Identification of erosional mechanisms during past glaciations based on a bedrock surface model of the central European Alps

The bedrock topography beneath the Quaternary cover provides an important archive for the identification of erosional processes during past glaciations. Here, we combined stratigraphic investigations of more than 40,000 boreholes with published data to generate a bedrock topography model for the entire plateau north of the Swiss Alps including the valleys within the mountain belt. We compared the bedrock map with data about the pattern of the erosional resistance of Alpine rocks to identify the controls of the lithologic architecture on the location of overdeepenings. We additionally used the bedrock topography map as a basis to calculate the erosional potential of the Alpine glaciers, which was related to the thickness of the LGM ice. We used these calculations to interpret how glaciers, with support by subglacial meltwater under pressure, might have shaped the bedrock topography of the Alps. We found that the erosional resistance of the bedrock lithology mainly explains where overdeepenings in the Alpine valleys and the plateau occur. In particular, in the Alpine valleys, the locations of overdeepenings largely overlap with areas where the underlying bedrock has a low erosional resistance, or where it was shattered by faults. We also found that the assignment of two end-member scenarios of erosion, related to glacial abrasion/plucking in the Alpine valleys, and dissection by subglacial meltwater in the plateau, may be adequate to explain the pattern of overdeepenings in the Alpine realm. This most likely points to the topographic controls on glacial scouring. In the Alps, the flow of LGM and previous glaciers were constrained by valley flanks, while ice flow was mostly divergent on the plateau where valley borders are absent. We suggest that these differences in landscape conditioning might have contributed to the contrasts in the formation of overdeepenings in the Alpine valleys and the plateau.

Drilling into debris-rich basal ice at the bottom of the NEEM (Greenland) borehole

After the NEEM (Greenland) deep ice-core drilling was declared terminated with respect to developing stratigraphic climate reconstructions, efforts were turned toward collecting basal ice-sheet debris and, if possible, drilling into the bedrock itself. In 2010, several meters of banded debris-rich ice were obtained under normal ice-drilling operations with the NEEM version of the Hans Tausen (HT) drill, but further penetration was obstructed by a rock in the path of the drill head at 2537.36 m. During short campaigns in 2011 and 2012, attempts were made to penetrate further using various reinforced ice cutters mounted on the HT drill head, tailored to cut through rock. These had some success in penetrating coarse material, but produced severely damaged cutters. Additionally a 51 mm diameter diamond cutting tipped rock drill was adapted to fit the NEEM drill. With this device, several additional meters of core containing subglacial sediments, rocks and rock fragments were collected. With these tools 1.39 m of additional material were obtained during the 2011 field season, and 7.1 m during 2012. Subglacial water refreezing into the newly formed borehole hindered further penetration, and the bedrock interface was not reached before final closure of the NEEM Camp.

Retrieving the paleoclimatic signal from the deeper part of the EPICA Dome C ice core

An important share of paleoclimatic information is buried within the lowermost layers of deep ice cores. Because improving our records further back in time is one of the main challenges in the near future, it is essential to judge how deep these records remain unaltered, since the proximity of the bedrock is likely to interfere both with the recorded temporal sequence and the ice properties. In this paper, we present a multiparametric study (δD-δ18Oice, δ18Oatm, total air content, CO2, CH4, N2O, dust, high-resolution chemistry, ice texture) of the bottom 60 m of the EPICA (European Project for Ice Coring in Antarctica) Dome C ice core from central Antarctica. These bottom layers were subdivided into two distinct facies: the lower 12 m showing visible solid inclusions (basal dispersed ice facies) and the upper 48 m, which we will refer to as the "basal clean ice facies". Some of the data are consistent with a pristine paleoclimatic signal, others show clear anomalies. It is demonstrated that neither large-scale bottom refreezing of subglacial water, nor mixing (be it internal or with a local basal end term from a previous/initial ice sheet configuration) can explain the observed bottom-ice properties. We focus on the high-resolution chemical profiles and on the available remote sensing data on the subglacial topography of the site to propose a mechanism by which relative stretching of the bottom-ice sheet layers is made possible, due to the progressively confining effect of subglacial valley sides. This stress field change, combined with bottom-ice temperature close to the pressure melting point, induces accelerated migration recrystallization, which results in spatial chemical sorting of the impurities, depending on their state (dissolved vs. solid) and if they are involved or not in salt formation. This chemical sorting effect is responsible for the progressive build-up of the visible solid aggregates that therefore mainly originate "from within", and not from incorporation processes of debris from the ice sheet's substrate. We further discuss how the proposed mechanism is compatible with the other ice properties described. We conclude that the paleoclimatic signal is only marginally affected in terms of global ice properties at the bottom of EPICA Dome C, but that the timescale was considerably distorted by mechanical stretching of MIS20 due to the increasing influence of the subglacial topography, a process that might have started well above the bottom ice. A clear paleoclimatic signal can therefore not be inferred from the deeper part of the EPICA Dome C ice core. Our work suggests that the existence of a flat monotonic ice–bedrock interface, extending for several times the ice thickness, would be a crucial factor in choosing a future "oldest ice" drilling location in Antarctica.

Overdeepened glacial basins as archives for the Quaternary landscape evolution of the Alps

The Alps and the Alpine foreland have been shaped by repeated glaciations during Quaternary glacial-interglacial cycles. Extent, timing and impact on landscape evolution of these glaciations are, however, poorly constrained due to the fragmentary character of terrestrial archives. In this context, the sedimentary infills of subglacially eroded, ‘overdeepened’, basins may serve as important archives to complement the Quaternary stratigraphy over several glacial-interglacial cycles. In this thesis, the infills of deep subglacial basins in the Lower Glatt valley (N Switzerland) are explored to better constrain the Middle- to Late Pleistocene environmental change. Five drill cores gave direct insight into to the up to ~200 m thick valley fill at the study site and allowed for detailed analysis of sedimentary facies, age and architecture of the basin fills. A first focus is set on the sedimentology of coarse-grained diamicts with sorted interbeds overlying bedrock in the trough center, which mark the onset of deposition in many glacial bedrock troughs. Evidence from macro- and microsedimentology suggests that these sediments are emplaced subglacially and reflect deposition, reworking and deformation in response to repeated coupling and decoupling of the ice-bed interface promoted by high basal water pressures. Overlying these subglacial sediments, large volumes of sandy glacio-deltaic, fine-grained glacio-lacustrine and lacustrine sediments document sedimentation during glacier retreat from the basins. On these thick valley fill sequences the applicability and reliability of luminescence dating is investigated in a second step on the basis of experiments with several different luminescence signals, protocols and experiments to assess the signal stability. The valley fill of the Lower Glatt valley is then grouped into nine depositional cycles (Formations A-I), which are related to the Birrfeld Glaciation (~MIS2), the Beringen Glaciation (~MIS6), and up to three earlier Middle Pleistocene glaciations, tentatively correlated to the Hagenholz, Habsburg, and Möhlin Glaciations, according to the regional glaciation history. The complex bedrock geometry and valley fill architecture are shown to be the result of multiple erosion and infilling cycles and reflect the interplay of subglacial erosion, glacial to lacustrine infilling of overdeepened basins, and fluvial down-cutting and aggradation in the non-overdeepened valley fill. Evidence suggests that in the study area deep bedrock incision, and/or partial re-excavation, occurred mainly during the Beringen and Hagenholz Glaciation, while older structures may have existed. Together with the observation of minor, ‘inlaid’ glacial basins, dynamic changes in the magnitude and focus of subglacial erosion over time are documented.