Potential vorticity and moisture in extratropical cyclones : climatology and sensitivity experiments

The development of extratropical cyclones can be seen as an interplay of three positive potential vorticity (PV) anomalies: an upper-level stratospheric intrusion, low-tropospheric diabatically produced PV, and a warm anomaly at the surface acting as a surrogate PV anomaly. In the mature stage they become vertically aligned and form a “PV tower” associated with strong cyclonic circulation. This paradigm of extratropical cyclone development provides the basis of this thesis, which will use a climatological dataset and numerical model experiments to investigate the amplitude of the three anomalies and the processes leading in particular to the formation of the diabatically produced low-tropospheric PV anomaly.rnrnThe first part of this study, based on the interim ECMWF Re-Analysis (ERA-Interim) dataset, quantifies the amplitude of the three PV anomalies in mature extratropical cyclones in different regions in the Northern Hemisphere on a climatological basis. A tracking algorithm is applied to sea level pressure (SLP) fields to identify cyclone tracks. Surface potential temperature anomalies ∆θ and vertical profiles of PV anomalies ∆PV are calculated at the time of the cyclones’ minimum SLP and during the intensification phase 24 hours before in a vertical cylinder with a radius of 200 km around the surface cyclone center. To compare the characteristics of the cyclones, they are grouped according to their location (8 regions) and intensity, where the central SLP is used as a measure of intensity. Composites of ∆PV profiles and ∆θ are calculated for each region and intensity class at the time of minimum SLP and during the cyclone intensification phase.rnrnDuring the cyclones’ development stage the amplitudes of all three anomalies increase on average. In the mature stage all three anomalies are typically larger for intense than for weak winter cyclones [e.g., 0.6 versus 0.2 potential vorticity units (PVU) at lower levels, and 1.5 versus 0.5 PVU at upper levels].rnThe regional variability of the cyclones’ vertical structure and the profile evolution is prominent (cyclones in some regions are more sensitive to the amplitude of a particular anomaly than in other regions). Values of ∆θ and low-level ∆PV are on average larger in the western parts of the oceans than in the eastern parts. In addition, a large seasonal variability can be identified, with fewer and weaker cyclones especially in the summer, associated with higher low-tropospheric PV values, but also with a higher tropopause and much weaker surface potential temperature anomalies (compared to winter cyclones).rnrnIn the second part, we were interested in the diabatic low-level part of PV towers. Evaporative sources were identified of moisture that was involved in PV production through condensation. Lagrangian backward trajectories were calculated from the region with high PV values at low-levels in the cyclones. PV production regions were identified along these trajectories and from these regions a new set of backward trajectories was calculated and moisture uptakes were traced along them. The main contribution from surface evaporation to the specific humidity of the trajectories is collected 12-72 hours prior to therntime of PV production. The uptake region for weaker cyclones with less PV in the centre is typically more localized with reduced uptake values compared to intense cyclones. However, in a qualitative sense uptakes and other variables along single trajectories do not vary much between cyclones of different intensity in different regions.rnrnA sensitivity study with the COSMO model comprises the last part of this work. The study aims at investigating the influence of synthetic moisture modification in the cyclone environment in different stages of its development. Moisture was eliminated in three regions, which were identified as important moisture source regions for PV production. Moisture suppression affected the cyclone the most in its early phase. It led to cyclolysis shortly after its genesis. Nevertheles, a new cyclone formed on the other side of a dry box and developed relatively quickly. Also in other experiments, moisture elimination led to strong intensity reduction of the surface cyclone, limited upper-level development, and delayed or missing interaction between the two.rnrnIn summary, this thesis provides novel insight into the structure of different intensity categories of extratropical cyclones from a PV perspective, which corroborates the findings from a series of previous case studies. It reveals that all three PV anomalies are typically enhanced for more intense cyclones, with important regional differences concerning the relative amplitude of the three anomalies. The moisture source analysis is the first of this kind to study the evaporation-condensation cycle related to the intensification of extratropical cyclones. Interestingly, most of the evaporation occurs during the 3 days prior to the time of maximum cyclone intensity and typically extends over fairly large areas along the track of the cyclone. The numerical model case study complements this analysis by analyzing the impact of regionally confined moisture sources for the evolution of the cyclone.

Development of analytical methodologies for iodine species in gaseous and particulate phases of the coastal atmosphere

It has been demonstrated that iodine does have an important influence on atmospheric chemistry, especially the formation of new particles and the enrichment of iodine in marine aerosols. It was pointed out that the most probable chemical species involved in the production or growth of these particles are iodine oxides, produced photochemically from biogenic halocarbon emissions and/or iodine emission from the sea surface. However, the iodine chemistry from gaseous to particulate phase in the coastal atmosphere and the chemical nature of the condensing iodine species are still not understood. A Tenax / Carbotrap adsorption sampling technique and a thermo-desorption / cryo-trap / GC-MS system has been further developed and improved for the volatile organic iodine species in the gas phase. Several iodo-hydrocarbons such as CH3I, C2H5I, CH2ICl, CH2IBr and CH2I2 etc., have been measured in samples from a calibration test gas source (standards), real air samples and samples from seaweeds / macro-algae emission experiments. A denuder sampling technique has been developed to characterise potential precursor compounds of coastal particle formation processes, such as molecular iodine in the gas phase. Starch, TMAH (TetraMethylAmmonium Hydroxide) and TBAH (TetraButylAmmonium Hydroxide) coated denuders were tested for their efficiencies to collect I2 at the inner surface, followed by a TMAH extraction and ICP/MS determination, adding tellurium as an internal standard. The developed method has been proved to be an effective, accurate and suitable process for I2 measurement in the field, with the estimated detection limit of ~0.10 ng∙L-1 for a sampling volume of 15 L. An H2O/TMAH-Extraction-ICP/MS method has been developed for the accurate and sensitive determination of iodine species in tropospheric aerosol particles. The particle samples were collected on cellulose-nitrate filters using conventional filter holders or on cellulose nitrate/tedlar-foils using a 5-stage Berner impactor for size-segregated particle analysis. The water soluble species as IO3- and I- were separated by anion exchanging process after water extraction. Non-water soluble species including iodine oxide and organic iodine were digested and extracted by TMAH. Afterwards the triple samples were analysed by ICP/MS. The detection limit for particulate iodine was determined to be 0.10~0.20 ng•m-3 for sampling volumes of 40~100 m3. The developed methods have been used in two field measurements in May 2002 and September 2003, at and around the Mace Head Atmospheric Research Station (MHARS) located at the west coast of Ireland. Elemental iodine as a precursor of the iodine chemistry in the coastal atmosphere, was determined in the gas phase at a seaweed hot-spot around the MHARS, showing I2 concentrations were in the range of 0~1.6 ng∙L-1 and indicating a positive correlation with the ozone concentration. A seaweed-chamber experiment performed at the field measurement station showed that the I2 emission rate from macro-algae was in the range of 0.019~0.022 ng•min-1•kg-1. During these experiments, nanometer-particle concentrations were obtained from the Scanning Mobility Particle Sizer (SMPS) measurements. Particle number concentrations were found to have a linear correlation with elemental iodine in the gas phase of the seaweeds chamber, showing that gaseous I2 is one of the important precursors of the new particle formation in the coastal atmosphere. Iodine contents in the particle phase were measured in both field campaigns at and around the field measurement station. Total iodine concentrations were found to be in the range of 1.0 ~ 21.0 ng∙m-3 in the PM2.5 samples. A significant correlation between the total iodine concentrations and the nanometer-particle number concentrations was observed. The particulate iodine species analysis indicated that iodide contents are usually higher than those of iodate in all samples, with ratios in the range of 2~5:1. It is possible that those water soluble iodine species are transferred through the sea-air interface into the particle phase. The ratio of water soluble (iodate + iodide) and non-water soluble species (probably iodine oxide and organic iodine compounds) was observed to be in the range of 1:1 to 1:2. It appears that higher concentrated non-water soluble species, as the products of the photolysis from the gas phase into the particle phase, can be obtained in those samples while the nucleation events occur. That supports the idea that iodine chemistry in the coastal boundary layer is linked with new particle formation events. Furthermore, artificial aerosol particles were formed from gaseous iodine sources (e.g. CH2I2) using a laboratory reaction-chamber experiment, in which the reaction constant of the CH2I2 photolysis was calculated to be based upon the first order reaction kinetic. The end products of iodine chemistry in the particle phase were identified and quantified.

Anatomy, phylogeny, and palaeoecology of the basal thalattosuchians (Mesoeucrocodylia) from the Liassic of Central Europe

In the marine Jurassic deposits of Europe, a group of marine crocodilians, the Thalattosuchia, belongs to the frequently found reptiles. Thalattosuchia are widely spread in Central Europe from the Jurassic to Lower Cretaceous, and some taxa are also distributed worldwide. The task of the work was to examine all taxa known from the Liassic of Europe. The most frequently known taxa Steneosaurus bollensis and Pelagosaurus typus are anatomically revised. New discoveries at the skull of Pelagosaurus typus e.g., the fact of a partly paired frontal are described by means of computed tomography investigations. In addition, juvenile specimens of this taxon are studied in detail for the first time. The rarely occurring taxon Platysuchus multiscrobiculatus is anatomically described in detail for the first time. It shows both in the skull and in the postcranial material morphological differences to Steneosaurus bollensis and Pelagosaurus typus. Thus Pl. multiscrobiculatus possesses, e.g., an ilium with a deeper acetabulum and a femur with a distinctly flexed femoral head. A juvenile specimen of Pl. multiscrobiculatus is now discovered and is described in parts for the first time, too. Furthermore, Steneosaurus gracilirostris and Steneosaurus brevior known from Lower Jurassic deposits of England are examined and in parts revised. In this work, Steneosaurs brevior is discovered with one specimen from the Upper Liassic of Holzmaden, Germany for the first time, and provides new evidence for the palaeobiogeographical distribution of the taxon. Because of the high number of investigated specimens, it is possible to study ontogenetic development from juvenile to adult stage in Steneosaurus bollensis, Pelagosaurus typus, and Platysuchus multiscrobiculatus. Biometric data are collected from thalattosuchians and extant crocodilians (e.g. Gavialis gangeticus) to investigate intraspecific variation, ontogenetic development, and taxa differentiation. The skulls of Platysuchus multiscrobiculatus and Steneosaurus bollensis are reconstructed three-dimensionally as wax models. The skull reconstructions form the basis of the jaw muscle restoration of Steneosaurus bollensis in connection with comparative studies at extant crocodilians. By means of functional morphologic analysis of the jaw musculature, the dentition, and the locomotor system of S. bollensis, possible conclusions are drawn for the prey options and the hunting behaviour. To clarify the relationships within the Thalattosuchia, a computer-based cladistic phylogenetic in-group analyse of 25 Thalattosuchia taxa is performed. For the analysis, following Thalattosuchia taxa are studied likewise at original material for comparisons: Metriorhynchus superciliosus, Metriorhynchus hastifer, Metriorhynchus leedsi, Geosaurus gracilis, Geosaurus giganteus, Teleidosaurus calvadosi, Teleidosaurus gaudryi, Teleosaurus cadomensis, Teleosaurus geoffroyi, Steneosaurus priscus, Steneosaurus edwardsi, Steneosaurus heberti, Steneosaurus leedsi, Steneosaurus boutilieri, Steneosaurus megarhinus, Steneosaurus obtusidens, and Machimosaurus hugii. The phylogenetic in-group analyse based on 115 characters, reveals a sister-group relationship of the monophyletic Teleosauridae and monophyletic Metriorhynchidae. Within the groups, some taxa are probably paraphyletic. The taxon Pelagosaurus typus is nested inside the Teleosauridae and not outside or within the Metriorhynchidae, as many authors suggested it so far. Based on these results, a tentative palaeobiogeographical-evolutionary scenario is developed.