Iodine-129: Sample preparation, quality control and analyses of pre-nuclear materials and of natural waters from Lower Saxony, Germany

Sample preparation procedures for AMS measurements of 129I and 127I in environmental materials and some methodological aspects of quality assurance are discussed. Measurements from analyses of some pre-nuclear soil and thyroid gland samples and of a systematic investigation of natural waters in Lower Saxony, Germany, are described. Although the up-to-now lowest 129I/127I ratios in soils and thyroid glands were observed, they are still suspect to contamination since they are significantly higher than the pre-nuclear equilibrium ratio in the marine hydrosphere. A survey on all available 129I/127I isotopic ratios in precipitation shows a dramatic increase until the middle of the 1980s and a stabilization since 1987 at high isotopic ratios of about (3.6–8.3)×10−7. In surface waters, ratios of (57–380)×10−10 are measured while shallow ground waters show with ratios of (1.3–200)×10−10 significantly lower values with a much larger spread. The data for 129I in soils and in precipitation are used to estimate pre-nuclear and modern 129I deposition densities.

Influence of sample matrix on the alkaline extraction of Cr(VI) in soils and industrial materials

An accurate and efficient determination of the highly toxic Cr(VI) in solid materials is important to determine the total Cr(VI) inventory of contaminated sites and the Cr(VI) release potential from such sites into the environment. Most commonly, total Cr(VI) is extracted from solid materials following a hot alkaline extraction procedure (US EPA method 3060A) where a complete release of water-extractable and sparingly soluble Cr(VI) phase is achieved. This work presents an evaluation of matrix effects that may occur during the hot alkaline extraction and in the determination of the total Cr(VI) inventory of variably composed contaminated soils and industrial materials (cement, fly ash) and is compared to water-extractable Cr(VI) results. Method validation including multiple extractions and matrix spiking along with chemical and mineralogical characterization showed satisfying results for total Cr(VI) contents for most of the tested materials. However, unreliable results were obtained by applying method 3060A to anoxic soils due to the degradation of organic material and/or reactions with Fe2+-bearing mineral phases. In addition, in certain samples discrepant spike recoveries have to be also attributed to sample heterogeneity. Separation of possible extracted Cr(III) by applying cation-exchange cartridges prior to solution analysis further shows that under the hot alkaline extraction conditions only Cr(VI) is present in solution in measurable amounts, whereas Cr(III) gets precipitated as amorphous Cr(OH)3(am). It is concluded that prior to routine application of method 3060A to a new material type, spiking tests are recommended for the identification of matrix effects. In addition, the mass of extracted solid material should to be well adjusted to the heterogeneity of the Cr(VI) distribution in the material in question.

Long-term Responses of Mountain Ecosystems to Environmental Changes: Resilience, Adjustment, and Vulnerability

The steep environmental gradients of mountain ecosystems over short distances reflect large gradients of several climatic parameters and hence provide excellent possibilities for ecological research on the effects of environmental change. To gain a better understanding of the dynamics of abiotic and biotic parameters of mountain ecosystems, long-term records are required since permanent plots in mountain regions cover in the best case about 50 - 70 years. In order to extend investigations of ecological dynamics beyond these temporal limitations of permanent plots, paleoecological approaches can be used if the sampling resolution can be adapted to ecological research questions, e.g. a sample every 10 years. Paleoecological studies in mountain ecosystems can provide new ecological insights through the combination of different spatial and temporal scales. [f we thus improve our understanding of processes across both steep environmental gradients and different time scales, we may be able to better estimate ecosystem responses to current and future environmental change (Ammann et al. 1993; Lotter et al. 1997). The complexity of ecological interactions in mountain regions forces us to concentrate on a number of sub-systems - without losing sight of the wider context. Here, we summarize a few case studies on the effects of Holocene climate change and disturbance on the vegetation of the Western Alps. To categorize the main response modes of vegetation to climatic change and disturbance in the Alps we use three classes of ecological behaviour: "resilience", "adjustment", and "vulnerability", We assume a resilient (or elastic) behaviour if vegetation is able to recover to its former state, regaining important ecosystem characteristics, such as floristic composition, biodiversity, species abundances, and biomass (e.g. Küttel 1990; Aber and Melillo 199 1). Conversely, vegetation displacements may occur in response to climatic change and/or disturbance. In some cases, this may culminate in irreversible large-scale processes such as species and/or community extinctions. Such drastic developments indicate high ecosystem vulnerability (or inelasticity or instability, for detailed definitions see Küttel 1990; Aber and Melillo 199 1) to climatic change and/or disturbance. In this sense, the "vulnerability" (or instability) of an ecosystem is expressed by the degree of failure to recover to the original state before disturbance and/or climatic change. Between these two extremes (resilience vs. vulnerability), ecosystem adjustments to climatic change and/or disturbance may occur, including the appearance of new and/or the disappearance of old species. The term "adjustment" is hence used to indicate the response of vegetational communities, which adapted to new environmental conditions without losing their main character. For forest ecosystems, we assume vegetational adjustments (rather than vulnerability) if the dominant (or co-dominant) tree species are not outnumbered or replaced by formerly unimportant plant species or new invaders. Adaptation as a genetic process is not discussed here and will require additional pbylogeographical studies (that incorporate the analysis of ancient DNA) in order to fully understand the distributions of ecotypes.