Sulfur isotope analysis of aerosol particles by NanoSIMS

A new method to measure the sulfur isotopic composition of individual aerosol particles by NanoSIMS has been developed and tested on several standards such as barite (BaSO4), anhydrite (CaSO4), gypsum (CaSO4·2H2O), mascagnite ((NH4)2SO4), epsomite (MgSO4·7H2O), magnesium sulfate (MgSO4·xH2O), thenardite (Na2SO4), boetite (K2SO4) and cysteine (an amino acid). This ion microprobe technique employs a Cs+ primary ion beam and measures negative secondary ions permitting the analysis of sulfur isotope ratios in individual aerosol particles down to 500 nm in size (0.001-0.5 ng of sample material). The grain-to-grain reproducibility of measurements is typically 5‰ (1σ) for micron-sized grains, <5‰ for submicron-sized grains, and <2‰ for polished thin sections and ultra microtome sections which were studied for comparison. The role of chemical omposition (matrix effect) and sample preparation techniques on the instrumental mass fractionation (IMF) of the 34S/32S ratio in the NanoSIMS has been investigated. The IMF varies by ~15‰ between the standards studied here. A good correlation between IMF and ionic radius of the cations in sulfates was observed. This permits to infer IMF corrections even for sulfates for which no isotope standards are available. The new technique allows to identify different types of primary and secondary sulfates based on their chemical composition and to measure their isotopic signature separately. It was applied to marine aerosol samples collected in Mace Head and urban aerosol samples collected in Mainz. It was shown that primary sulfate particles such as sulfate in NaCl or gypsum particles precipitated from ocean water retain the original isotopic signature of their source. The isotopic composition of secondary sulfate depends on the isotopic composition of precursor SO2 and the oxidation pathway. The 34S/32S fractionation with respect to the precursor SO2 is -9‰ for homogeneous oxidation and +16.5‰ for heterogeneous oxidation. This large difference between the isotopic fractionation of both pathways allows identifying the oxidation pathway from which the SO42- in a secondary sulfate particle is derived, by means of its sulfur isotope ratio, provided that the isotopic signature of the precursor SO2 is known. The isotopic composition of the precursor SO2 of secondary sulfates was calculated based on the isotopic composition of particles with known oxidation pathway such as fine mode ammonium sulfate.

Iodine speciation in atmospheric aerosols in the marine boundary layer

Iodine chemistry plays an important role in the tropospheric ozone depletion and the new particle formation in the Marine Boundary Layer (MBL). The sources, reaction pathways, and the sinks of iodine are investigated using lab experiments and field observations. The aims of this work are, firstly, to develop analytical methods for iodine measurements of marine aerosol samples especially for iodine speciation in the soluble iodine; secondly, to apply the analytical methods in field collected aerosol samples, and to estimate the characteristics of aerosol iodine in the MBL. Inductively Coupled Plasma – Mass Spectrometry (ICP-MS) was the technique used for iodine measurements. Offline methods using water extraction and Tetra-methyl-ammonium-hydroxide (TMAH) extraction were applied to measure total soluble iodine (TSI) and total insoluble iodine (TII) in the marine aerosol samples. External standard calibration and isotope dilution analysis (IDA) were both conducted for iodine quantification and the limits of detection (LODs) were both 0.1 μg L-1 for TSI and TII measurements. Online couplings of Ion Chromatography (IC)-ICP-MS and Gel electrophoresis (GE)-ICP-MS were both developed for soluble iodine speciation. Anion exchange columns were adopted for IC-ICP-MS systems. Iodide, iodate, and unknown signal(s) were observed in these methods. Iodide and iodate were separated successfully and the LODs were 0.1 and 0.5 μg L-1, respectively. Unknown signals were soluble organic iodine species (SOI) and quantified by the calibration curve of iodide, but not clearly identified and quantified yet. These analytical methods were all applied to the iodine measurements of marine aerosol samples from the worldwide filed campaigns. The TSI and TII concentrations (medians) in PM2.5 were found to be 240.87 pmol m-3 and 105.37 pmol m-3 at Mace Head, west coast of Ireland, as well as 119.10 pmol m-3 and 97.88 pmol m-3 in the cruise campaign over the North Atlantic Ocean, during June – July 2006. Inorganic iodine, namely iodide and iodate, was the minor iodine fraction in both campaigns, accounting for 7.3% (median) and 5.8% (median) in PM2.5 iodine at Mace Head and over the North Atlantic Ocean, respectively. Iodide concentrations were higher than iodate in most of the samples. In the contrast, more than 90% of TSI was SOI and the SOI concentration was correlated significantly with the iodide concentration. The correlation coefficients (R2) were both higher than 0.5 at Mace Head and in the first leg of the cruise. Size fractionated aerosol samples collected by 5 stage Berner impactor cascade sampler showed similar proportions of inorganic and organic iodine. Significant correlations were obtained in the particle size ranges of 0.25 – 0.71 μm and 0.71 – 2.0 μm between SOI and iodide, and better correlations were found in sunny days. TSI and iodide existed mainly in fine particle size range (< 2.0 μm) and iodate resided in coarse range (2.0 – 10 μm). Aerosol iodine was suggested to be related to the primary iodine release in the tidal zone. Natural meteorological conditions such as solar radiation, raining etc were observed to have influence on the aerosol iodine. During the ship campaign over the North Atlantic Ocean (January – February 2007), the TSI concentrations (medians) ranged 35.14 – 60.63 pmol m-3 among the 5 stages. Likewise, SOI was found to be the most abundant iodine fraction in TSI with a median of 98.6%. Significant correlation also presented between SOI and iodide in the size range of 2.0 – 5.9 μm. Higher iodate concentration was again found in the higher particle size range, similar to that at Mace Head. Airmass transport from the biogenic bloom region and the Antarctic ice front sector was observed to play an important role in aerosol iodine enhancement. The TSI concentrations observed along the 30,000 km long cruise round trip from East Asia to Antarctica during November 2005 – March 2006 were much lower than in the other campaigns, with a median of 6.51 pmol m-3. Approximately 70% of the TSI was SOI on average. The abundances of inorganic iodine including iodine and iodide were less than 30% of TSI. The median value of iodide was 1.49 pmol m-3, which was more than four fold higher than that of iodate (median, 0.28 pmol m-3). Spatial variation indicated highest aerosol iodine appearing in the tropical area. Iodine level was considerably lower in coastal Antarctica with the TSI median of 3.22 pmol m-3. However, airmass transport from the ice front sector was correlated with the enhance TSI level, suggesting the unrevealed source of iodine in the polar region. In addition, significant correlation between SOI and iodide was also shown in this campaign. A global distribution in aerosol was shown in the field campaigns in this work. SOI was verified globally ubiquitous due to the presence in the different sampling locations and its high proportion in TSI in the marine aerosols. The correlations between SOI and iodide were obtained not only in different locations but also in different seasons, implying the possible mechanism of iodide production through SOI decomposition. Nevertheless, future studies are needed for improving the current understanding of iodine chemistry in the MBL (e.g. SOI identification and quantification as well as the update modeling involving organic matters).

Characterization of primary biogenic aerosol particles by DNA analysis: Diversity of airborne Ascomycota and Basidiomycota

Primary biogenic aerosol (PBA) particles account for large proportions of air particulate matter, and they can influence the hydrological cycle and climate as nuclei for water droplets and ice crystals in clouds, fog, and precipitation. Moreover, they can cause or enhance human, animal, and plant diseases. The actual abundance and properties of PBA particles and components in the atmosphere are, however, still poorly understood and quantified. rnIn this study, the identity, diversity, and frequency of occurrence of PBA particles were investigated by DNA analysis. Methods for the extraction, amplification, and analysis of DNA from aerosol filter samples were developed and optimized for different types of organisms, including fungi, bacteria, and plants. The investigations were focused on fungal DNA, and over 2500 sequences were obtained from air samples collected at different locations and climatic zones around the world (tropical, mid-latitude, sub-polar; continental, marine). rnNearly all fungal DNA sequences could be attributed to the phyla of Ascomycota and Basidiomycota. With regard to species richness, the ratio of Basidiomycota to Ascomycota was much higher in continental air samples (~60:40) than in marine air samples (~30:70). Pronounced differences in the relative abundance and seasonal cycles of various groups of fungi were detected in coarse and fine particulate matter from continental air, with more plant pathogens in the coarse and more human pathogens and allergens in the respirable fine particle fraction (<3 µm). The results of this study provide new information and insights into the sources of PBA particles and the interactions of the biosphere with the atmosphere, climate, and public health. rn

Isolation and characterization of a manganese oxidizing bacterium from the Mediterranean marine sponge Suberites domuncula

In the present study of sponge-bacterial association, the presence of a marine bacterium which has not seen to be associated previously with the Mediterranean sponge Suberites domuncula was investigated. The marine sponge S. domuncula was chosen as the subject of investigation, for the identification of potential symbiotic microorganisms, since it can be kept under controlled laboratory conditions for over five years. By the use of specialized media assisting in the growth of a metal oxidizing bacterium, the manganese oxidizing bacterium was isolated from the surface of the marine sponge. The bacterium so isolated was characterized for its growth characteristics by microbiological and biochemical techniques, a detailed analysis of which showed that the bacterium followed a life cycle where the culture showed the presence of spore forming bacteria. This was correlated to the manganese oxidation activity of the bacteria and it was found that both stages are interdependent.The action of the protein responsible for carrying out the manganese (Mn) oxidation was studied by an in-gel oxidation assay, and the presence of a multi copper oxidase was confirmed by the use of copper chelators in the buffer. In parallel the effect of addition of copper was observed on the manganese oxidation by the bacteria thus supporting the observations. The manganese oxidation reaction by the bacteria was determined in the culture medium and on the surface of the cells, and it could be concluded that the oxidation was facilitated by the presence of the polysaccharides and proteins on the surface of the cells.Thus the presence of a bacterium capable of oxidizing the manganese from the surroundings was confirmed to be symbiotically associated with the marine sponge S. domuncula by monitoring its growth in axenic cultures. The reasons behind this association were studied.This bacterium displays a crucial role in the physiology/metabolism of the sponge by acting as a reversible Mn store in S. domuncula. According to this view, the presence of SubDo-03 bacteria is required as a protection against higher, toxic concentrations of Mn in the environment; manganese (II) after undergoing oxidation to manganese (IV), becomes an insoluble ion. Since only minute levels of manganese exist in the surrounding seawater a substantial accumulation of manganese has to arise, or a release by the bacterial-precipitated manganese (IV) is implicated to maintain the reversible balance. The other possible benefits provided by the bacterial association to the sponge could be in preventing cellular oxygen toxicity, help in nutrient scavenging and detoxification.

The reconstruction of paleoclimate variability in Northern Germany, during marine isotope stage 5

In order to obtain a better understanding about the influence of post-depositional diagenesis on speleothem 230Th/U-ages and paleoclimate variability during Marine Isotope Stage (MIS) 5 in northern Germany, four stalagmites from the Riesenberghöhle (RBH) were investigated by thin section analysis, 230Th/U-dating as well as stable oxygen and carbon isotope and laser ablation inductively coupled mass spectrometry (LA-ICPMS) trace element analysis. The RBH is located in the Weser Hills and is one of the northernmost limestone caves in Germany.rnMulti collector (MC) ICPMS 230Th/U-ages and thin section analysis of the RBH stalagmites shows that some growth phases of the stalagmites were diagenetically altered after their deposition. The impact of post-depositional diagenesis (PDD) on the 230Th/U-ages is modeled, and potential processes leading to PDD are discussed. In this context, it is suggested that PDD may be induced by rapid climate change at the inception of the GIS.rnDespite of the dating uncertainties resulting from PDD, 230Th/U-dating shows that the RBH stalagmites grew during the Eemian and most of the Greenland Interstadials (GIS) during MIS 5. Thus, the growth phases of the RBH stalagmites might be related to a reorganization of the Atlantic Meridional Overturning Circulation (AMOC). The stable isotope (δ13C and δ18O) and the trace element variability of the stalagmites reflects rapid changes of past temperature and precipitation on millennial and sub-millennial timescales. These past climate changes can be amplified by orbitally forced variations of the July solar insolation at 65°N.