T or estrone by steroidogenic enzymes present during embryonic development. Thus it may not be appropriate to assume that A4 has the same effect as T. In addition, A4's metabolic fate is likely to differ between females and males. The goals of this study were to examine the sex-specific uptake and metabolism of yolk A4 and consequences of elevated levels of yolk A4 on development and behavior of domestic chicks. Eggs were injected with 2mu Ci of tritiated androstenedione; radioactivity was detected in all tissues of day 7 and day 16 embryos and found in both aqueous and organics phases of day 7 yolk, with no difference between sexes. A second set of eggs was injected with 125ng of A4. A4 increased growth of morphological traits (tarsus, beak) in females, but not males. A4 males had smaller combs than controls; there was no treatment effect in females. A4 reduced tonic immobility behavior in both sexes. The results of this study illustrate the importance of distinguishing both between androgens and between sexes when investigating avian endocrine maternal effects. Copyright 2013 Elsevier Inc. All rights reserved.

Modeling And Predicting The Performance Of Infiltrated Solid Oxide Fuel Cell Anodes

Fuel cells are a topic of high interest in the scientific community right now because of their ability to efficiently convert chemical energy into electrical energy. This thesis is focused on solid oxide fuel cells (SOFCs) because of their fuel flexibility, and is specifically concerned with the anode properties of SOFCs. The anodes are composed of a ceramic material (yttrium stabilized zirconia, or YSZ), and conducting material. Recent research has shown that an infiltrated anode may offer better performance at a lower cost. This thesis focuses on the creation of a model of an infiltrated anode that mimics the underlying physics of the production process. Using the model, several key parameters for anode performance are considered. These are the initial volume fraction of YSZ in the slurry before sintering, the final porosity of the composite anode after sintering, and the size of the YSZ and conducting particles in the composite. The performance measures of the anode, namely percolation threshold and effective conductivity, are analyzed as a function of these important input parameters. Simple two and three-dimensional percolation models are used to determine the conditions at which the full infiltrated anode would be investigated. These more simple models showed that the aspect ratio of the anode has no effect on the threshold or effective conductivity, and that cell sizes of 303 are needed to obtain accurate conductivity values. The full model of the infiltrated anode is able to predict the performance of the SOFC anodes and it can be seen that increasing the size of the YSZ decreases the percolation threshold and increases the effective conductivity at low conductor loadings. Similar trends are seen for a decrease in final porosity and a decrease in the initial volume fraction of YSZ.