Increment thickness versus dentin bond strength of bulk fill flowables

Objectives: The aim was to investigate the influence of increment thickness on shear bond strength (SBS) to dentin of a conventional and two bulk fill flowable composites. Methods: A total of 135 specimens of ground human dentin were produced (n=15/group; 3 increment thicknesses; 3 flowable composites) and the dentin surfaces were treated with the adhesive system OptiBond FL (Kerr) according to manufacturer’s instructions. Split Teflon molds (inner diameter: 3.6 mm) of 2 mm, 4 mm, or 6 mm height allowing three increment thicknesses were clamped on the dentin surfaces and filled with either the conventional flowable Filtek Supreme XTE ((XTE); 3M ESPE) or the bulk fill flowables Filtek Bulk Fill ((FBF); 3M ESPE) or SDR ((SDR); DENTSPLY Caulk). The flowable composites were light-cured for 20 s (Demi LED; Kerr) and the specimens stored for 24 h (37°C, 100% humidity). Specimens were then subjected to a SBS-test in a universal testing machine at a cross-head speed of 1 mm/min (Zwick Z010; Zwick GmbH & Co.). SBS-values were statistically analysed with a nonparametrical ANOVA followed by exact Wilcoxon rank sum tests (α=0.05). Failure mode of the specimens was determined under a stereomicroscope at 25× magnification. Results: SBS-values (MPa) at 2 mm/4 mm/6 mm increment thicknesses (mean value [standard deviation]) were for XTE: 18.8 [2.6]/17.6 [1.6]/16.7 [3.1], for FBF: 20.6 [2.7]/17.8 [2.7]/18.7 [2.9], and for SDR: 21.7 [2.6]/18.5 [2.6]/20.3 [3.0]. For all three flowable composites, 2 mm increments yielded the highest SBS-values whereas for increments of 4 mm and 6 mm no differences were detected. All specimens presented failure modes involving cohesive failure in dentin. Conclusion: The influence of increment thickness on dentin SBS was less pronounced than expected. However, the high number of cohesive failures in dentin, reflecting the efficiency of the adhesive system, suggests a limited discriminatory power of the SBS-test.

Conflicting Cantonalisms: Disputed Sub-national Territorial Identities in Switzerland

The importance of constituent units for democratic federations, in general, and of the Swiss cantons for the Swiss Confederation, in particular, is beyond doubt. What is less clear, however, is how to solve conflicting views on the number and type of such units. The Swiss case offers two highly topical examples in this regard: the merger of the two ‘half-cantons’ Basel-City and Basel-Country, on the one hand, and the creation of a new canton encompassing canton Jura and the French-speaking area of canton Berne, on the other. In comparing different sub-national political identities at play in these two cases, the strength of ‘cantonalism’—understood as attachment to and identification with a canton—in Switzerland in the 21st century is shown. Second, different manifestations of cantonalism are compared: centre-periphery in Basel, linguistic vs. religious in Jura. Finally, the similar direct-democratic pathways chosen to solve both conflicting understandings of cantonalism testify to the Swiss commitment to peaceful, negotiated and popularly sanctioned settlements.