Characteristics, symptoms, and outcome of severe dysnatremias present on hospital admission

Dysnatremias are common in critically ill patients and associated with adverse outcomes, but their incidence, nature, and treatment rarely have been studied systematically in the population presenting to the emergency department. We conducted a study in patients presenting to the emergency department of the University of Bern.

Herpes-simplex virus encephalitis is characterized by an early MMP-9 increase and collagen type IV degradation

Cerebrovascular complications including cerebral edema, raised intracranial pressure and hemorrhage contribute to the high mortality and morbidity of herpes-simplex virus encephalitis (HSE). We examined changes of collagen type IV, the major constituent of the neurovascular matrix, together with expression and localization of matrix-degrading enzymes during the development of acute HSE. In an experimental model of focal HSE, we found that early, symptomatic HSE (3 days after infection) and acute, fully developed HSE (7 days after infection) are associated with significantly raised levels of matrix-metalloproteinase-9 (MMP-9) (both P<0.05). In situ zymography of brain sections revealed that the increase of MMP-9 was restricted to the cerebral vasculature in early HSE and further expanded towards the perivascular space and adjacent tissue in acute HSE. Around the cerebral vasculature, we observed that MMP-9 activity was insufficiently counterbalanced by its endogenous tissue inhibitor of MMP (TIMP) TIMP-1, resulting in loss of collagen type IV. Our findings suggest that MMP-9 is involved in the evolution of HSE by causing damage to the cerebral vasculature. The degradation of the neurovascular matrix in HSE facilitates the development of cerebrovascular complications and may represent a target for novel adjuvant treatment strategies.

Variation of the mechanical properties of PMMA to suit osteoporotic cancellous bone

Poly(methyl methacrylate) (PMMA) is by far the most frequently used bone substitute material for vertebroplasty. However, there are serious complications, such as cement leakage and an increased fracture rate of the adjacent vertebral bodies. The latter may be related to the mechanical properties of the augmented segment within the osteoporotic spine. A possible counter-measure is prophylactic augmentation at additional levels, but this aggravates the risk for the patient. Introduction of pores is a possible method to reduce the inherent high stiffness of PMMA. This study investigates the effect of porosity on the mechanical properties of PMMA bone cement. Different fractions of a highly viscous liquid were mixed into the PMMA during preparation. An open-porous material with adjustable mechanical properties resulted after removal of the aqueous phase. Different radiopacifiers were admixed to investigate their suitability for vertebroplasty. The final material was characterized mechanically by compressive testing, microscopically and radiologically. In addition, the monomer release subsequent to hardening was measured by means of gas chromatography. The Young's modulus in compression could be varied between 2800 +/- 70 MPa and 120 +/- 150 MPa, and the compression ultimate strength between 170 +/- 5 MPa and 8 +/- 9 MPa for aqueous fractions ranging between 0 and 50% of volume. Only a slight decrease of the Young's modulus and small changes of ultimate strength were found when the mixing time was increased. An organic hydrophilic and lipophilic radiopacifier led to a higher Young's modulus of the porous material; however, the ultimate strength was not significantly affected by adding different radiopacifiers to the porous cement. The radiopacity was lost after washing the aqueous phase out of the pores. No separation occurred between the aqueous and the PMMA phase during injection into an open porous ceramic material. The monomer released was found to increase for increasing aqueous fractions, but remained comparable in magnitude to standard PMMA. This study demonstrates that a conventional PMMA can be modified to obtain a range of mechanical properties, including those of osteoporotic bone.