Compact low-power cortical recording architecture for compressive multichannel data acquisition

This paper introduces an area- and power-efficient approach for compressive recording of cortical signals used in an implantable system prior to transmission. Recent research on compressive sensing has shown promising results for sub-Nyquist sampling of sparse biological signals. Still, any large-scale implementation of this technique faces critical issues caused by the increased hardware intensity. The cost of implementing compressive sensing in a multichannel system in terms of area usage can be significantly higher than a conventional data acquisition system without compression. To tackle this issue, a new multichannel compressive sensing scheme which exploits the spatial sparsity of the signals recorded from the electrodes of the sensor array is proposed. The analysis shows that using this method, the power efficiency is preserved to a great extent while the area overhead is significantly reduced resulting in an improved power-area product. The proposed circuit architecture is implemented in a UMC 0.18 [Formula: see text]m CMOS technology. Extensive performance analysis and design optimization has been done resulting in a low-noise, compact and power-efficient implementation. The results of simulations and subsequent reconstructions show the possibility of recovering fourfold compressed intracranial EEG signals with an SNR as high as 21.8 dB, while consuming 10.5 [Formula: see text]W of power within an effective area of 250 [Formula: see text]m × 250 [Formula: see text]m per channel.

A Baseline Wander Tracking System for Artifact Rejection in Long-Term Electrocardiography

Long-term electrocardiogram (ECG) signals might suffer from relevant baseline disturbances during physical activity. Motion artifacts in particular are more pronounced with dry surface or esophageal electrodes which are dedicated to prolonged ECG recording. In this paper we present a method called baseline wander tracking (BWT) that tracks and rejects strong baseline disturbances and avoids concurrent saturation of the analog front-end. The proposed algorithm shifts the baseline level of the ECG signal to the middle of the dynamic input range. Due to the fast offset shifts, that produce much steeper signal portions than the normal ECG waves, the true ECG signal can be reconstructed offline and filtered using computationally intensive algorithms. Based on Monte Carlo simulations we observed reconstruction errors mainly caused by the non-linearity inaccuracies of the DAC. However, the signal to error ratio of the BWT is higher compared to an analog front-end featuring a dynamic input ranges above 15 mV if a synthetic ECG signal was used. The BWT is additionally able to suppress (electrode) offset potentials without introducing long transients. Due to its structural simplicity, memory efficiency and the DC coupling capability, the BWT is dedicated to high integration required in long-term and low-power ECG recording systems.

Towards Batteryless Cardiac Implantable Electronic Devices – The Swiss Way

Energy harvesting devices are widely discussed as an alternative power source for todays active implantable medical devices. Repeated battery replacement procedures can be avoided by extending the implants life span, which is the goal of energy harvesting concepts. This reduces the risk of complications for the patient and may even reduce device size. The continuous and powerful contractions of a human heart ideally qualify as a battery substitute. In particular, devices in close proximity to the heart such as pacemakers, defibrillators or bio signal (ECG) recorders would benefit from this alternative energy source. The clockwork of an automatic wristwatch was used to transform the hearts kinetic energy into electrical energy. In order to qualify as a continuous energy supply for the consuming device, the mechanism needs to demonstrate its harvesting capability under various conditions. Several in-vivo recorded heart motions were used as input of a mathematical model to optimize the clockworks original conversion efficiency with respect to myocardial contractions. The resulting design was implemented and tested during in-vitro and in-vivo experiments, which demonstrated the superior sensitivity of the new design for all tested heart motions.

Causes, forms and consequences of the professionalization of international sport federa-tions in Switzerland: Conceptual framework and first results

Synopsis: Sport organisations are facing multiple challenges originating from an increasingly complex and dynamic environment in general, and from internal changes in particular. Our study seeks to reveal and analyse the causes for professionalization processes in international sport federations, the forms resulting from it, as well as related consequences. Abstract: AIM OF ABSTRACT/PAPER - RESEARCH QUESTION Sport organisations are facing multiple challenges originating from an increasingly complex and dynamic environment in general, and from internal changes in particular. In this context, professionalization seems to have been adopted by sport organisations as an appropriate strategy to respond to pressures such as becoming more “business-like”. The ongoing study seeks to reveal and analyse the internal and external causes for professionalization processes in international sport federations, the forms resulting from it (e.g. organisational, managerial, economic) as well as related consequences on objectives, values, governance methods, performance management or again rationalisation. THEORETICAL BACKGROUND/LITERATURE REVIEW Studies on sport as specific non-profit sector mainly focus on the prospect of the “professionalization of individuals” (Thibault, Slack & Hinings, 1991), often within sport clubs (Thiel, Meier & Cachay, 2006) and national sport federations (Seippel, 2002) or on organisational change (Griginov & Sandanski, 2008; Slack & Hinings, 1987, 1992; Slack, 1985, 2001), thus leaving broader analysis on governance, management and professionalization in sport organisations an unaccomplished task. In order to further current research on above-mentioned topics, our intention is to analyse causes, forms and consequences of professionalisation processes in international sport federations. The social theory of action (Coleman, 1986; Esser, 1993) has been defined as appropriate theoretical framework, deriving in the following a multi-level framework for the analysis of sport organisations (Nagel, 2007). In light of the multi-level framework, sport federations are conceptualised as corporative actors whose objectives are defined and implemented with regard to the interests of member organisations (Heinemann, 2004) and/or other pressure groups. In order to understand social acting and social structures (Giddens 1984) of sport federations, two levels are in the focus of our analysis: the macro level examining the environment at large (political, social, economic systems etc.) and the meso level (Esser, 1999) examining organisational structures, actions and decisions of the federation’s headquarter as well as member organisations. METHODOLOGY, RESEARCH DESIGN AND DATA ANALYSIS The multi-level framework mentioned seeks to gather and analyse information on causes, forms and consequences of professionalization processes in sport federations. It is applied in a twofold approach: first an exploratory study based on nine semi-structured interviews with experts from umbrella sport organisations (IOC, WADA, ASOIF, AIOWF, etc.) as well as the analysis of related documents, relevant reports (IOC report 2000 on governance reform, Agenda 2020, etc.) and important moments of change in the Olympic Movement (Olympic revenue share, IOC evaluation criteria, etc.); and secondly several case studies. Whereas the exploratory study seeks more the causes for professionalization on an external, internal and headquarter level as depicted in the literature, the case studies rather focus on forms and consequences. Applying our conceptual framework, the analysis of forms is built around three dimensions: 1) Individuals (persons and positions), 2) Processes, structures (formalisation, specialisation), 3) Activities (strategic planning). With regard to consequences, we centre our attention on expectations of and relationships with stakeholders (e.g. cooperation with business partners), structure, culture and processes (e.g. governance models, performance), and expectations of and relationships with member organisations (e.g. centralisation vs. regionalisation). For the case studies, a mixed-method approach is applied to collect relevant data: questionnaires for rather quantitative data, interviews for rather qualitative data, as well as document and observatory analysis. RESULTS, DISCUSSION AND IMPLICATIONS/CONCLUSIONS With regard to causes of professionalization processes, we analyse the content of three different levels: 1. the external level, where the main pressure derives from financial resources (stakeholders, benefactors) and important turning points (scandals, media pressure, IOC requirements for Olympic sports); 2. the internal level, where pressure from member organisations turned out to be less decisive than assumed (little involvement of member organisations in decision-making); 3. the headquarter level, where specific economic models (World Cups, other international circuits, World Championships), and organisational structures (decision-making procedures, values, leadership) trigger or hinder a federation’s professionalization process. Based on our first analysis, an outline for an economic model is suggested, distinguishing four categories of IFs: “money-generating IFs” being rather based on commercialisation and strategic alliances; “classical Olympic IFs” being rather reactive and dependent on Olympic revenue; “classical non-Olympic IFs” being rather independent of the Olympic Movement; and “money-receiving IFs” being dependent on benefactors and having strong traditions and values. The results regarding forms and consequences will be outlined in the presentation. The first results from the two pilot studies will allow us to refine our conceptual framework for subsequent case studies, thus extending our data collection and developing fundamental conclusions. References: Bayle, E., & Robinson, L. (2007). A framework for understanding the performance of national governing bodies of sport. European Sport Management Quarterly, 7, 249–268 Chantelat, P. (2001). La professionnalisation des organisations sportives: Nouveaux débats, nouveaux enjeux [Professionalisation of sport organisations]. Paris: L’Harmattan. Dowling, M., Edwards, J., & Washington, M. (2014). Understanding the concept of professionalization in sport management research. Sport Management Review. Advance online publication. doi: 10.1016/j.smr.2014.02.003 Ferkins, L. & Shilbury, D. (2012). Good Boards Are Strategic: What Does That Mean for Sport Governance? Journal of Sport Management, 26, 67-80. Thibault, L., Slack, T., & Hinings, B. (1991). Professionalism, structures and systems: The impact of professional staff on voluntary sport organizations. International Review for the Sociology of Sport, 26, 83–97.

Self-assembly of sensory neurons into ganglia-like microtissues

Unraveling intra- and inter-cellular signaling networks managing cell-fate control, coordinating complex differentiation regulatory circuits and shaping tissues and organs in living systems remain major challenges in the post-genomic era. Resting on the laurels of past-century monolayer culture technologies, the cell culture community has only recently begun to appreciate the potential of three-dimensional mammalian cell culture systems to reveal the full scope of mechanisms orchestrating the tissue-like cell quorum in space and time. Capitalizing on gravity-enforced self-assembly of monodispersed primary embryonic mouse cells in hanging drops, we designed and characterized a three-dimensional cell culture model for ganglion-like structures. Within 24h, a mixture of mouse embryonic fibroblasts (MEF) and cells, derived from the dorsal root ganglion (DRG) (sensory neurons and Schwann cells) grown in hanging drops, assembled to coherent spherical microtissues characterized by a MEF feeder core and a peripheral layer of DRG-derived cells. In a time-dependent manner, sensory neurons formed a polar ganglion-like cap structure, which coordinated guided axonal outgrowth and innervation of the distal pole of the MEF feeder spheroid. Schwann cells, present in embryonic DRG isolates, tended to align along axonal structures and myelinate them in an in vivo-like manner. Whenever cultivation exceeded 10 days, DRG:MEF-based microtissues disintegrated due to an as yet unknown mechanism. Using a transgenic MEF feeder spheroid, engineered for gaseous acetaldehyde-inducible interferon-beta (ifn-beta) production by cotransduction of retro-/ lenti-viral particles, a short 6-h ifn-beta induction was sufficient to rescue the integrity of DRG:MEF spheroids and enable long-term cultivation of these microtissues. In hanging drops, such microtissues fused to higher-order macrotissue-like structures, which may pave the way for sophisticated bottom-up tissue engineering strategies. DRG:MEF-based artificial micro- and macrotissue design demonstrated accurate key morphological aspects of ganglions and exemplified the potential of self-assembled scaffold-free multicellular micro-/macrotissues to provide new insight into organogenesis.

Meta-Environment and Executable Meta-Language using Smalltalk: an Experience Report

Object-oriented modelling languages such as EMOF are often used to specify domain specific meta-models. However, these modelling languages lack the ability to describe behavior or operational semantics. Several approaches have used a subset of Java mixed with OCL as executable meta-languages. In this experience report we show how we use Smalltalk as an executable meta-language in the context of the Moose reengineering environment. We present how we implemented EMOF and its behavioral aspects. Over the last decade we validated this approach through incrementally building a meta-described reengineering environment. Such an approach bridges the gap between a code-oriented view and a meta-model driven one. It avoids the creation of yet another language and reuses the infrastructure and run-time of the underlying implementation language. It offers an uniform way of letting developers focus on their tasks while at the same time allowing them to meta-describe their domain model. The advantage of our approach is that developers use the same tools and environment they use for their regular tasks. Still the approach is not Smalltalk specific but can be applied to language offering an introspective API such as Ruby, Python, CLOS, Java and C#.

The German business and information technologies project

The Business and Information Technologies (BIT) project strives to reveal new insights into how modern IT impacts organizational structures and business practices using empirical methods. Due to its international scope, it allows for inter-country comparison of empirical results. Germany — represented by the European School of Management and Technologies (ESMT) and the Institute of Information Systems at Humboldt-Universität zu Berlin — joined the BIT project in 2006. This report presents the result of the first survey conducted in Germany during November–December 2006. The key results are as follows: • The most widely adopted technologies and systems in Germany are websites, wireless hardware and software, groupware/productivity tools, and enterprise resource planning (ERP) systems. The biggest potential for growth exists for collaboration and portal tools, content management systems, business process modelling, and business intelligence applications. A number of technological solutions have not yet been adopted by many organizations but also bear some potential, in particular identity management solutions, Radio Frequency Identification (RFID), biometrics, and third-party authentication and verification. • IT security remains on the top of the agenda for most enterprises: budget spending was increasing in the last 3 years. • The workplace and work requirements are changing. IT is used to monitor employees' performance in Germany, but less heavily compared to the United States (Karmarkar and Mangal, 2007).1 The demand for IT skills is increasing at all corporate levels. Executives are asking for more and better structured information and this, in turn, triggers the appearance of new decision-making tools and online technologies on the market. • The internal organization of companies in Germany is underway: organizations are becoming flatter, even though the trend is not as pronounced as in the United States (Karmarkar and Mangal, 2007), and the geographical scope of their operations is increasing. Modern IT plays an important role in enabling this development, e.g. telecommuting, teleconferencing, and other web-based collaboration formats are becoming increasingly popular in the corporate context. • The degree to which outsourcing is being pursued is quite limited with little change expected. IT services, payroll, and market research are the most widely outsourced business functions. This corresponds to the results from other countries. • Up to now, the adoption of e-business technologies has had a rather limited effect on marketing functions. Companies tend to extract synergies from traditional printed media and on-line advertising. • The adoption of e-business has not had a major impact on marketing capabilities and strategy yet. Traditional methods of customer segmentation are still dominating. The corporate identity of most organizations does not change significantly when going online. • Online sales channel are mainly viewed as a complement to the traditional distribution means. • Technology adoption has caused production and organizational costs to decrease. However, the costs of technology acquisition and maintenance as well as consultancy and internal communication costs have increased.