The impact of ozone treatment on enamel physical properties

PURPOSE: To assess the effects of the highly reactive molecule of ozone on sound enamel physical properties and its effects on sealing ability. METHODS: The effect of ozone on sealant tag length, microleakage and unfilled area proportion were evaluated on intact and prepared sound molar fissures. Microhardness, contact angle and acid resistance tests were performed on ground sound smooth surfaces. The samples were treated with ozone for 40 seconds (HealOzone). Control samples were treated with air (modified HealOzone) or left untreated. RESULTS: No statistically significant difference was observed between the control and ozone treated samples in all tests. Prepared fissures exhibited no unfilled areas and a statistically significantly lower microleakage compared to intact fissures. Ozone was shown to dehydrate enamel and consequently enhance its microhardness, which was reversible.

Treating open carious lesions in anxious children with ozone. A prospective controlled clinical study

PURPOSE: To determine whether the treatment of dental caries with ozone was possible in apprehensive children and to ascertain whether ozone reverses caries in open single-surface lesions. Further, the influence of ozone on laser fluorescence was investigated. METHODS: 82 lesions in 28 children with at least two open single-surface lesions were assessed. The children were anxious and were judged by the referring dentist as non-treatable. For each test lesion, which was treated with ozone, a control lesion was left without ozone treatment. Hardness and laser fluorescence values were assessed and the changes for hardness and laser fluorescence values in the test lesion were compared with the values in the control lesion after 2, 4, 6, and 8 months. RESULTS: 94 percent of the children were treatable and 93% lost their dental anxiety. The hardness values improved significantly in the ozone-treated test lesions after 4, 6, and 8 months (P< 0.05) compared with baseline while the control lesions had no significant change in hardness at any recall interval. Comparing the differences between test and control teeth over time, the laser fluorescence values improved, however the improvement was not statistically significant (P> 0.05). The use of ozone resulted in an average reduction of 13% of the laser fluorescence values immediately after the ozone treatment.

Treating sensitive cervical areas with ozone. A prospective controlled clinical trial

PURPOSE: To determine whether the treatment of hypersensitive teeth with gaseous ozone (Healozone, KaVo 1600 ppm) for 60 seconds reduces pain immediately after treatment and in the longer term. METHODS: In three private practices in Switzerland, 31 subjects suffering from hypersensitive teeth were treated with gaseous ozone over a period of 54 weeks (one test and one control tooth in each subject). A cross-over design was chosen. The pain level was measured with a Visual Analogue Scale before and after the treatment. RESULTS: The subjects' pain level was reduced by 55% +/- 5.5% immediately after the ozone treatment. Over time, the pain level decreased significantly in all groups: The pain level in the test teeth was significantly reduced in Weeks 0-22 (treatment group, P < 0.001) compared to the pain level before treatment. The pain level in the control group was also reduced significantly over time in Weeks 0-22 (no-treatment, P = 0.025) and in Weeks 22-54 (treatment group, P = 0.0065). Comparing test and control teeth over time, there was no statistically significant difference in pain reduction (P = 0.58).

Mechanical and Chemical Stability of Injection-Molded Microcantilevers Used for Sensing

Ultraviolet-ozone treatment is used as a standard surface cleaning procedure for removal of molecular organic contamination from analytical and sensing devices. Here, it is applied for injection-molded polymer microcantilevers before characterization and sensing experiments. This article examines the effects of the surface cleaning process using commercial equipment, in particular on the performance and mechanical properties of the cantilevers. It can be shown that the first chemical aging process essentially consist of the cross linking of the polymer chains together with a physical aging of the material. For longer exposure, the expected thermo-oxidative formation of carbonyl groups sets in and an exposure dependent chemical degradation can be detected. A process time of 20 min was found suitable as a trade-off between cleaning and stability

Effect of ozone on periodontopathogenic species--an in vitro study

The in vitro study was aimed to determine the effect of ozone on periodontopathogenic microorganisms. Ozone was generated for 6 s-2 × 24 s (corresponding to 0.56 mg-2 × 2.24 mg of ozone) against 23 mainly anaerobic periodontopathogenic species. Agar diffusion test was used as a screening method. Then, the killing activity was tested in a serum-free environment and with 25% v/v inactivated serum. Further, the effect of ozone on bactericidal activity of native serum was analyzed against Fusobacterium nucleatum, Porphyromonas gingivalis, and Aggregatibacter actinomycetemcomitans. Agar diffusion test showed a high efficacy of ozone against microorganisms, especially against Porphyromonas gingivalis. This result was confirmed by the killing tests; most of the strains in a concentration of 10(5) were completely eliminated after twofold 18-s application of ozone. Only four of the six potentially "superinfecting" species (Staphylococcus aureus, Enterococcus faecalis, Enterobacter cloacae, Candida albicans) survived in part. Addition of heat-inactivated serum reduced the killing rate of ozone by 78% after 6-s and by 47% after twofold 18-s exposures; no strain was completely eradicated after any application of ozone. The bactericidal effect of native serum was enhanced after application of ozone; no effect was visible on the included A. actinomycetemcomitans strain which was found to be completely resistant to the bactericidal action of serum. In conclusion, (a) ozone has a strong antibacterial activity against putative periodontopathogenic microorganisms, and (b) the bactericidal effect is reduced in the presence of serum. Ozone may have potential as an adjunctive application to mechanical treatment in periodontitis patients.

Comparison of the immediate effects of gaseous ozone and chlorhexidine gel on bacteria in cavitated carious lesions in children in vivo

Clinical application of ozone gas has been shown to arrest the progression of dentinal caries in children. In this study, we compare the immediate effects of gaseous ozone and chlorhexidine gel on bacteria in cavitated carious lesions in children. Forty children, each with at least two open occlusal carious lesions, were enrolled in the study. Two teeth were chosen randomly. In one lesion, overlying soft biological material was removed, whilst the other lesion was not excavated. Cavities were rinsed with sterile water and dried with air. A standardised sample was taken from the mesial part of each lesion. Then, gaseous ozone (HealOzone) or 1% chlorhexidine gel (Corsodyl) was applied for 30 s on both lesions of 20 children each, and a second sample was taken from the distal part of each lesion. The anaerobic microbiota was cultivated; the number of colony forming units was calculated per milligram sample. The two-sided paired t test showed no significant (P > 0.05) differences in the reduction of total bacterial counts per milligram comparing samples before and after ozone or chlorhexidine application. The tests also showed no statistically significant difference whether the superficial decayed dentine had been removed before ozone or with chlorhexidine treatment or not. It can be concluded that gaseous ozone or chlorhexidine gel application for 30 s to deep occlusal carious cavities had no significant immediate antimicrobial effects whether the superficial decayed layers dentine were removed or not.