Pathology of sarcoptic mange in red foxes (Vulpes vulpes): macroscopic and histologic characterization of three disease stages

Sarcoptic mange is a highly contagious skin disease that can have a devastating impact on affected wild mammal populations. There are notable variations in the clinical and pathologic picture of sarcoptic mange among species and among conspecifics. However, the origin of these variations is unclear. We propose a classification scheme for skin lesions associated with Sarcoptes scabiei infestation to provide a basis for a subsequent risk factor analysis. We conducted a case-control study focused on macroscopic and histologic examination of the skin, using 279 red foxes (Vulpes vulpes) found dead or shot in Switzerland between November 2004 and February 2006. All animals were submitted to gross necropsy following a detailed protocol. Selection criteria for cases (n=147) vs. controls (n=111) were the presence or absence of mange-like lesions, mite detection by isolation or histologic examination, and serologic testing for S. scabiei antibodies. Characteristic features of mange lesions were scored macroscopically in all foxes and histologically in 67 cases and 15 controls. We classified skin lesions and associated necropsy findings into three types of mange: A) early stage (n=45): focal-extensive skin lesions, thin crusts, mild to moderate alopecia, few mites, numerous eosinophils, and mild lymph node enlargement; B) hyperkeratotic, fatal form (n=86): generalized skin lesions, thick crusts with or without alopecia, foul odor, abundance of mites, numerous bacteria and yeasts, numerous lymphocytes and mast cells, severe lymph node enlargement, and emaciation; C) alopecic, healing form (n=16): focal lesions, no crusts, severe alopecia, hyperpigmentation and lichenification, absence of mites, mixed cell infiltration, and rare mild lymph node enlargement. We hypothesize that after stage A, the animal either enters stage B and dies, or stage C and survives, depending on largely unknown extrinsic or intrinsic factors affecting the host ability to control mite infestation.

Liquid–Vapor Interface of Formic Acid Solutions in Salt Water: A Comparison of Macroscopic Surface Tension and Microscopic in Situ X-ray Photoelectron Spectroscopy Measurements

The liquid–vapor interface is difficult to access experimentally but is of interest from a theoretical and applied point of view and has particular importance in atmospheric aerosol chemistry. Here we examine the liquid–vapor interface for mixtures of water, sodium chloride, and formic acid, an abundant chemical in the atmosphere. We compare the results of surface tension and X-ray photoelectron spectroscopy (XPS) measurements over a wide range of formic acid concentrations. Surface tension measurements provide a macroscopic characterization of solutions ranging from 0 to 3 M sodium chloride and from 0 to over 0.5 mole fraction formic acid. Sodium chloride was found to be a weak salting out agent for formic acid with surface excess depending only slightly on salt concentration. In situ XPS provides a complementary molecular level description about the liquid–vapor interface. XPS measurements over an experimental probe depth of 51 Å gave the C 1s to O 1s ratio for both total oxygen and oxygen from water. XPS also provides detailed electronic structure information that is inaccessible by surface tension. Density functional theory calculations were performed to understand the observed shift in C 1s binding energies to lower values with increasing formic acid concentration. Part of the experimental −0.2 eV shift can be assigned to the solution composition changing from predominantly monomers of formic acid to a combination of monomers and dimers; however, the lack of an appropriate reference to calibrate the absolute BE scale at high formic acid mole fraction complicates the interpretation. Our data are consistent with surface tension measurements yielding a significantly more surface sensitive measurement than XPS due to the relatively weak propensity of formic acid for the interface. A simple model allowed us to replicate the XPS results under the assumption that the surface excess was contained in the top four angstroms of solution.

Quantum Nondemolition Measurement Enables Macroscopic Leggett-Garg Tests

We show how a test of macroscopic realism based on Leggett-Garg inequalities (LGIs) can be performed in a macroscopic system. Using a continuous-variable approach, we consider quantum nondemolition (QND) measurements applied to atomic ensembles undergoing magnetically driven coherent oscillation. We identify measurement schemes requiring only Gaussian states as inputs and giving a significant LGI violation with realistic experimental parameters and imperfections. The predicted violation is shown to be due to true quantum effects rather than to a classical invasivity of the measurement. Using QND measurements to tighten the “clumsiness loophole” forces the stubborn macrorealist to recreate quantum backaction in his or her account of measurement.