Untersuchung der Filmbildung aus Polymerdispersionen mit Hilfe der forcierten Rayleighstreuung

Der Filmbildungsprozess wässriger Polymerdispersionen wurde mit forcierter Rayleighstreuung untersucht.Diffusionskoeffizienten D von Farbstoffsonden sind damit zwischen 10^-21 und 10^-9 m^2s^-1 zugänglich. Das Diffusionsverhalten der hydrophoben FarbstoffsondeAberchrome in feuchten und trockenen Filmen aus Poly(n-butylmethacrylat-co-acrylsäure)-Dispersionen sowie bei der Wiederbefeuchtung trockener Filme wurde untersucht.Die Dynamik von Aberchrome weicht in feuchten Filmen von Fickscher Diffusion ab. Dies äußert sich in Abweichungen vomcharakteristischen q^2-Verhalten der Relaxationsrate tau^-1 (tau^-1 = Dq^2; q:Streuvektor) und im Auftreten gestrecktexponentieller Intensitätsrelaxationskurven. Diese Anomalie wurde mit einem apparenten, längenskalenabhängigen Diffusionskoeffizienten Dapp(Lambda) (Lambda= 2Pi/q) beschrieben, der für Lambda -> 0 Werte annimmt, die einem homogen hydroplastifizierten Polymermaterial entsprechen, während Dapp(Lambda) für Lambda -> Unendlich stark anwächst. Diese Anomalien verschwinden bei Wassergehalten entsprechend der Polymerwasserlöslichkeit. Weiteres Trocknen führt zum Absinken des Fickschen-Diffusionskoeffizienten auf einen Grenzwert für trockene Filme. Die Ergebnisse konnten mit einem Zwei-Zustands-Modell beschrieben werden: Die Sonde diffundiert Ficksch in einer hydrophilen Grenzflächenphase und einer langsamen Polymerphase. Austausch zwischendiesen Phasen ist ohne Einschränkung möglich. Das Modell erlaubt die Quantifizierung des Einflusses des Trocknungsprozesses auf Polymer- und Grenzflächenphaseneigenschaften.Dies wurde durch systematische Veränderungen der Grenzflächeneigenschaften demonstriert. Dies geschah durch Acrylsäuregehaltvariationen in den Poly(n-butylmethacrylat-co-acrylsäure)-Dispersionen und Emulgatorbedeckungsgradvariationen. In beiden Fällen reflektieren sich Dispersionsveränderungen in einer Veränderung der Modellparameter in der Grenzflächenphase.

Grazing incidence pumped Zr x-ray laser for spectroscopy on Li-like ions

X-ray laser fluorescence spectroscopy of the 2s-2p transition in Li-like ions is promising to become a widely applicable tool to provide information on the nuclear charge radii of stable and radioactive isotopes. For performing such experiments at the Experimental Storage Ring ESR, and the future NESR within the FAIR Project, a grazing incidence pumped (GRIP) x-ray laser (XRL) was set up at GSI Darmstadt using PHELIX (Petawatt High Energy Laser for heavy Ions eXperiments). The experiments demonstrated that lasing using the GRIP geometry could be achieved with relatively low pump energy, a prerequisite for higher repetition rate. In the first chapter the need of a plasma XRL is motivated and a short history of the plasma XRL is presented. The distinctive characteristic of the GRIP method is the controlled deposition of the pump laser energy into the desired plasma density region. While up to now the analysis performed were mostly concerned with the plasma density at the turning point of the main pump pulse, in this thesis it is demonstrated that also the energy deposition is significantly modified for the GRIP method, being sensitive in different ways to a large number of parameters. In the second chapter, the theoretical description of the plasma evolution, active medium and XRL emission properties are reviewed. In addition an innovative analysis of the laser absorption in plasma which includes an inverse Bremsstrahlung (IB) correction factor is presented. The third chapter gives an overview of the experimental set-up and diagnostics, providing an analytical formula for the average and instantaneous traveling wave speed generated with a tilted, on-axis spherical mirror, the only focusing system used up to now in GRIP XRL. The fourth chapter describes the experimental optimization and results. The emphasis is on the effect of the incidence angle of the main pump pulse on the absorption in plasma and on output and gain in different lasing lines. This is compared to the theoretical results for two different incidence angles. Significant corrections for the temperature evolution during the main pump pulse due to the incidence angle are demonstrated in comparison to a simple analytical model which does not take into account the pumping geometry. A much better agreement is reached by the model developed in this thesis. An interesting result is also the appearance of a central dip in the spatially resolved keV emission which was observed in the XRL experiments for the first time and correlates well with previous near field imaging and plasma density profile measurements. In the conclusion also an outlook to the generation of shorter wavelength XRL’s is given.

Nuclear charge radius of the halo nucleus lithium-11

Nuclear charge radii of short-lived isotopes can be probed in a nuclear-model independent way via isotope shift measurements. For this purpose a novel technique was developed at GSI, Darmstadt. It combines two-photon laser spectroscopy in the 2s-3s electronic transition of lithium, resonance ionization, and detection via quadrupole mass spectrometry. In this way an accuracy of 5e-5 which is necessary for the extraction of nuclear charge radii, and an overall detection efficiency of 1e-4 is reached. This allowed an isotope shift measurement of Li-11 for the first time at the TRIUMF facility in Vancouver. Additionally, uncertainties in the isotope shift for all other lithium isotopes were reduced by about a factor of four compared to previous measurements at GSI. Results were combined with recent theoretical mass shift calculations in three-electron systems and root-mean-square nuclear charge radii of all lithium isotopes, particulary of the two-neutron halo nucleus Li-11, were determined. Obtained charge radii decrease continuously from Li-6 to Li-9, while a strong increase between Li-9 and Li-11 is observed. This is compared to predictions of various nuclear models and it is found that a multicluster model gives the best overall agreement. Within this model, the increase in charge radius between Li-9 and Li-11is to a large extend caused by intrinsic excitation of the Li-9-like core while the neutron-halo correlation contributes only to a small extend.

Nuclear charge radii of light isotopes based on frequency comb measurements

Optical frequency comb technology has been used in this work for the first time to investigate the nuclear structure of light radioactive isotopes. Therefore, three laser systems were stabilized with different techniques to accurately known optical frequencies and used in two specialized experiments. Absolute transition frequency measurements of lithium and beryllium isotopes were performed with accuracy on the order of 10^(−10). Such a high accuracy is required for the light elements since the nuclear volume effect has only a 10^(−9) contribution to the total transition frequency. For beryllium, the isotope shift was determined with an accuracy that is sufficient to extract information about the proton distribution inside the nucleus. A Doppler-free two-photon spectroscopy on the stable lithium isotopes (6,7)^Li was performed in order to determine the absolute frequency of the 2S → 3S transition. The achieved relative accuracy of 2×10^(−10) is improved by one order of magnitude compared to previous measurements. The results provide an opportunity to determine the nuclear charge radius of the stable and short-lived isotopes in a pure optical way but this requires an improvement of the theoretical calculations by two orders of magnitude. The second experiment presented here was performed at ISOLDE/CERN, where the absolute transition frequencies of the D1 and D2 lines in beryllium ions for the isotopes (7,9,10,11)^Be were measured with an accuracy of about 1 MHz. Therefore, an advanced collinear laser spectroscopy technique involving two counter-propagating frequency-stabilized laser beams with a known absolute frequency was developed. The extracted isotope shifts were combined with recent accurate mass shift calculations and the root-mean square nuclear charge radii of (7,10)^Be and the one-neutron halo nucleus 11^Be were determined. Obtained charge radii are decreasing from 7^Be to 10^Be and increasing again for 11^Be. While the monotone decrease can be explained by a nucleon clustering inside the nucleus, the pronounced increase between 10^Be and 11^Be can be interpreted as a combination of two contributions: the center-of-mass motion of the 10^Be core and a change of intrinsic structure of the core. To disentangle these two contributions, the results from nuclear reaction measurements were used and indicate that the center-of-mass motion is the dominant effect. Additionally, the splitting isotope shift, i.e. the difference in the isotope shifts between the D1 and D2 fine structure transitions, was determined. This shows a good consistency with the theoretical calculations and provides a valuable check of the beryllium experiment.

Synthese von Sialyl-Lewis-X-Mimetika durch stereoselektive ortho-C-Glycosylierung von Phenolen

Ziel der Arbeit war es, Sialyl-LewisX-Mimetika auf Basis ortho-C-glycosylierter Phenole als Inhibitoren für die Selektin-Ligand-Wechselwirkungen zu synthetisieren. Dazu wurde zunächst die Stereoselektivität der ortho-C-Mannosylierung untersucht. Dabei wurde gezeigt, dass bei der Umsetzung von Phenolen mit dem benzylgeschützten Mannosyl-trichloracetimidat in Gegenwart von TMSOTf selektiv das β-C-Mannosid erhalten wurde. Gleichzeitig konnte anhand der NMR-spektroskopischen Untersuchungen nachgewiesen werden, dass die in der Literatur beschriebenen α-C-Mannoside von Phenolen tatsächlich β-konfiguriert sind. Wenn Naphthole als Glycosylakzeptoren verwendet wurden, konnten durch Modifikation des Promotors auch die für die Synthese der Mimetika benötigten α-C-Mannoside erhalten werden, wobei ZnCl2 als Promotor die besten Ergebnisse lieferte. Allerdings zeigten die synthetisierten α-C-Mannoside und α-C-Galactoside eine Inversion des Pyranoseringes und lagen in der ungewöhnlichen 1C4-Konformation vor.rnAnschließend konnte auf diese Weise das durch Docking-Studien gefundene Mimetikum (2S)-3-Cyclohexyl-2-[7-hydroxy-8-(α-D-mannosyl)naphthalin-2-yloxy]propionsäure syntheti-siert werden. Es besaß jedoch in Zelladhäsionstests keine ausreichende Aktivität bei der Inhibierung der Selektin-Ligand-Wechselwirkung. Bei den ursprünglichen Dockingstudien war allerdings von der gewohnten 4C1-Konformation ausgegangen worden. Spätere NMR-Experimente und DFT-Berechnungen zeigten, dass das Mimetikum tatsächlich in der 1C4-Konformation vorlag und es deshalb nicht aktiv war. Die synthetisierten Stereo- und Regioisomere zeigten in Zelladhäsionstests ebenfalls keine Aktivität.rnVersuche, die α-1-C-Mannosylnaphthole zu den benötigten 1-C-2-O-Diglycosyl-naphthalinen umzusetzen waren nicht erfolgreich, da die phenolische OH-Gruppe sterisch zu sehr abgeschirmt war, um unter milden Reaktionsbedingungen glycosyliert zu werden, bzw. die α-1-C-Mannosylnaphthaline unter drastischeren Reaktionsbedingungen nicht stabil waren. Daher wurde 1-(2′,3′,4′,6′-Tetra-O-benzyl-β-D-galactopyranosyl)-2-naphthol mit 2,3,4,6-Tetra-O-acetyl-α-D-mannopyranosyl-trichloracetimidat in Gegenwart von TMSOTf zum ersten synthetischen 1-C-2-O-Diglycosyl-phenol umgesetzt. Nach Abspaltung der Schutzgruppen sollte das erhaltene 1-Galactosyl-2-O-mannosyl-naphthalin enzymatisch zum Sialyl-LewisX-Mimetikum verlängert werden. Es wurde vom Enzym jedoch nicht als Substrat erkannt. Versuche zur chemischen Anbindung des Säurebausteins stehen noch aus.rn

Production of antihydrogen via double charge exchange

Spectroscopy of the 1S-2S transition of antihydrogen confined in a neutral atom trap and comparison with the equivalent spectral line in hydrogen will provide an accurate test of CPT symmetry and the first one in a mixed baryon-lepton system. Also, with neutral antihydrogen atoms, the gravitational interaction between matter and antimatter can be tested unperturbed by the much stronger Coulomb forces.rnAntihydrogen is regularly produced at CERN's Antiproton Decelerator by three-body-recombination (TBR) of one antiproton and two positrons. The method requires injecting antiprotons into a cloud of positrons, which raises the average temperature of the antihydrogen atoms produced way above the typical 0.5 K trap depths of neutral atom traps. Therefore only very few antihydrogen atoms can be confined at a time. Precision measurements, like laser spectroscopy, will greatly benefit from larger numbers of simultaneously trapped antihydrogen atoms.rnTherefore, the ATRAP collaboration developed a different production method that has the potential to create much larger numbers of cold, trappable antihydrogen atoms. Positrons and antiprotons are stored and cooled in a Penning trap in close proximity. Laser excited cesium atoms collide with the positrons, forming Rydberg positronium, a bound state of an electron and a positron. The positronium atoms are no longer confined by the electric potentials of the Penning trap and some drift into the neighboring cloud of antiprotons where, in a second charge exchange collision, they form antihydrogen. The antiprotons remain at rest during the entire process, so much larger numbers of trappable antihydrogen atoms can be produced. Laser excitation is necessary to increase the efficiency of the process since the cross sections for charge-exchange collisions scale with the fourth power of the principal quantum number n.rnThis method, named double charge-exchange, was demonstrated by ATRAP in 2004. Since then, ATRAP constructed a new combined Penning Ioffe trap and a new laser system. The goal of this thesis was to implement the double charge-exchange method in this new apparatus and increase the number of antihydrogen atoms produced.rnCompared to our previous experiment, we could raise the numbers of positronium and antihydrogen atoms produced by two orders of magnitude. Most of this gain is due to the larger positron and antiproton plasmas available by now, but we could also achieve significant improvements in the efficiencies of the individual steps. We therefore showed that the double charge-exchange can produce comparable numbers of antihydrogen as the TBR method, but the fraction of cold, trappable atoms is expected to be much higher. Therefore this work is an important step towards precision measurements with trapped antihydrogen atoms.