Minimum count sums for charcoalconcentration estimates in pollen slides: accuracy and potential errors

Charcoal particles in pollen slides are often abundant, and thus analysts are faced with the problem of setting the minimum counting sum as small as possible in order to save time. We analysed the reliability of charcoal-concentration estimates based on different counting sums, using simulated low-to high-count samples. Bootstrap simulations indicate that the variability of inferred charcoal concentrations increases progressively with decreasing sums. Below 200 items (i.e., the sum of charcoal particles and exotic marker grains), reconstructed fire incidence is either too high or too low. Statistical comparisons show that the means of bootstrap simulations stabilize after 200 counts. Moreover, a count of 200-300 items is sufficient to produce a charcoal-concentration estimate with less than+5% error if compared with high-count samples of 1000 items for charcoal/marker grain ratios 0.1-0.91. If, however, this ratio is extremely high or low (> 0.91 or < 0.1) and if such samples are frequent, we suggest that marker grains are reduced or added prior to new sample processing.

Time-order errors and standard-position effects in duration discrimination: An experimental study and an analysis by the sensation-weighting model

Studies have shown that the discriminability of successive time intervals depends on the presentation order of the standard (St) and the comparison (Co) stimuli. Also, this order affects the point of subjective equality. The first effect is here called the standard-position effect (SPE); the latter is known as the time-order error. In the present study, we investigated how these two effects vary across interval types and standard durations, using Hellström’s sensation-weighting model to describe the results and relate them to stimulus comparison mechanisms. In Experiment 1, four modes of interval presentation were used, factorially combining interval type (filled, empty) and sensory modality (auditory, visual). For each mode, two presentation orders (St–Co, Co–St) and two standard durations (100 ms, 1,000 ms) were used; half of the participants received correctness feedback, and half of them did not. The interstimulus interval was 900 ms. The SPEs were negative (i.e., a smaller difference limen for St–Co than for Co–St), except for the filled-auditory and empty-visual 100-ms standards, for which a positive effect was obtained. In Experiment 2, duration discrimination was investigated for filled auditory intervals with four standards between 100 and 1,000 ms, an interstimulus interval of 900 ms, and no feedback. Standard duration interacted with presentation order, here yielding SPEs that were negative for standards of 100 and 1,000 ms, but positive for 215 and 464 ms. Our findings indicate that the SPE can be positive as well as negative, depending on the interval type and standard duration, reflecting the relative weighting of the stimulus information, as is described by the sensation-weighting model.

Mapping spectroscopic uncertainties into prospective methane retrieval errors from Sentinel-5 and its precursor

Sentinel-5 (S5) and its precursor (S5P) are future European satellite missions aiming at global monitoring of methane (CH4) column-average dry air mole fractions (XCH4). The spectrometers to be deployed onboard the satellites record spectra of sunlight backscattered from the Earth's surface and atmosphere. In particular, they exploit CH4 absorption in the shortwave infrared spectral range around 1.65 mu m (S5 only) and 2.35 mu m (both S5 and S5P) wavelength. Given an accuracy goal of better than 2% for XCH4 to be delivered on regional scales, assessment and reduction of potential sources of systematic error such as spectroscopic uncertainties is crucial. Here, we investigate how spectroscopic errors propagate into retrieval errors on the global scale. To this end, absorption spectra of a ground-based Fourier transform spectrometer (FTS) operating at very high spectral resolution serve as estimate for the quality of the spectroscopic parameters. Feeding the FTS fitting residuals as a perturbation into a global ensemble of simulated S5- and S5P-like spectra at relatively low spectral resolution, XCH4 retrieval errors exceed 0.6% in large parts of the world and show systematic correlations on regional scales, calling for improved spectroscopic parameters.

Standard Errors for the Blinder-Oaxaca Decomposition

The decomposition technique introduced by Blinder (1973) and Oaxaca (1973) is widely used to study outcome differences between groups. For example, the technique is commonly applied to the analysis of the gender wage gap. However, despite the procedure's frequent use, very little attention has been paid to the issue of estimating the sampling variances of the decomposition components. We therefore suggest an approach that introduces consistent variance estimators for several variants of the decomposition. The accuracy of the new estimators under ideal conditions is illustrated with the results of a Monte Carlo simulation. As a second check, the estimators are compared to bootstrap results obtained using real data. In contrast to previously proposed statistics, the new method takes into account the extra variation imposed by stochastic regressors.

Driver Aggression as a Function of Status Concurrence: An Analysis of Horn-Honking Responses

Various field experiments were conducted to examine the influence of social status on aggression in road traffic. Horn-honking response times of subjects blocked by an experimental car at traffic lights were considered to be an indicator of the degree of aggression. During an initial experiment, the status of the frustrator was varied and an inverse relation was observed between status and aggression towards the frustrator. On the other hand, in a more recent experiment higher status aggressors were found to behave more aggressively. In our study we combined the two designs, i.e., we varied the status of the frustrator and at the same time measured the status of the aggressor. Neither results of the former experiments could be replicated, but we observed a reduction in aggression when frustrator and aggressor were of similar social status.

Latin Americaʹs emergence in global services: a new driver of structural change in the region?

Studies of international production acknowledge that the ability of firms to learn, upgrade and innovate in global value chains (GVCs) is influenced by knowledge flows within these global networks and by the national institutional systems in which the firms are embedded. Little is known, however, about how differences in national innovation and business systems shape the way firms and national economies insert themselves in global value chains and how this influences their upgrading trajectories. Based on a review of the existing academic literature, the chapter examines the impact of national innovation and business systems from middle-income and developing countries on learning and innovation processes in services GVCs.