Nanoshell assisted laser soldering of vascular tissue

Laser tissue soldering (LTS) is a promising technique for tissue fusion but is limited by the lack of reproducibility particularly when the amount of indocyanine green (ICG) applied as energy absorber cannot be controlled during the soldering procedure. Nanotechnology enables the control over the quantitative binding of the ICG. The aim of this study was to establish a highly reproducible and strong tissue fusion using ICG packed nanoshells. By including the chromophore in the soldering scaffold, dilution of the energy absorber during the soldering procedure is prevented. The feasibility of this novel nanoshell soldering technique was studied by assessing the local heating of the area and tensile strength of the resulting fused tissue.

The content and composition of lipids in the digital cushion of the bovine claw with respect to age and location--a preliminary report

The pads of the bovine digital cushion, which serves as a shock absorber, have specific anatomical structures to cope with the substantial forces acting within the claw. To gain more information on the lipid composition and content of the pads, horn shoes from 12 slaughtered heifers and cows were removed and different samples of the pads excised with a scalpel. Pad lipids were extracted and the fatty acid composition determined by gas chromatography. Fat from perirenal and subcutaneous adipose tissues served as a comparison. Overall, this fat contained a higher quantity of extracted lipids than that of the claw pads and did not differ between heifers and cows. In contrast, lipid content in the pads was significantly higher in the cows than in the heifers. In both groups, the lipid content of the middle and abaxial pads, which are situated directly under the distal phalanx, was lower than in the pads of the other locations. The lipids in all pads contained >77% monounsaturated fatty acids (MUFA), differing sharply from the adipose tissue with values <51%. Among the polyunsaturated fatty acids (PUFA) a significantly higher proportion of arachidonic acid (AA) was found in the heifer pads than in those of the cows, whereas the proportion of AA was similar in the adipose tissue of all animals. The proportion of AA in the pad lipids also varied between the defined locations with the highest proportion found in locations that showed the lowest lipid content and was related to the age of the animal.

Low Mass Calibration Target for MM-Wave Remote Sensing Instruments

The reliability of millimeter and sub-millimeter wave radiometer measurements is dependent on the accuracy of the loads they employ as calibration targets. In the recent past on-board calibration loads have been developed for a variety of satellite remote sensing instruments. Unfortunately some of these have suffered from calibration inaccuracies which had poor thermal performance of the calibration target as the root cause. Stringent performance parameters of the calibration target such as low reflectivity, high temperature uniformity, low mass and low power consumption combined with low volumetric requirements remain a challenge for the space instrument developer. In this paper we present a novel multi-layer absorber concept for a calibration load which offers an excellent compromise between very good radiometric performance and temperature uniformity and the mass and volumetric constraints required by space-borne calibration targets.

Radiochemical determination of 129I and 36Cl in MEGAPIE, a proton irradiated lead-bismuth eutectic spallation target

The concentrations of the long-lived nuclear reaction products 129I and 36Cl have been measured in samples from the MEGAPIE liquid metal spallation target. Samples from the bulk target material (lead-bismuth eutectic, LBE), from the interface of the metal free surface with the cover gas, from LBE/steel interfaces and from noble metal absorber foils installed in the cover gas system were analysed using Accelerator Mass Spectrometry at the Laboratory of Ion beam Physics at ETH Zürich. The major part of 129I and 36Cl was found accumulated on the interfaces, particularly at the interface of LBE and the steel walls of the target container, while bulk LBE samples contain only a minor fraction of these nuclides. Both nuclides were also detected on the absorber foils to a certain extent (≪ 1% of the total amount). The latter number is negligible concerning the radio-hazard of the irradiated target material; however it indicates a certain affinity of the absorber foils for halogens, thus proving the principle of using noble metal foils for catching these volatile radionuclides. The total amounts of 129I and 36Cl in the target were estimated from the analytical data by averaging within the different groups of samples and summing up these averages over the total target. This estimation could account for about half of the amount of 129I and 36Cl predicted to be produced using nuclear physics modelling codes for both nuclides. The significance of the results and the associated uncertainties are discussed.