3 resultados para Telemetry of process variables
em ArchiMeD - Elektronische Publikationen der Universität Mainz - Alemanha
Resumo:
The present thesis introduces a novel sensitive technique based on TSM resonators that provides quantitative information about the dynamic properties of biological cells and artificial lipid systems. In order to support and complement results obtained by this method supplementary measurements based on ECIS technique were carried out. The first part (chapters 3 and 4) deals with artificial lipid systems. In chapter 3 ECIS measurements were used to monitor the adsorption of giant unilamellar vesicles as well as their thermal fluctuations. From dynamic Monte Carlo Simulations the rate constant of vesicle adsorption was determined. Furthermore, analysis of fluctuation measurements reveals Brownian motion reflecting membrane undulations of the adherent liposomes. In chapter 4 QCM-based fluctuation measurements were applied to quantify nanoscopically small deformations of giant unilamellar vesicles with an external electrical field applied simultaneously. The response of liposomes to an external voltage with shape changes was monitored as a function of cholesterol content and adhesion force. In the second part (chapters 5 - 8) attention was given to cell motility. It was shown for the first time, that QCM can be applied to monitor the dynamics of living adherent cells in real time. QCM turned out to be a highly sensitive tool to detect the vertical motility of adherent cells with a time resolution in the millisecond regime. The response of cells to environmental changes such as temperature or osmotic stress could be quantified. Furthermore, the impact of cytochalasin D (inhibits actin polymerization) and taxol (facilitate polymerization of microtubules) as well as nocodazole (depolymerizes microtubules) on the dynamic properties of cells was scrutinized. Each drug provoked a significant reduction of the monitored cell shape fluctuations as expected from their biochemical potential. However, not only the abolition of fluctuations was observed but also an increase of motility due to integrin-induced transmembrane signals. These signals were activated by peptides containing the RGD sequence, which is known to be an integrin recognition motif. Ultimately, two pancreatic carcinoma cell lines, derived from the same original tumor, but known to possess different metastatic potential were studied. Different dynamic behavior of the two cell lines was observed which was attributed to cell-cell as well as cell-substrate interactions rather than motility. Thus one may envision that it might be possible to characterize the motility of different cell types as a function of many variables by this new highly sensitive technique based on TSM resonators. Finally the origin of the broad cell resonance was investigated. Improvement of the time resolution reveals the "real" frequency of cell shape fluctuations. Several broad resonances around 3-5 Hz, 15-17 Hz and 25-29 Hz were observed and that could unequivocally be assigned to biological activity of living cells. However, the kind of biological process that provokes this synchronized collective and periodic behavior of the cells remains to be elucidated.
Resumo:
All currently available human skeletal remains from the Wadi Howar (Eastern Sahara, Sudan) were employed in an anthropological study. The study’s first aim was to describe this unique 5th to 2nd millennium BCE material, which comprised representatives of all three prehistoric occupation phases of the region. Detecting diachronic differences in robusticity, occupational stress levels and health within the spatially, temporally and culturally heterogeneous sample was its second objective. The study’s third goal was to reveal metric and non-metric affinities between the different parts of the series and between the Wadi Howar material and other relevant prehistoric as well as modern African populations. rnThe reconstruction and comprehensive osteological analysis of 23 as yet unpublished individuals, the bulk of the Wadi Howar series, constituted the first stage of the study. The analyses focused on each individual’s in situ position, state of preservation, sex, age at death, living height, living weight, physique, biological ancestry, epigenetic traits, robusticity, occupational stress markers, health and metric as well as morphological characteristics. Building on the results of these efforts and the re-examination of the rest of the material, the Wadi Howar series as a whole, altogether 32 individuals, could be described. rnA wide variety of robusticity, occupational stress and health variables was evaluated. The pre-Leiterband (hunter-gatherer-fisher/hunter-gatherer-fisher-herder) and the Leiterband (herder-gatherer) data of over a third of these variables differed statistically significantly or in tendency from each other. The Leiterband sub-sample was characterised by higher enamel hypoplasia frequencies, lower mean ages at death and less pronounced expressions of occupational stress traits. This pattern was interpreted as evidence that the adoption and intensification of animal husbandry did probably not constitute reactions to worsening conditions. Apart from that, the relevant observations, noteworthy tendencies and significant differences were explained as results of a broader spectrum of pre-Leiterband subsistence activities and the negative side effects of the increasingly specialised herder-gatherer economy of the Leiterband phase. rnUsing only the data which could actually be collected from it, multiple, separate, individualised discriminant function analyses were carried out for each Wadi Howar skeleton to determine which prehistoric and which modern comparative sample it was most similar to. The results of all individual analyses were then summarised and examined as a whole. Thus it became possible to draw conclusions about the affinities the Wadi Howar material shared with prehistoric as well as modern populations and to answer questions concerning the diachronic links between the Wadi Howar’s prehistoric populations. When the Wadi Howar remains were positioned in the context of the selected prehistoric (Jebel Sahaba/Tushka, A-Group, Malian Sahara) and modern comparative samples (Southern Sudan, Chad, Mandinka, Somalis, Haya) in this fashion three main findings emerged. Firstly, the series as a whole displayed very strong affinities with the prehistoric sample from the Malian Sahara (Hassi el Abiod, Kobadi, Erg Ine Sakane, etc.) and the modern material from Southern Sudan and, to a lesser extent, Chad. Secondly, the pre-Leiterband and the Leiterband sub-sample were closer to the prehistoric Malian as well as the modern Southern Sudanese material than they were to each other. Thirdly, the group of pre-Leiterband individuals approached the Late Pleistocene sample from Jebel Sahaba/Tushka under certain circumstances. A theory offering explanations for these findings was developed. According to this theory, the entire prehistoric population of the Wadi Howar belonged to a Saharo-Nilotic population complex. The Jebel Sahaba/Tushka population constituted an old Nilotic and the early population of the Malian Sahara a younger Saharan part of this complex. The pre-Leiterband groups probably colonised the Wadi Howar from the east, either during or soon after the original Saharo-Nilotic expansion. Unlike the pre-Leiterband groups, the Leiterband people originated somewhere west of the Wadi Howar. They entered the region in the context of a later, secondary Saharo-Nilotic expansion. In the process, the incoming Leiterband groups absorbed many members of the Wadi Howar’s older pre-Leiterband population. The increasing aridification of the Wadi Howar region ultimately forced its prehistoric inhabitants to abandon the wadi. Most of them migrated south and west. They, or groups closely related to them, probably were the ancestors of the majority of the Nilo-Saharan-speaking pastoralists of modern-day Southern Sudan and Eastern Chad.
Resumo:
In this study a novel method MicroJet reactor technology was developed to enable the custom preparation of nanoparticles. rnDanazol/HPMCP HP50 and Gliclazide/Eudragit S100 nanoparticles were used as model systems for the investigation of effects of process parameters and microjet reactor setup on the nanoparticle properties during the microjet reactor construction. rnFollowing the feasibility study of the microjet reactor system, three different nanoparticle formulations were prepared using fenofibrate as model drug. Fenofibrate nanoparticles stabilized with poloxamer 407 (FN), fenofibrate nanoparticles in hydroxypropyl methyl cellulose phthalate (HPMCP) matrix (FHN) and fenofibrate nanoparticles in HPMCP and chitosan matrix (FHCN) were prepared under controlled precipitation using MicroJet reactor technology. Particle sizes of all the nanoparticle formulations were adjusted to 200-250 nm. rnThe changes in the experimental parameters altered the system thermodynamics resulting in the production of nanoparticles between 20-1000 nm (PDI<0.2) with high drug loading efficiencies (96.5% in 20:1 polymer:drug ratio).rnDrug releases from all nanoparticle formulations were fast and complete after 15 minutes both in FaSSIF and FeSSIF medium whereas in mucodhesiveness tests, only FHCN formulation was found to be mucoadhesive. Results of the Caco-2 studies revealed that % dose absorbed values were significantly higher (p<0.01) for FHCN in both cases where FaSSIF and FeSSIF were used as transport buffer.rn