Hair analysis for Delta9-tetrahydrocannabinolic acid A--new insights into the mechanism of drug incorporation of cannabinoids into hair

Differentiation between external contamination and incorporation of drugs or their metabolites from inside the body via blood, sweat or sebum is a general issue in hair analysis and of high concern when interpreting analytical results. In hair analysis for cannabinoids the most common target is Delta9-tetrahydrocannabinol (THC), sometimes cannabidiol (CBD) and cannabinol (CBN) are determined additionally. After repeated external contamination by cannabis smoke these analytes are known to be found in hair even after performing multiple washing steps. A widely accepted strategy to unequivocally prove active cannabis consumption is the analysis of hair extracts for the oxidative metabolite 11-nor-9-carboxy-THC (THC-COOH). Although the acidic nature of this metabolite suggests a lower rate of incorporation into the hair matrix compared to THC, it is not fully understood up to now why hair concentrations of THC-COOH are generally found to be much lower (mostly <10 pg/mg) than the corresponding THC concentrations. Delta9-Tetrahydrocannabinolic acid A (THCA A) is the preliminary end product of the THC biosynthesis in the cannabis plant. Unlike THC it is non-psychoactive and can be regarded as a 'precursor' of THC being largely decarboxylated when heated or smoked. The presented work shows for the first time that THCA A is not only detectable in blood and urine of cannabis consumers but also in THC positive hair samples. A pilot experiment performed within this study showed that after oral intake of THCA A on a regular basis no relevant incorporation into hair occurred. It can be concluded that THCA A in hair almost exclusively derives from external contamination e.g. by side stream smoke. Elevated temperatures during the analytical procedure, particularly under alkaline conditions, can lead to decarboxylation of THCA A and accordingly increase THC concentrations in hair. Additionally, it has to be kept in mind that in hair samples tested positive for THCA A at least a part of the 'non-artefact' THC probably derives from external contamination as well, because in condensate of cannabis smoke both THC and THCA A are present in relevant amounts. External contamination by side stream smoke could therefore explain the great differences in THC and THC-COOH hair concentrations commonly found in cannabis users.

Pre-Columbian human occupation patterns in the eastern plains of the Llanos de Moxos, Bolivian Amazonia

Despite an increasing number of publications regarding the Pre-Columbian earthworks of the Llanos de Moxos, there have been no serious attempts to undertake a systematic survey of the archaeological remains of this lowland region in the Bolivian Amazon. Based on the GIS analysis of data gathered in the field and retrieved from satellite images, we discuss the spatial distribution of the Pre-Columbian settlements in a 4500 Km2 area of the Llanos de Moxos to the east of Trinidad, capital of the Beni Department, and their relationship with the geographical settings. Our findings shed new light on the prehistory of the region and bear important implications for our understanding of the impact of Pre-Columbian human occupation.

A comparison of pixel and object-based land cover classification. A case study of the Asmara region, Eritrea

In this paper we compare the performance of two image classification paradigms (object- and pixel-based) for creating a land cover map of Asmara, the capital of Eritrea and its surrounding areas using a Landsat ETM+ imagery acquired in January 2000. The image classification methods used were maximum likelihood for the pixel-based approach and Bhattacharyya distance for the object-oriented approach available in, respectively, ArcGIS and SPRING software packages. Advantages and limitations of both approaches are presented and discussed. Classifications outputs were assessed using overall accuracy and Kappa indices. Pixel- and object-based classification methods result in an overall accuracy of 78% and 85%, respectively. The Kappa coefficient for pixel- and object-based approaches was 0.74 and 0.82, respectively. Although pixel-based approach is the most commonly used method, assessment and visual interpretation of the results clearly reveal that the object-oriented approach has advantages for this specific case-study.

Effect of tin-chloride pretreatment on bond strength of two adhesive systems to dentin

OBJECTIVES: To determine the effect on resin composite-to-dentin bond strength of incorporation of an acidic tin-chloride pretreatment in two adhesive systems. MATERIALS AND METHODS: Human molars were ground to expose mid-coronal dentin. For microtensile bond strength (μTBS) testing, dentin was treated with Optibond FL or Clearfil SE according to one of six protocols (n = 22/group). Group 1: Phosphoric acid etching, Optibond FL Prime, Optibond FL Adhesive (manufacturer's instructions; control); Group 2: Tin-chloride pretreatment, Optibond FL Prime, Optibond FL Adhesive; Group 3: Phosphoric acid etching, tin-chloride pretreatment, Optibond FL Prime, Optibond FL Adhesive; Group 4: Clearfil SE Primer, Clearfil SE Bond (manufacturer's instructions; control); Group 5: Phosphoric acid etching, Clearfil SE Primer, Clearfil SE Bond; and Group 6: Tin-chloride pretreatment, Clearfil SE Primer, Clearfil SE Bond. The molars were then built up with resin composite (Clearfil Majesty Esthetic). After storage (1 week, 100  % humidity, 37 °C) the μTBS was measured and failure mode was determined. Additionally, pretreated dentin surfaces were evaluated using SEM and EDX. The μTBS results were analyzed statistically by a Welch Two Sample t-test and a Kruskal-Wallis test followed by exact Wilcoxon rank sum tests with Bonferroni-Holm adjustment for multiple testing (α = 0.05). RESULTS: When Optibond FL was used, partial or total replacement of phosphoric acid with tin-chloride decreased μTBS significantly. In contrast, when Clearfil SE was used, inclusion of a tin-chloride pretreatment in the adhesive procedure increased μTBS significantly. CONCLUSIONS: Tin-chloride pretreatment had a beneficial influence on the bond promoting capacity of the MDP-containing adhesive system Clearfil SE.

Annexations in Europe and the Persecution of Jews, 1939-1944

This contribution tries to explain why Jews were persecuted earlier or more fiercely in territories annexed by a state during World War II than in the mainland of that state. The case-studies covered are Nazi Germany, Romania, Hungary, Bulgaria, and the USSR. It is argued that internationally, similar policies of incorporation, especially the replacement of existing elites and the process of bringing in new settlers, worked against the Jews. Aside from focusing on governmental policies, the contribution also sketches the manner in which individual actions by state functionaries (who did not merely implement state policies) and by non-state actors had adverse effects on the Jewish population, impacting their survival chances. Finally, the article places the persecution of Jews in annexed areas in the context of the concerted violence conducted, at the same time, against other ethnically defined, religious, and social groups.

Cognitive Cities: An Application for Nairobi. Text Message Participation of Slum Inhabitants to Improve Sanitary Facilities

Population growth is always increasing, and thus the concept of smart and cognitive cities is becoming more important. Developed countries are aware of and working towards needed changes in city management. However, emerging countries require the optimization of their own city management. This chapter illustrates, based on a use case, how a city in an emerging country can quickly progress using the concept of smart and cognitive cities. Nairobi, the capital of Kenya, is chosen for the test case. More than half of the population of Nairobi lives in slums with poor sanitation, and many slum inhabitants often share a single toilet, so the proper functioning and reliable maintenance of toilets are crucial. For this purpose, an approach for processing text messages based on cognitive computing (using soft computing methods) is introduced. Slum inhabitants can inform the responsible center via text messages in cases when toilets are not functioning properly. Through cognitive computer systems, the responsible center can fix the problem in a quick and efficient way by sending repair workers to the area. Focusing on the slum of Kibera, an easy-to-handle approach for slum inhabitants is presented, which can make the city more efficient, sustainable and resilient (i.e., cognitive).

Water quality and health in a Sahelian semi-arid urban context: an integrated geographical approach in Nouakchott, Mauritania

Access to sufficient quantities of safe drinking water is a human right. Moreover, access to clean water is of public health relevance, particularly in semi-arid and Sahelian cities due to the risks of water contamination and transmission of water-borne diseases. We conducted a study in Nouakchott, the capital of Mauritania, to deepen the understanding of diarrhoeal incidence in space and time. We used an integrated geographical approach, combining socio-environmental, microbiological and epidemiological data from various sources, including spatially explicit surveys, laboratory analysis of water samples and reported diarrhoeal episodes. A geospatial technique was applied to determine the environmental and microbiological risk factors that govern diarrhoeal transmission. Statistical and cartographic analyses revealed concentration of unimproved sources of drinking water in the most densely populated areas of the city, coupled with a daily water allocation below the recommended standard of 20 l per person. Bacteriological analysis indicated that 93% of the non-piped water sources supplied at water points were contaminated with 10-80 coliform bacteria per 100 ml. Diarrhoea was the second most important disease reported at health centres, accounting for 12.8% of health care service consultations on average. Diarrhoeal episodes were concentrated in municipalities with the largest number of contaminated water sources. Environmental factors (e.g. lack of improved water sources) and bacteriological aspects (e.g. water contamination with coliform bacteria) are the main drivers explaining the spatio-temporal distribution of diarrhoea. We conclude that integrating environmental, microbiological and epidemiological variables with statistical regression models facilitates risk profiling of diarrhoeal diseases. Modes of water supply and water contamination were the main drivers of diarrhoea in this semi-arid urban context of Nouakchott, and hence require a strategy to improve water quality at the various levels of the supply chain.