Confocal microscopy applied to the study of single entity fluorescence and light scattering

A sample scanning confocal optical microscope (SCOM) was designed and constructed in order to perform local measurements of fluorescence, light scattering and Raman scattering. This instrument allows to measure time resolved fluorescence, Raman scattering and light scattering from the same diffraction limited spot. Fluorescence from single molecules and light scattering from metallic nanoparticles can be studied. First, the electric field distribution in the focus of the SCOM was modelled. This enables the design of illumination modes for different purposes, such as the determination of the three-dimensional orientation of single chromophores. Second, a method for the calculation of the de-excitation rates of a chromophore was presented. This permits to compare different detection schemes and experimental geometries in order to optimize the collection of fluorescence photons. Both methods were combined to calculate the SCOM fluorescence signal of a chromophore in a general layered system. The fluorescence excitation and emission of single molecules through a thin gold film was investigated experimentally and modelled. It was demonstrated that, due to the mediation of surface plasmons, single molecule fluorescence near a thin gold film can be excited and detected with an epi-illumination scheme through the film. Single molecule fluorescence as close as 15nm to the gold film was studied in this manner. The fluorescence dynamics (fluorescence blinking and excited state lifetime) of single molecules was studied in the presence and in the absence of a nearby gold film in order to investigate the influence of the metal on the electronic transition rates. The trace-histogram and the autocorrelation methods for the analysis of single molecule fluorescence blinking were presented and compared via the analysis of Monte-Carlo simulated data. The nearby gold influences the total decay rate in agreement to theory. The gold presence produced no influence on the ISC rate from the excited state to the triplet but increased by a factor of 2 the transition rate from the triplet to the singlet ground state. The photoluminescence blinking of Zn0.42Cd0.58Se QDs on glass and ITO substrates was investigated experimentally as a function of the excitation power (P) and modelled via Monte-Carlo simulations. At low P, it was observed that the probability of a certain on- or off-time follows a negative power-law with exponent near to 1.6. As P increased, the on-time fraction reduced on both substrates whereas the off-times did not change. A weak residual memory effect between consecutive on-times and consecutive off-times was observed but not between an on-time and the adjacent off-time. All of this suggests the presence of two independent mechanisms governing the lifetimes of the on- and off-states. The simulated data showed Poisson-distributed off- and on-intensities, demonstrating that the observed non-Poissonian on-intensity distribution of the QDs is not a product of the underlying power-law probability and that the blinking of QDs occurs between a non-emitting off-state and a distribution of emitting on-states with different intensities. All the experimentally observed photo-induced effects could be accounted for by introducing a characteristic lifetime tPI of the on-state in the simulations. The QDs on glass presented a tPI proportional to P-1 suggesting the presence of a one-photon process. Light scattering images and spectra of colloidal and C-shaped gold nano-particles were acquired. The minimum size of a metallic scatterer detectable with the SCOM lies around 20 nm.

Regulation der Zeaxanthin- und der Diatoxanthin-Epoxidase in Chlorophyll a/b- und Fucoxanthin-Chlorophyll a/c-haltigen Pflanzen

In der vorliegenden Arbeit wird der Vx-Zyklus und der Ddx-Zyklus unterschiedlicher Pflanzen hinsichtlich ihrer Regulation untersucht. Es konnte an Hand von in vivo Messungen gezeigt werden, dass bei zwei Kieselalgen unterschiedlicher Ordnung (Pennales bzw. Centrales) und einer Haptophyte mit Ddx-Zyklus die Dtx-Epoxidase delta-pH-reguliert ist. Im Gegensatz dazu steht die nicht-regulierte Zx-Epoxidase des Vx-Zyklus einer Raphidophyceae, einer Grünalge und einer aquatischen Höheren Pflanze. Es konnte gezeigt werden, dass der Grund für diese unterschiedliche Regulation der beiden Epoxidasen die verschiedenen Quench-Eigenschaften der Pigmente Dtx bzw. Zx ist. Durch parallele Messungen des NPQ und des De-Epoxidierungsgrads wurde deutlich, dass Zx zum Aufbau eines Quenching direkt den im Licht aufgebauten delta-pH benötigt, während Dtx alleine ausreichend ist, um ein Quenching zu verursachen. Bei diesen in vivo Messungen wurde außerdem deutlich, dass die Aktivitäten der untersuchten Epoxidasen große Unterschiede aufweisen. Diese sind abhängig von der entsprechenden Pigmentierung des jeweiligen Lichtsammelsystems, stehen also in Zusammenhang mit den Carotinoidbiosynthesen. Es konnte gezeigt werden, dass bei allen untersuchten Organismen, die eine Xanthophyll-dominierte Antenne mit Fx als Massenpigment enthielten, die Umsatzraten der Epoxidase sehr hoch waren, im Gegensatz zu Chl-dominierten Antennen. Nach diesen Erkenntnissen wurde die Dtx-Epoxidase weiter untersucht und so erstmalig durch Western-Blotting identifiziert. Es ergaben sich, allerdings erst nach zusätzlicher Proteinstabilisierung, zwei Signale, eins bei 60 kDa, das andere bei 57 kDa. Hierbei ist nach wie vor unklar, warum das Antiserum zwei Signale lieferte und ob es sich dabei um Isoformen, um anderweitige Modifizierungen, oder um eine Kreuzreaktion handelt. Auch der Mechanismus der delta-pH-Regulation der Dtx-Epoxidase konnte trotz in vivo und in vitro durchgeführter Studien nicht endgültig geklärt werden. Allerdings konnten verschiedene Mechanismen, wie z.B. eine direkte pH-Abhängigkeit des Enzyms, eine Regulation durch Reduktion und Oxidation oder durch Phosphorylierung und Dephosphorylierung, auf Grund der Daten falsifiziert werden. Es konnte schließlich die Regulation mit Hilfe eines transmembranen Rezeptors als das einzige, mit allen Daten konsistente Regulationsmodell vorgeschlagen werden.

C 3-symmetric discotic liquid crystalline materials for molecular electronics: versatile synthesis and self-organization

This thesis presents the versatile synthesis and self-organization of C3-symmetric discotic nanographene molecules as well as their potential applications as materials in molecular electronics. The details can be described as follows: 1) A novel synthetic strategy towards properly designed C3 symmetric 1,3,5-tris-2’arylbenzene precursors has been developed. After the final planarization by treatment with FeCl3 under mild conditions, for the first time, it became possible to access a variety of new C3-symmetric hexa-peri-hexabenzocoronenes (HBCs) and a series of triangle-shaped nanographenes. D3 symmetric HBC with three alkyl substituents and C2 symmetric HBC with two alkyl substituents were synthesized and found to show the surprising decrease of isotropic points., the self-assembly at the liquid-solid interface displayed a unique zigzag and flower patterns. 2) Triangle-shaped discotics revealed a unique self-assembly behavior in solution, solid state as well as at the solution-substrate interface. A mesophase stability over the broad temperature range with helical supramoelcular arrangement were observed in the bulk state. The honeycomb pattern as the result of novel self-assembly was presented. Triangle-shaped discotics with swallow alkyl tails were fabricated into photovoltaic devices, the supramolecular arrangement upon thermal treatment was found to play a key role in the improvement of solar efficiency. 3) A novel class of C3 symmetric HBCs with alternating polar/apolar substituents was synthesized. Their peculiar self-assembly in solution, in the bulk and on the surface were investigated by NMR techniques, X-ray diffraction as well as different electron microscope techniques. 4) A novel concept for manipulating the intracolumnar stacking of discotics and thus for controlling the helical pitch was presented. A unique staggered stacking in the column was achieved for the first time. Theoretical simulations confirmed this self-organization and predicted that this packing should show the highest charge carrier mobility for all discotics.