Genesis of metasomatic sapphirine-corundum-spinel-bearing granulites in Sri Lanka

The goal of the present study is to understand the mechanism of mass transfer, the composition and the role of fluids during crustal metasomatism in high-temperature metamorphic terranes. A well constrained case study, a locality at Rupaha, Sri Lanka was selected. It is located in the Highland Complex of Sri Lanka, which represents a small, but important fragment of the super-continent Gondwana. Excellent exposures of ultramafic rocks, which are embedded in granulites, were found at 10 localities. These provide a unique background for understanding the metasomatic processes. The boundary between the ultramafic and the granulite rocks are lined with metasomatic reaction zones up to 50cm in width. Progressing from the ultramafics to the granulite host rock, three distinct zones with the following mineral assemblages can be distinguished: (1). phlogopite + spinel + sapphirine, (2). spinel + sapphirine and (3). corundum + biotite + plagioclase. In order to assess the P-T-t path, the peak metamorphism and the exhumation history were constrained using different thermobarometers, as well as a diffusion model of garnet zoning. A maximum temperature of 875 ± 20oC (Opx-Cpx thermometer) and at the peak pressure of 9.0 ± 0.1 kbar (Grt-Cpx-Pl-Qtz) was calculated for the silicic granulite. The ultramafic rocks recorded a peak temperature of 840 ± 70oC (Opx-Cpx thermometer) at 9 kbar. Coexisting spinel and sapphirine from the reaction zone yield a temperature of 820 ± 40oC. This is in agreement with the peak-temperatures recorded in the adjacent granulites and ultramafics rocks. The structural concordance of the ultramafic rocks with the siliceous granulite host rock further support the suggestion, that all units have experienced the same peak metamorphism. Diffusion modeling of retrograde zoning in garnets from mafic granulites suggests a three-step cooling history. A maximum cooling rate of 1oC/Ma is estimated during the initial stage of cooling, followed by a cooling rate of ~30oC/Ma. The outermost rims of garnet indicate a slightly slower cooling rate at about 10-15oC/Ma. The sequences of mineral zones, containing a variety of Al-rich, silica undersaturated minerals in the reaction zones separating the ultramafic rocks from the silica-rich rocks can be explained by a diffusion model. This involves the diffusion of Mg from ultramafic rocks across the layers, and K and Si diffuse in opposite direction. Chemical potential of Mg and Si generated continuous monotonic gradient, allowing steady state diffusional transport across the profile. The strong enrichment in Al, and the considerable loss of Si, during the formation of reaction bands can be inferred from isocon diagrams. Some Al was probably added to the reaction zones, while Si was lost. This is most likely due to fluids percolating parallel to the zones at the boundary of the rock units. This study has shown that not only pressure and temperature conditions but most importantly PH2O and the concentration of the chlorine and fluorine in aqueous fluids also control the mass transport in different geological environments.

Partial melting within the lower crust – Constraints from bulk rock geochemical data and trace element mineral analyses of granulites and migmatites from Central Finland

This PhD thesis concerns geochemical constraints on recycling and partial melting of Archean continental crust. A natural example of such processes was found in the Iisalmi area of Central Finland. The rocks from this area are Middle to Late Archean in age and experienced metamorphism and partial melting between 2.7-2.63 Ga. The work is based on extensive field work. It is furthermore founded on bulk rock geochemical data as well as in-situ analyses of minerals. All geochemical data were obtained at the Institute of Geosciences, University of Mainz using X-ray fluorescence, solution ICP-MS and laser ablation-ICP-MS for bulk rock geochemical analyses. Mineral analyses were accomplished by electron microprobe and laser ablation ICP-MS. Fluid inclusions were studied by microscope on a heating-freezing-stage at the Geoscience Center, University Göttingen. Part I focuses on the development of a new analytical method for bulk rock trace element determination by laser ablation-ICP-MS using homogeneous glasses fused from rock powder on an Iridium strip heater. This method is applicable for mafic rock samples whose melts have low viscosities and homogenize quickly at temperatures of ~1200°C. Highly viscous melts of felsic samples prevent melting and homogenization at comparable temperatures. Fusion of felsic samples can be enabled by addition of MgO to the rock powder and adjustment of melting temperature and melting duration to the rock composition. Advantages of the fusion method are low detection limits compared to XRF analyses and avoidance of wet-chemical processing and use of strong acids as in solution ICP-MS as well as smaller sample volumes compared to the other methods. Part II of the thesis uses bulk rock geochemical data and results from fluid inclusion studies for discrimination of melting processes observed in different rock types. Fluid inclusion studies demonstrate a major change in fluid composition from CO2-dominated fluids in granulites to aqueous fluids in TTG gneisses and amphibolites. Partial melts were generated in the dry, CO2-rich environment by dehydration melting reactions of amphibole which in addition to tonalitic melts produced the anhydrous mineral assemblages of granulites (grt + cpx + pl ± amph or opx + cpx + pl + amph). Trace element modeling showed that mafic granulites are residues of 10-30 % melt extraction from amphibolitic precursor rocks. The maximum degree of melting in intermediate granulites was ~10 % as inferred from modal abundances of amphibole, clinopyroxene and orthopyroxene. Carbonic inclusions are absent in upper-amphibolite facies migmatites whereas aqueous inclusion with up to 20 wt% NaCl are abundant. This suggests that melting within TTG gneisses and amphibolites took place in the presence of an aqueous fluid phase that enabled melting at the wet solidus at temperatures of 700-750°C. The strong disruption of pre-metamorphic structures in some outcrops suggests that the maximum amount of melt in TTG gneisses was ~25 vol%. The presence of leucosomes in all rock types is taken as the principle evidence for melt formation. However, mineralogical appearance as well as major and trace element composition of many leucosomes imply that leucosomes seldom represent frozen in-situ melts. They are better considered as remnants of the melt channel network, e.g. ways on which melts escaped from the system. Part III of the thesis describes how analyses of minerals from a specific rock type (granulite) can be used to determine partition coefficients between different minerals and between minerals and melt suitable for lower crustal conditions. The trace element analyses by laser ablation-ICP-MS show coherent distribution among the principal mineral phases independent of rock composition. REE contents in amphibole are about 3 times higher than REE contents in clinopyroxene from the same sample. This consistency has to be taken into consideration in models of lower crustal melting where amphibole is replaced by clinopyroxene in the course of melting. A lack of equilibrium is observed between matrix clinopyroxene / amphibole and garnet porphyroblasts which suggests a late stage growth of garnet and slow diffusion and equilibration of the REE during metamorphism. The data provide a first set of distribution coefficients of the transition metals (Sc, V, Cr, Ni) in the lower crust. In addition, analyses of ilmenite and apatite demonstrate the strong influence of accessory phases on trace element distribution. Apatite contains high amounts of REE and Sr while ilmenite incorporates about 20-30 times higher amounts of Nb and Ta than amphibole. Furthermore, trace element mineral analyses provide evidence for magmatic processes such as melt depletion, melt segregation, accumulation and fractionation as well as metasomatism having operated in this high-grade anatectic area.

The relevance of the silica metabolizing enzyme silicatein-alpha to biomineralization and the formation of biogenic silica in siliceous sponges

Die technische Silikatproduktion erfordert in der Regel hohe Temperaturen und extreme pH-Werte. In der Natur hingegen haben insbesondere Kieselschwämme die außergewöhnliche Fähigkeit, ihr Silikatskelett, das aus einzelnen sogenannten Spiculae besteht, enzymatisch mittels des Proteins Silicatein zu synthetisieren. rnIm Inneren der Spiculae, im zentralen Kanal, befindet sich das Axialfilament, welches hauptsächlich aus Silicatein-α aufgebaut ist. Mittels Antikörperfärbungen und Elektronenmikroskopischen Analysen konnte festgestellt werden, dass Silicatein in mit Kieselsäure-gefüllten Zellorganellen (silicasomes) nachzuweisen ist. Mittels dieser Vakuolen kann das Enzym und die Kieselsäure aus der Zelle zu den Spiculae im extrazellulären Raum befördert werden, wo diese ihre endgültige Länge und Dicke erreichen. Zum ersten Mal konnte nachgewiesen werden, dass rekombinant hergestelltes Silicatein-α sowohl als Siliciumdioxid-Polymerase als auch Siliciumdioxid-Esterase wirkt. Mittels Massenspektroskopie konnte die enzymatische Polymerisation von Kieselsäure nachverfolgt werden. Durch Spaltung der Esterbindung des künstlichen Substrates Bis(p-aminophenoxy)-dimethylsilan war es möglich kinetische Parameter der Siliciumdioxid-Esterase-Aktivität des rekombinanten Silicateins zu ermitteln.rnZu den größten biogenen Silikatstukuren auf der Erde gehören die Kieselnadeln der Schwammklasse Hexactinellida. Nadelextrakte aus den Schwammklassen Demospongien (S. domuncula) und Hexactinellida (M. chuni) wurden miteinander verglichen um die potentielle Existenz von Silicatein oder Silicatein-ähnliche Molekülen und die dazu gehörige proteolytischen Aktivität nachzuweisen. Biochemische Analysen zeigten, dass das 27 kDA große isolierte Polypeptid in Monoraphis mehrere gemeinsame Merkmale mit den Silicateinen der Demospongien teilt. Dazu gehören die Größe und die Proteinase-Aktivität. rnUm die Frage zu klären, ob das axiale Filament selbst zur Formbildung der Skelettelemente beiträgt, wurde ein neues mildes Extraktionsverfahren eingeführt. Dieses Verfahren ermöglichte die Solubilisierung des nativen Silicateins aus den Spiculae. Die isolierten Silicateine lagen als Monomere (24 kDa) vor, die Dimere durch nicht-kovalente Bindungen ausbildeten. Darüber hinaus konnten durch PAGE-Gelelektrophorese Tetramere (95 kDa) und Hexamere (135 kDa) nachgewiesen werden. Die Monomere zeigten eine beträchtliche proteolytische Aktivität, die sich während der Polymerisationsphase des Proteins weiter erhöhte. Mit Hilfe der Lichtmikroskopie und Elektronenmikroskopie (TEM) konnte die Assemblierung der Proteine zu filamentartigen Strukturen gezeigt werden. Die Selbstorganisation der Silicatein-α-Monomeren scheint eine Basis für Form- und Musterbildung der wachsenden Nadeln zu bilden.rn Um die Rolle des kürzlich entdeckten Proteins Silintaphin-1, ein starker Interaktionspartner des Silicatein-α, während der Biosilifizierung zu klären, wurden Assemblierungs-Experimente mit den rekombinanten Proteinen in vitro durchgeführt. Zusätzlich wurde deren Effekt auf die Biosilikatsynthese untersucht. Elektronenmikroskopische Analysen ergaben, dass rekombinantes Silicatein-α zufällig verteilte Aggregate bildet, während die Koinkubation beider Proteine (molekulares Verhältnis 4:1) über fraktal artige Strukturen zu Filamenten führt. Auch die enzymatische Aktivität der Silicatein-α-vermittelte Biosilikatsynthese erhöhte sich in Gegenwart von Silintaphin-1 um das 5,3-fache. rn