Publication and non-publication of clinical trials: longitudinal study of applications submitted to a research ethics committee

BACKGROUND: Not all clinical trials are published, which may distort the evidence that is available in the literature. We studied the publication rate of a cohort of clinical trials and identified factors associated with publication and nonpublication of results. METHODS: We analysed the protocols of randomized clinical trials of drug interventions submitted to the research ethics committee of University Hospital (Inselspital) Bern, Switzerland from 1988 to 1998. We identified full articles published up to 2006 by searching the Cochrane CENTRAL database (issue 02/2006) and by contacting investigators. We analyzed factors associated with the publication of trials using descriptive statistics and logistic regression models. RESULTS: 451 study protocols and 375 corresponding articles were analyzed. 233 protocols resulted in at least one publication, a publication rate of 52%. A total of 366 (81%) trials were commercially funded, 47 (10%) had non-commercial funding. 346 trials (77%) were multi-centre studies and 272 of these (79%) were international collaborations. In the adjusted logistic regression model non-commercial funding (Odds Ratio [OR] 2.42, 95% CI 1.14-5.17), multi-centre status (OR 2.09, 95% CI 1.03-4.24), international collaboration (OR 1.87, 95% CI 0.99-3.55) and a sample size above the median of 236 participants (OR 2.04, 95% CI 1.23-3.39) were associated with full publication. CONCLUSIONS: In this cohort of applications to an ethics committee in Switzerland, only about half of clinical drug trials were published. Large multi-centre trials with non-commercial funding were more likely to be published than other trials, but most trials were funded by industry.

Nanoscale switching characteristics of nearly tetragonal BiFeO3 thin films

We have investigated the nanoscale switching properties of strain-engineered BiFeO(3) thin films deposited on LaAlO(3) substrates using a combination of scanning probe techniques. Polarized Raman spectral analysis indicates that the nearly tetragonal films have monoclinic (Cc) rather than P4mm tetragonal symmetry. Through local switching-spectroscopy measurements and piezoresponse force microscopy, we provide clear evidence of ferroelectric switching of the tetragonal phase, but the polarization direction, and therefore its switching, deviates strongly from the expected (001) tetragonal axis. We also demonstrate a large and reversible, electrically driven structural phase transition from the tetragonal to the rhombohedral polymorph in this material, which is promising for a plethora of applications.

Overview of data assimilation methods

We present the data assimilation approach, which provides a framework for combining observations and model simulations of the climate system, and has led to a new field of applications for paleoclimatology. The three subsequent articles explore specific applications in more detail.

Precise Orbit Determination of Low Earth Satellites at AIUB using GPS and SLR data

An ever increasing number of low Earth orbiting (LEO) satellites is, or will be, equipped with retro-reflectors for Satellite Laser Ranging (SLR) and on-board receivers to collect observations from Global Navigation Satellite Systems (GNSS) such as the Global Positioning Sys- tem (GPS) and the Russian GLONASS and the European Galileo systems in the future. At the Astronomical Insti- tute of the University of Bern (AIUB) LEO precise or- bit determination (POD) using either GPS or SLR data is performed for a wide range of applications for satellites at different altitudes. For this purpose the classical numeri- cal integration techniques, as also used for dynamic orbit determination of satellites at high altitudes, are extended by pseudo-stochastic orbit modeling techniques to effi- ciently cope with potential force model deficiencies for satellites at low altitudes. Accuracies of better than 2 cm may be achieved by pseudo-stochastic orbit modeling for satellites at very low altitudes such as for the GPS-based POD of the Gravity field and steady-state Ocean Circula- tion Explorer (GOCE).

Visible and Infrared Spectroscopical Applications

Spectra in the visible (VIS) and infrared (IR) region contain a wide variety of information about inorganic and organic substances in sediments. The information from the spectra enables a wide array of applications that allow quantitative, semiquantitative, and qualitative characterization of sediment. Due to the fact that instrument/experimental setups are simple, rapid, and cost-saving and that only small sample quantities are required, the technique has become valuable in paleolimnological and Quaternary science. This article summarizes the theoretical background of VIS and IR spectroscopy, explains the analytical process, introduces statistical tools used for interpretation of spectra, and provides examples of applications in Quaternary science.

A new methodological protocol for the use of dendrogeomorphological data in flood risk analysis

Dendrogeomorphology uses information sources recorded in the roots, trunks and branches of trees and bushes located in the fluvial system to complement (or sometimes even replace) systematic and palaeohydrological records of past floods. The application of dendrogeomorphic data sources and methods to palaeoflood analysis over nearly 40 years has allowed improvements to be made in frequency and magnitude estimations of past floods. Nevertheless, research carried out so far has shown that the dendrogeomorphic indicators traditionally used (mainly scar evidence), and their use to infer frequency and magnitude, have been restricted to a small, limited set of applications. New possibilities with enormous potential remain unexplored. New insights in future research of palaeoflood frequency and magnitude using dendrogeomorphic data sources should: (1) test the application of isotopic indicators (16O/18O ratio) to discover the meteorological origin of past floods; (2) use different dendrogeomorphic indicators to estimate peak flows with 2D (and 3D) hydraulic models and study how they relate to other palaeostage indicators; (3) investigate improved calibration of 2D hydraulic model parameters (roughness); and (4) apply statistics-based cost–benefit analysis to select optimal mitigation measures. This paper presents an overview of these innovative methodologies, with a focus on their capabilities and limitations in the reconstruction of recent floods and palaeofloods.

Determination of Metabolic Stability Using Cryopreserved Hepatocytes from Rainbow Trout (Oncorhynchus mykiss).

Trout provide a relatively easy source of hepatocytes that can be cryopreserved and used for a range of applications including toxicity testing and determination of intrinsic clearance. Standard protocols for isolating, cryopreserving, and thawing rainbow trout hepatocytes are described, along with procedures for using fresh or cryopreserved hepatocytes to assess metabolic stability of xenobiotics in fish by means of a substrate depletion approach. Variations on these methods, troubleshooting tips, and directions for use of extrapolation factors to express results in terms of in vivo intrinsic clearance are included. These protocols have been developed for rainbow trout, but can be adapted to other fish species with appropriate considerations.

Early ship-based upper-air data and comparison with the Twentieth Century

Extension of 3-D atmospheric data products back into the past is desirable for a wide range of applications. Historical upper-air data are important in this endeavour, particularly in the maritime regions of the tropics and the southern hemisphere, where observations are extremely sparse. Here we present newly digitized and re-evaluated early ship-based upper-air data from two cruises: (1) kite and registering balloon profiles from onboard the ship SMS Planet on a cruise from Europe around South Africa and across the Indian Ocean to the western Pacific in 1906/1907, and (2) ship-based radiosonde data from onboard the MS Schwabenland on a cruise from Europe across the Atlantic to Antarctica and back in 1938/1939. We describe the data and provide estimations of the errors. We compare the data with a recent reanalysis (the Twentieth Century Reanalysis Project, 20CR, Compo et al., 2011) that provides global 3-D data back to the 19th century based on an assimilation of surface pressure data only (plus monthly mean sea-surface temperatures). In cruise (1), the agreement is generally good, but large temperature differences appear during a period with a strong inversion. In cruise (2), after a subset of the data are corrected, close agreement between observations and 20CR is found for geopotential height (GPH) and temperature notwithstanding a likely cold bias of 20CR at the tropopause level. Results are considerably worse for relative humidity, which was reportedly inaccurately measured. Note that comparing 20CR, which has limited skill in the tropical regions, with measurements from ships in remote regions made under sometimes difficult conditions can be considered a worst case assessment. In view of that fact, the anomaly correlations for temperature of 0.3–0.6 in the lower troposphere in cruise (1) and of 0.5–0.7 for tropospheric temperature and GPH in cruise (2) are considered as promising results. Moreover, they are consistent with the error estimations. The results suggest room for further improvement of data products in remote regions.

Acute health problems in African refugees: ten years' experience in a Swiss emergency department

Over the last two decades, the total number of applications from Africans for asylum in the countries of the European Union has increased from 578,000 to more than 2.9 million. About 20 % (7,196/36,100) of the asylum seekers in Switzerland originate from Africa. The disease profile of African asylum seekers is remarkably different from that of the native population in the country of application. We have therefore conducted an analysis of African asylum seekers presenting themselves to our emergency department.

Robotics in ear, nose and throat (ENT) surgery

The three main classes of robotics in ear, nose and throat (ENT) surgery (telemanipulation, image-guided functional servoing, and computer numerical control) are discussed and important examples of applications are described to show both technological and clinical developments. As access to many anatomical features of the head requires very small and compact tools to accurately perform procedures, examples are give in ear surgery where manipulation of the minute ossicles requires fine, dexterous movements.

Optimized spectrally selective steady-state free precession sequences for cartilage imaging at ultra-high fields

OBJECT: Fat suppressed 3D steady-state free precession (SSFP) sequences are of special interest in cartilage imaging due to their short repetition time in combination with high signal-to-noise ratio. At low-to-high fields (1.5-3.0 T), spectral spatial (spsp) radio frequency (RF) pulses perform superiorly over conventional saturation of the fat signal (FATSAT pulses). However, ultra-high fields (7.0 T and more) may offer alternative fat suppression techniques as a result of the increased chemical shift. MATERIALS AND METHODS: Application of a single, frequency selective, RF pulse is compared to spsp excitation for water (or fat) selective imaging at 7.0 T. RESULTS: For SSFP, application of a single frequency selective RF pulse for selective water or fat excitation performs beneficially over the commonly applied spsp RF pulses. In addition to the overall improved fat suppression, the application of single RF pulses leads to decreased power depositions, still representing one of the major restrictions in the design and application of many pulse sequences at ultra-high fields. CONCLUSION: The ease of applicability and implementation of single frequency selective RF pulses at ultra-high-fields might be of great benefit for a vast number of applications where fat suppression is desirable or fat-water separation is needed for quantification purposes.

Model-Centric, Context-Aware Software Adaptation

Software must be constantly adapted to changing requirements. The time scale, abstraction level and granularity of adaptations may vary from short-term, fine-grained adaptation to long-term, coarse-grained evolution. Fine-grained, dynamic and context-dependent adaptations can be particularly difficult to realize in long-lived, large-scale software systems. We argue that, in order to effectively and efficiently deploy such changes, adaptive applications must be built on an infrastructure that is not just model-driven, but is both model-centric and context-aware. Specifically, this means that high-level, causally-connected models of the application and the software infrastructure itself should be available at run-time, and that changes may need to be scoped to the run-time execution context. We first review the dimensions of software adaptation and evolution, and then we show how model-centric design can address the adaptation needs of a variety of applications that span these dimensions. We demonstrate through concrete examples how model-centric and context-aware designs work at the level of application interface, programming language and runtime. We then propose a research agenda for a model-centric development environment that supports dynamic software adaptation and evolution.

Multimorbidity in adult asylum seekers: a first overview

PRINCIPALS Over the last two decades, the total annual number of applications for asylum in the countries of the European Union has increased from 15,000 to more than 300,000 people. The aim of this study was to give a first overview on multimorbidity of adult asylum seekers. METHODS Our retrospective Swiss single center data analysis examined multimorbidity of adult asylums seekers admitted to our ED between 1 January 2000 and 31 December 2012. RESULTS A total of 3170 patients were eligible for the study; they were predominantly male (2392 male, 75.5% versus 778 female, 24.5). The median age of the patients was 28 years (range 28-82). The most common region of origin was Africa (1544, 48.7%), followed by the Middle East (736, 23.6%). 2144 (67.6%) of all patients were not multimorbid. A total of 1183 (37.7%) of our patients were multimorbid. The mean Charlson comorbidity index was 0.25 (SD 1.1, range 0-12). 634 (20%) of all patients sufferem from psychiatric diseases, followed by chronic medical conditions (12.6%, 399) and infectious diseases (4.7%, 150). Overall, 11% (349) of our patients presented as a direct consequence of prior violence. Patients from Sri Lanka/India most often suffered from addictions problems (50/240, 20.8%, p<0.0001). Infectious diseases were most frequent in patients from Africa (6.6%), followed by the Balkans and Eastern Europe/Russia (each 3.8%). CONCLUSION The health care problems of asylum seekers are manifold. More than 60% of the study population assessed in our study did not suffer from more than one disease. Nevertheless a significant percentage of asylum seekers is multimorbid and exhibits underlying psychiatric, infectious or chronic medical conditions despite their young age.

Radiometric Method for Emissivity Retrieval in High Reflective Materials

High reflective materials in the microwave region play a very important role in the realization of antenna reflectors for a broad range of applications, including radiometry. These reflectors have a characteristic emissivity which needs to be characterized accurately in order to perform a correct radiometric calibration of the instrument. Such a characterization can be performed by using open resonators, waveguide cavities or by radiometric measurements. The latter consists of comparative radiometric observations of absorbers, reference mirrors and the sample under test, or using the cold sky radiation as a direct reference source. While the first two mentioned techniques are suitable for the characterization of metal plates and mirrors, the latter has the advantages to be also applicable to soft materials. This paper describes how, through this radiometric techniques, it is possible to characterize the emissivity of the sample relative to a reference mirror and how to characterize the absolute emissivity of the latter by performing measurements at different incident angles. The results presented in this paper are based on our investigations on emissivity of a multilayer insulation material (MLI) for space mission, at the frequencies of 22 and 90 GHz.