Relevance of In-vitro Tests of Adhesive and Composite Dental Materials. A Review in 3 Parts. Part 2: Non-standardized tests of composite materials

Summary The first part of this review examined ISO approval requirements and in vitro testing. In the second part, non-standardized test methods for composite materials are presented and discussed. Physical tests are primarily described. Analyses of surface gloss and alterations, as well as aging simulations of dental materials are presented. Again, the importance of laboratory tests in determining clinical outcomes is evaluated. Differences in the measurement protocols of the various testing institutes and how these differences can in?uence the results are also discussed. Because there is no standardization of test protocols, the values determined by different institutes cannot be directly compared. However, the ranking of the tested materials should be the same if a valid protocol is applied by different institutes. The modulus of elasticity, the expansion after water sorption, and the polishability of the material are all clinically relevant, whereas factors measured by other test protocols may have no clinical correlation. The handling properties of the materials are highly dependent on operators' preferences. Therefore, no standard values can be given.

Relevance of in vitro tests of adhesive and composite dental materials, a review in 3 parts. Part 1: Approval requirements and standardized testing of composite materials according to ISO specifications

The first part of this three-part review on the relevance of laboratory testing of composites and adhesives deals with approval requirements for composite materials. We compare the in vivo and in vitro literature data and discuss the relevance of in vitro analyses. The standardized ISO protocols are presented, with a focus on the evaluation of physical parameters. These tests all have a standardized protocol that describes the entire test set-up. The tests analyse flexural strength, depth of cure, susceptibility to ambient light, color stability, water sorption and solubility, and radiopacity. Some tests have a clinical correlation. A high flexural strength, for instance, decreases the risk of fractures of the marginal ridge in posterior restorations and incisal edge build-ups of restored anterior teeth. Other tests do not have a clinical correlation or the threshold values are too low, which results in an approval of materials that show inferior clinical properties (e.g., radiopacity). It is advantageous to know the test set-ups and the ideal threshold values to correctly interpret the material data. Overall, however, laboratory assessment alone cannot ensure the clinical success of a product.

Structural and resting state functional connectivity of the subthalamic nucleus: identification of motor STN parts and the hyperdirect pathway

Deep brain stimulation (DBS) for Parkinson's disease often alleviates the motor symptoms, but causes cognitive and emotional side effects in a substantial number of cases. Identification of the motor part of the subthalamic nucleus (STN) as part of the presurgical workup could minimize these adverse effects. In this study, we assessed the STN's connectivity to motor, associative, and limbic brain areas, based on structural and functional connectivity analysis of volunteer data. For the structural connectivity, we used streamline counts derived from HARDI fiber tracking. The resulting tracks supported the existence of the so-called "hyperdirect" pathway in humans. Furthermore, we determined the connectivity of each STN voxel with the motor cortical areas. Functional connectivity was calculated based on functional MRI, as the correlation of the signal within a given brain voxel with the signal in the STN. Also, the signal per STN voxel was explained in terms of the correlation with motor or limbic brain seed ROI areas. Both right and left STN ROIs appeared to be structurally and functionally connected to brain areas that are part of the motor, associative, and limbic circuit. Furthermore, this study enabled us to assess the level of segregation of the STN motor part, which is relevant for the planning of STN DBS procedures.

Persistence of biological traces at inside parts of a firearm from a case of multiple familial homicide

Backspatter from wounds caused by contact shots against a biological target had before been shown to be propelled into firearms' barrels where they can persist and be retrieved from as relevant forensic evidence. Herein, that insight was applied to the investigation of a case of multiple familial homicide with a firearm. Samples of backspatter were collected from the firearm using DNA-free swabs. DNA was extracted from the swabs, and 16 STR systems were PCR-amplified to generate DNA profiles of all victims shot by the firearm. The quality of the resulting DNA profiles was sufficient to exclude the perpetrator as donor and to differentiate the three closely related victims thereby proving that all three victims had been shot by the same firearm from very close or contact distance. A key insight gained from this case was that not only a firearms' barrel inside but other inner surfaces may be charged with profilable DNA.

Simultaneous analysis of nuclear and mitochondrial DNA, mRNA and miRNA from backspatter from inside parts of firearms generated by shots at "triple contrast" doped ballistic models

When a firearm projectile hits a biological target a spray of biological material (e.g., blood and tissue fragments) can be propelled from the entrance wound back towards the firearm. This phenomenon has become known as "backspatter" and if caused by contact shots or shots from short distances traces of backspatter may reach, consolidate on, and be recovered from, the inside surfaces of the firearm. Thus, a comprehensive investigation of firearm-related crimes must not only comprise of wound ballistic assessment but also backspatter analysis, and may even take into account potential correlations between these emergences. The aim of the present study was to evaluate and expand the applicability of the "triple contrast" method by probing its compatibility with forensic analysis of nuclear and mitochondrial DNA and the simultaneous investigation of co-extracted mRNA and miRNA from backspatter collected from internal components of different types of firearms after experimental shootings. We demonstrate that "triple contrast" stained biological samples collected from the inside surfaces of firearms are amenable to forensic co-analysis of DNA and RNA and permit sequence analysis of the entire mtDNA displacement-loop, even for "low template" DNA amounts that preclude standard short tandem repeat DNA analysis. Our findings underscore the "triple contrast" method's usefulness as a research tool in experimental forensic ballistics.

The European Hare (Lepus europaeus): A Picky Herbivore Searching for Plant Parts Rich in Fat

European hares of both sexes rely on fat reserves, particularly during the reproduc-tive season. Therefore, hares should select dietary plants rich in fat and energy. However, hares also require essential polyunsaturated fatty acids (PUFA) such as linoleic acid (LA) and alpha-linolenic acid (ALA) to reproduce and survive. Although hares are able to absorb PUFA selectively in their gastrointestinal tract, it is unknown whether this mechanism is sufficient to guarantee PUFA supply. Thus, diet selection may involve a trade-off between a preference for energy versus a preference for crucial nutrients, namely PUFA. We compared plant and nutrient availability and use by hares in an arable landscape in Austria over three years. We found that European hares selected their diet for high energy content (crude fat and crude protein), and avoided crude fibre. There was no evidence of a preference for plants rich in LA and ALA. We conclude that fat is the limiting resource for this herbivorous mammal, whereas levels of LA and ALA in forage are sufficiently high to meet daily requirements, especially since their uptake is enhanced by physiological mechanisms. Animals selected several plant taxa all year round, and preferences did not simply correlate with crude fat content. Hence, European hares might not only select for plant taxa rich in fat, but also for high-fat parts of preferred plant taxa. As hares preferred weeds/grasses and various crop types while avoiding cereals, we suggest that promoting heterogeneous habitats with high crop diversity and set-asides may help stop the decline of European hares throughout Europe.