Ectomycorrhizae of sessile oak (Quercus petraea (Matt.) Liebl.)

Investigations were performed during the years 1999 to 2001 on a limed and unlimed plot within a high-elevated sessile oak forest. The oak forest (with 90 years old European beech at the understorey) was 170 to 197 years old. It is located at forest district Merzalben, location 04/0705, which is situated in the Palatinate Forest in south-west Germany. Liming was performed in December 1988 when 6 tons/ha of powdered Dolomite were brought up by the forestry department. Liming was performed to counteract the effects of soil acidification (pH(H2O) at Horizon A (0-10 cm): 3.9), which is induced by long-term (anthropogenic) acidic cloud cover and precipitation. Potentially toxic Al3+ ions, which become solubilized below pH 5, were suspected to be responsible for forest dieback and sudden death of the mature oaks. The most logical entry point for these toxic ions was suspected to occur in the highly absorptive region of the ectomycorrhizae (fungal covered root tips). However, the diversity and abundance of oak-ectomycorrhizal species and their actual roles in aluminum translocation (or blockage) were unknown. It was hypothesized that the ectomycorrhizae of sessile oaks in a limed forest would exhibit greater seasonal diversity and abundance with less evidence of incorporated aluminum than similar oak ectomycorrhizae from unlimed soils. To test this hypothesis, 12 oaks in the limed plot and 12 in an adjacent unlimed plot were selected. Each spring and fall for 2 years (1999 & 2000), 2 sets of soil cylinders (9.9 cm dia.) were extracted from Horizon A (0-10 cm), Horizon B (30-40 cm) and Horizon C (50-60 cm depth) at a distance of 1 meter from each tree base. Roots were extracted from each probe by gentle sieving and rinsing. Soil samples were retained for pH (H2O, CaCl2, and KCl) and moisture analysis. One set of roots was sorted by size and air-dried for biomass analysis. The finest mycorrhizal roots of this set were used for bound and unbound (cytosolic) mineral [Al, Ca, Mg, K, Na, Mn, S, Zn, Fe, Cd and Pb] analysis (by Landwirtschaftliche Untersuchungs- und Forschungsanstalt Rheinland Palatinate (LUFA)). Within 7 days of collection, the mycorrhizal tips from the second set of probes were excised, sorted, identified (using Agerer’s Color Atlas), counted and weighed. Seasonal diversity and abundance was characterized for 50 of the 93 isolates. The location and relative abundance of Al within the fungal and root cell walls was characterized for 68 species using 0.01% Morin dye and fluorescence microscopy. Morin complexes with Al to produce an intense yellow fluorescence. The 4 most common species (Cenococcum geophilum, Quercirhiza fibulocsytidiata, Lactarius subdulcis, Piceirhiza chordata) were prepared for bound Al, Ca, Fe and K mineral analysis by LUFA. The unlimed and limed plots were then compared. Only 46 of the 93 isolated ectomycorrhizal species had been previously associated with oaks in the literature. Mycorrhizal biomass was most abundant in Horizon A, declining with depth, drought and progressive soil acidification. Mycorrhizae were most diverse (32 species) in the limed plot, but individual species abundance was low (R Selection) in comparison to the unlimed plot, where there were fewer species (24) but each species present was abundant (K Selection). Liming increased diversity and altered dominance hierarchy, seasonal distributions and succession trends of ectomycorrhizae at all depths. Despite an expected reduction in Al content, the limed ectomycorrhizae both qualitatively (fluorescence analysis) and quantitatively (mineral analysis) contained more bound Al, especially so in Horizon A. The Al content qualitatively and quantitatively increased with depth in the unlimed and limed plots. The bound Al content fluctuated between 4000-and 20000 ppm while the unbound component was consistently lower (4 -14 ppm). The relative amount of unbound Al declined upon liming implying less availability for translocation to the crown area of the trees. This correspouds with the findings of good crown appearance and lower tree mortality in the limed zone. Each ectomycorrhizal species was unique in its ability to block, sequester (hold) or translocate Aluminum. In several species, Al uptake varied with changes in moisture, pH, depth and liming. According to the fluorescence study, about 48% of the isolated ectomycorrhizal species blocked and/or sequestered (held) Al in their mantle and/or Hartig net walls, qualitatively lowering bound Al in the adjacent root cell walls. Generally, if Al was more concentrated in the fungal walls, it was less evident in the cortex and xylem and conversely, if Al was low or absent from the fungal walls it was frequently more evident in the cortex and xylem.

Investigation of the nuclear matter density distributions of the exotic 12 Be, 14 Be and 8 B nuclei by elastic proton scattering in inverse kinematics

The proton-nucleus elastic scattering at intermediate energies is a well-established method for the investigation of the nuclear matter distribution in stable nuclei and was recently applied also for the investigation of radioactive nuclei using the method of inverse kinematics. In the current experiment, the differential cross sections for proton elastic scattering on the isotopes $^{7,9,10,11,12,14}$Be and $^8$B were measured. The experiment was performed using the fragment separator at GSI, Darmstadt to produce the radioactive beams. The main part of the experimental setup was the time projection ionization chamber IKAR which was simultaneously used as hydrogen target and a detector for the recoil protons. Auxiliary detectors for projectile tracking and isotope identification were also installed. As results from the experiment, the absolute differential cross sections d$sigma$/d$t$ as a function of the four momentum transfer $t$ were obtained. In this work the differential cross sections for elastic p-$^{12}$Be, p-$^{14}$Be and p-$^{8}$B scattering at low $t$ ($t leq$~0.05~(GeV/c)$^2$) are presented. The measured cross sections were analyzed within the Glauber multiple-scattering theory using different density parameterizations, and the nuclear matter density distributions and radii of the investigated isotopes were determined. The analysis of the differential cross section for the isotope $^{14}$Be shows that a good description of the experimental data is obtained when density distributions consisting of separate core and halo components are used. The determined {it rms} matter radius is $3.11 pm 0.04 pm 0.13$~fm. In the case of the $^{12}$Be nucleus the results showed an extended matter distribution as well. For this nucleus a matter radius of $2.82 pm 0.03 pm 0.12$~fm was determined. An interesting result is that the free $^{12}$Be nucleus behaves differently from the core of $^{14}$Be and is much more extended than it. The data were also compared with theoretical densities calculated within the FMD and the few-body models. In the case of $^{14}$Be, the calculated cross sections describe the experimental data well while, in the case of $^{12}$Be there are discrepancies in the region of high momentum transfer. Preliminary experimental results for the isotope $^8$B are also presented. An extended matter distribution was obtained (though much more compact as compared to the neutron halos). A proton halo structure was observed for the first time with the proton elastic scattering method. The deduced matter radius is $2.60pm 0.02pm 0.26$~fm. The data were compared with microscopic calculations in the frame of the FMD model and reasonable agreement was observed. The results obtained in the present analysis are in most cases consistent with the previous experimental studies of the same isotopes with different experimental methods (total interaction and reaction cross section measurements, momentum distribution measurements). For future investigation of the structure of exotic nuclei a universal detector system EXL is being developed. It will be installed at the NESR at the future FAIR facility where higher intensity beams of radioactive ions are expected. The usage of storage ring techniques provides high luminosity and low background experimental conditions. Results from the feasibility studies of the EXL detector setup, performed at the present ESR storage ring, are presented.

New design of polyphenylene dendrimers for full-color light-emitting diodes

Dendritic systems, and in particular polyphenylene dendrimers, have recently attracted considerable attention from the synthetic organic chemistry community, as well as from photophysicists, particularly in view of the search for synthetic model analogies to photoelectric materials to fabricate organic light-emitting diodes (OLEDs), and even more advanced areas of research such as light-harvesting system, energy transfer and non-host device. Geometrically, dendrimers are unique systems that consist of a core, one or more dendrons, and surface groups. The different parts of the macromolecule can be selected to give the desired optoelectronic and processing properties. Compared to small molecular or polymeric light-emitting materials, these dendritic materials can combine the benefits of both previous classes. The high molecular weights of these dendritic macromolecules, as well as the surface groups often attached to the distal ends of the dendrons, can improve the solution processability, and thus can be deposited from solution by simple processes such as spin-coating and ink-jet printing. Moreover, even better than the traditional polymeric light-emitting materials, the well-defined monodisperse distributed dendrimers possess a high purity comparable to that of small molecules, and as such can be fabricated into high performance OLEDs. Most importantly, the emissive chromophores can be located at the core of the dendrimer, within the dendrons, and/or at the surface of the dendrimers because of their unique dendritic architectures. The different parts of the macromolecule can be selected to give the desired optoelectronic and processing properties. Therefore, the main goals of this thesis are the design and synthesis, characterization of novel functional dendrimers, e.g. polytriphenylene dendrimers for blue fluorescent, as well as iridium(III) complex cored polyphenylene dendrimers for green and red phosphorescent light emitting diodes. In additional to the above mentioned advantages of dendrimer based OLEDs, the modular molecular architecture and various functionalized units at different locations in polyphenylene dendrimers open up a tremendous scope for tuning a wide range of properties in addition to color, such as intermolecular interactions, charge mobility, quantum yield, and exciton diffusion. In conclusion, research into dendrimer containing OLEDs combines fundamental aspects of organic semiconductor physics, novel and highly sophisticated organic synthetic chemistry and elaborate device technology.rn