Simple beam models for Monte Carlo photon beam dose calculations in radiotherapy

Monte Carlo (code GEANT) produced 6 and 15 MV phase space (PS) data were used to define several simple photon beam models. For creating the PS data the energy of starting electrons hitting the target was tuned to get correct depth dose data compared to measurements. The modeling process used the full PS information within the geometrical boundaries of the beam including all scattered radiation of the accelerator head. Scattered radiation outside the boundaries was neglected. Photons and electrons were assumed to be radiated from point sources. Four different models were investigated which involved different ways to determine the energies and locations of beam particles in the output plane. Depth dose curves, profiles, and relative output factors were calculated with these models for six field sizes from 5x5 to 40x40cm2 and compared to measurements. Model 1 uses a photon energy spectrum independent of location in the PS plane and a constant photon fluence in this plane. Model 2 takes into account the spatial particle fluence distribution in the PS plane. A constant fluence is used again in model 3, but the photon energy spectrum depends upon the off axis position. Model 4, finally uses the spatial particle fluence distribution and off axis dependent photon energy spectra in the PS plane. Depth dose curves and profiles for field sizes up to 10x10cm2 were not model sensitive. Good agreement between measured and calculated depth dose curves and profiles for all field sizes was reached for model 4. However, increasing deviations were found for increasing field sizes for models 1-3. Large deviations resulted for the profiles of models 2 and 3. This is due to the fact that these models overestimate and underestimate the energy fluence at large off axis distances. Relative output factors consistent with measurements resulted only for model 4.

Drought Stress alters Solute Allocation in Broadleaf Dock (Rumex obtusifolius)

According to climate models, drier summers must be expected more frequently in Central Europe during the next decades, which may influence plant performance and competition in grassland. The overall source–sink relations in plants, especially allocation of solutes to above- and below-ground parts, may be affected by drought. To investigate solute export from a given leaf of broadleaf dock, a solution containing 57Co and 65Zn was introduced through a leaf flap. The export from this leaf was detected by analysing radionuclide contents in various plant parts. Less label was allocated to new leaves and more to roots under drought. The observed alterations of source–sink relations in broadleaf dock were reversible during a subsequent short period of rewatering. These findings suggest an increased resource allocation to roots under drought improving the functionality of the plants.

Achieving a more realistic assessment of rockfall hazards by coupling three-dimensional process models and field-based tree-ring data

Sound knowledge of the spatial and temporal patterns of rockfalls is fundamental for the management of this very common hazard in mountain environments. Process-based, three-dimensional simulation models are nowadays capable of reproducing the spatial distribution of rockfall occurrences with reasonable accuracy through the simulation of numerous individual trajectories on highly-resolved digital terrain models. At the same time, however, simulation models typically fail to quantify the ‘real’ frequency of rockfalls (in terms of return intervals). The analysis of impact scars on trees, in contrast, yields real rockfall frequencies, but trees may not be present at the location of interest and rare trajectories may not necessarily be captured due to the limited age of forest stands. In this article, we demonstrate that the coupling of modeling with tree-ring techniques may overcome the limitations inherent to both approaches. Based on the analysis of 64 cells (40 m × 40 m) of a rockfall slope located above a 1631-m long road section in the Swiss Alps, we illustrate results from 488 rockfalls detected in 1260 trees. We illustrate that tree impact data cannot only be used (i) to reconstruct the real frequency of rockfalls for individual cells, but that they also serve (ii) the calibration of the rockfall model Rockyfor3D, as well as (iii) the transformation of simulated trajectories into real frequencies. Calibrated simulation results are in good agreement with real rockfall frequencies and exhibit significant differences in rockfall activity between the cells (zones) along the road section. Real frequencies, expressed as rock passages per meter road section, also enable quantification and direct comparison of the hazard potential between the zones. The contribution provides an approach for hazard zoning procedures that complements traditional methods with a quantification of rockfall frequencies in terms of return intervals through a systematic inclusion of impact records in trees.

Models of hybridization during range expansions and their application to recent human evolution

Several lines of genetic, archeological and paleontological evidence suggest that anatomically modern humans (Homo sapiens) colonized the world in the last 60,000 years by a series of migrations originating from Africa (e.g. Liu et al., 2006; Handley et al., 2007; Prugnolle, Manica, and Balloux, 2005; Ramachandran et al. 2005; Li et al. 2008; Deshpande et al. 2009; Mellars, 2006a, b; Lahr and Foley, 1998; Gravel et al., 2011; Rasmussen et al., 2011). With the progress of ancient DNA analysis, it has been shown that archaic humans hybridized with modern humans outside Africa. Recent direct analyses of fossil nuclear DNA have revealed that 1–4 percent of the genome of Eurasian has been likely introgressed by Neanderthal genes (Green et al., 2010; Reich et al., 2010; Vernot and Akey, 2014; Sankararaman et al., 2014; Prufer et al., 2014; Wall et al., 2013), with Papua New Guineans and Australians showing even larger levels of admixture with Denisovans (Reich et al., 2010; Skoglund and Jakobsson, 2011; Reich et al., 2011; Rasmussen et al., 2011). It thus appears that the past history of our species has been more complex than previously anticipated (Alves et al., 2012), and that modern humans hybridized several times with local hominins during their expansion out of Africa, but the exact mode, time and location of these hybridizations remain to be clarifi ed (Ibid.; Wall et al., 2013). In this context, we review here a general model of admixture during range expansion, which lead to some predictions about expected patterns of introgression that are relevant to modern human evolution.

Enhanced associative memory for colour (but not shape or location) in synaesthesia

People with grapheme-colour synaesthesia have been shown to have enhanced memory on a range of tasks using both stimuli that induce synaesthesia (e.g. words) and, more surprisingly, stimuli that do not (e.g. certain abstract visual stimuli). This study examines the latter by using multi-featured stimuli consisting of shape, colour and location conjunctions (e.g. shape A + colour A + location A; shape B + colour B + location B) presented in a recognition memory paradigm. This enables distractor items to be created in which one of these features is ‘unbound’ with respect to the others (e.g. shape A + colour B + location A; shape A + colour A + location C). Synaesthetes had higher recognition rates suggesting an enhanced ability to bind certain visual features together into memory. Importantly, synaesthetes’ false alarm rates were lower only when colour was the unbound feature, not shape or location. We suggest that synaesthetes are “colour experts” and that enhanced perception can lead to enhanced memory in very specific ways; but, not for instance, an enhanced ability to form associations per se. The results support contemporary models that propose a continuum between perception and memory.

Selective sampling during catastrophic disruption: Mapping the location of reaccumulated fragments in the original parent body

In this paper, we simulate numerically the catastrophic disruption of a large asteroid as a result of a collision with a smaller projectile and the subsequent reaccumulation of fragments as a result of their mutual gravitational attractions. We then investigate the original location within the parent body of the small pieces that eventually reaccumulate to form the largest offspring of the disruption as a function of the internal structure of the parent body. We consider four cases that may represent the internal structure of such a body (whose diameter is fixed at 250 km) in various early stages of the Solar System evolution: fully molten, half molten (i.e., a 26 km-deep outer layer of melt containing half of the mass), solid except a thin molten layer (8 km thick) centered at 10 km depth, and fully solid. The solid material has properties of basalt. We then focus on the three largest offspring that have enough reaccumulated pieces to consider. Our results indicate that the particles that eventually reaccumulate to form the largest reaccumulated bodies retain a memory of their original locations in the parent body. Most particles in each reaccumulated body are clustered from the same original region, even if their reaccumulations take place far away. The extent of the original region varies considerably depending on the internal structure of the parent. It seems to shrink with the solidity of the body. The fraction of particles coming from a given depth is computed for the four cases, which can give constraints on the internal structure of parent bodies of some meteorites. As one example, we consider the ureilites, which in some petrogenetic models are inferred to have formed at particular depths within their parent body. (C) 2014 Elsevier Ltd. All rights reserved.