The Utilization of Classical Spin Monte Carlo Methods to Simulate the Magnetic Behavior of Extended Three-Dimensional Cubic Networks Incorporating M(II) Ions with an S = 5/2 Ground State Spin

The numerical simulations of the magnetic properties of extended three-dimensional networks containing M(II) ions with an S = 5/2 ground-state spin have been carried out within the framework of the isotropic Heisenberg model. Analytical expressions fitting the numerical simulations for the primitive cubic, diamond, together with (10−3) cubic networks have all been derived. With these empirical formulas in hands, we can now extract the interaction between the magnetic ions from the experimental data for these networks. In the case of the primitive cubic network, these expressions are directly compared with those from the high-temperature expansions of the partition function. A fit of the experimental data for three complexes, namely [(N(CH3)4][Mn(N3)] 1, [Mn(CN4)]n 2, and [FeII(bipy)3][MnII2(ox)3] 3, has been carried out. The best fits were those obtained using the following parameters, J = −3.5 cm-1, g = 2.01 (1); J = −8.3 cm-1, g = 1.95 (2); and J = −2.0 cm-1, g = 1.95 (3).

Influence of sample matrix on the alkaline extraction of Cr(VI) in soils and industrial materials

An accurate and efficient determination of the highly toxic Cr(VI) in solid materials is important to determine the total Cr(VI) inventory of contaminated sites and the Cr(VI) release potential from such sites into the environment. Most commonly, total Cr(VI) is extracted from solid materials following a hot alkaline extraction procedure (US EPA method 3060A) where a complete release of water-extractable and sparingly soluble Cr(VI) phase is achieved. This work presents an evaluation of matrix effects that may occur during the hot alkaline extraction and in the determination of the total Cr(VI) inventory of variably composed contaminated soils and industrial materials (cement, fly ash) and is compared to water-extractable Cr(VI) results. Method validation including multiple extractions and matrix spiking along with chemical and mineralogical characterization showed satisfying results for total Cr(VI) contents for most of the tested materials. However, unreliable results were obtained by applying method 3060A to anoxic soils due to the degradation of organic material and/or reactions with Fe2+-bearing mineral phases. In addition, in certain samples discrepant spike recoveries have to be also attributed to sample heterogeneity. Separation of possible extracted Cr(III) by applying cation-exchange cartridges prior to solution analysis further shows that under the hot alkaline extraction conditions only Cr(VI) is present in solution in measurable amounts, whereas Cr(III) gets precipitated as amorphous Cr(OH)3(am). It is concluded that prior to routine application of method 3060A to a new material type, spiking tests are recommended for the identification of matrix effects. In addition, the mass of extracted solid material should to be well adjusted to the heterogeneity of the Cr(VI) distribution in the material in question.

Charge exchange in cometary coma: Discovery of H- ions in the solar wind close to comet 67P/Churyumov-Gerasimenko

As Rosetta was orbiting comet 67P/Churyumov-Gerasimenko, the Ion and Electron Sensor detected negative particles with angular distributions like those of the concurrently measured solar wind protons but with fluxes of only about 10% of the proton fluxes and energies of about 90% of the proton energies. Using well-known cross sections and energy-loss data, it is determined that the fluxes and energies of the negative particles are consistent with the production of H- ions in the solar wind by double charge exchange with molecules in the coma.

Influence of catchment quality and altitude on the water and sediment composition of 68 small lakes in Central Europe

68 lakes (63 Swiss, 2 French and 3 Italian) located in an altitudinal range between 334 and 2339m spanning a wide range of land-use have been investigated. The aim of the study was to discuss influences of geographic location, vegetation and land-use in the catchment area on the water and sediment chemistry of small lakes. Detailed quantitative description of land-use, vegetation, and climate in the watershed of all lakes was established. Surface and bottom water samples collected from each lake were analyzed for major ions and nutrients. Correlations were interpreted using linear regression analysis. Chemical parameters of water and sediment reflect the characteristics of the catchment areas. All lakes were alkaline since they were situated on calcareous bedrock. Concentrations of nitrogen and phosphorus strongly increase with increasing agricultural land-use. Na and K, however, are positively correlated with the amount of urbanization within the catchment area. These elements as well as dissolved organic carbon (DOC), Mg, Ca, and alkalinity, increase when the catchment is urbanized or used for agriculture. Total nitrogen and organic carbon in the sediments decrease distinctly if large parts of the catchment consist of bare land. No correlations between sediment composition and maximum water depth or altitude of the lakes were found.¶Striking differences in the water compositions of lakes above and below approximately 700 m of altitude were observed. Concentrations of total nitrogen and nitrate, total phosphorus, DOC, Na, K, Mg, Ca, and alkalinity are distinctly higher in most lakes below 700 m than above, and the pH of the bottom waters of these lakes is generally lower. Estimates of total nitrogen concentrations, even in remote areas, indicate that precipitation is responsible for increased background concentrations. At lower altitudes nitrogen concentrations in lakes is explained by the nitrogen loaded rain from urban areas deposited on the catchment, and with high percentages of agricultural land-use in the watershed.