Incapsulamento di complessi organometallici e lantanoidei con silice e sviluppo come traccianti di supporti ceramici

Lo scopo di questo lavoro di tesi sperimentale consiste nell’ideazione e nell’ottimizzazione di nuove forme d’ingegnerizzazione di sistemi nano e micrometrici di silice (SiO2) in cui sono stati incorporati complessi di metalli di transizione e lantanoidei. Lo studio è scaturito dalla prospettiva di poter trasferire le caratteristiche di luminescenza dei complessi dalla scala molecolare di sintesi a quella macroscopica, attraverso l’utilizzo di una opportuna matrice veicolante. Dopo una intensa sessione di lavoro dedicata all’ottimizzazione della sintesi e delle caratteristiche di stabilità e resistenza dei sistemi, dalla fase sol fino ai micronizzati, si è sviluppata una possibile applicazione industriale come substrato tessile dotato di funzioni eventualmente antibatteriche. This experimental work is aimed at exploiting and optimizing new and convenient ways to incorporate organometallic and lanthanoid complexes into silica-based colloid matrices. Following a similar approach, the luminescent properties of both organometallic and lanthanoid complexes could be kept unaltered on passing from the molecular to nanometric scale (sol), ending up to micrometer sized systems (micro-powders). The subsequent optimization of the processes led to systems that were loaded onto the surface of fabric, which were successively studied for their light-induced antimicrobial abilities.

Cure Induced Residual Stresses on Thick Composite Components Manufactured by Additive Process

This study investigates the effect of an additive process in manufacturing of thick composites. Airstone 780 E epoxy resin and 785H Hardener system is used in the analysis since it is widely used wind turbine blade, namely thick components. As a fiber, fabric by SAERTEX (812 g/m2) with a 0-90 degrees layup direction is used. Temperature overshoot is a major issue during the manufacturing of thick composites. A high temperature overshoot leads to an increase in residual stresses. These residual stresses are causing warping, delamination, dimensional instability, and undesired distortion of composite structures. A coupled thermo-mechanical model capable of predicting cure induced residual stresses have been built using the commercial FE software Abaqus®. The possibility of building thick composite components by means of adding a finite number of sub-laminates has been investigated. The results have been compared against components manufactured following a standard route. The influence of pre-curing of the sub-laminates has also been addressed and results compared with standard practice. As a result of the study, it is found that introducing additive process can prevent temperature overshoot to occur and benefits the residual stresses generation during the curing process. However, the process time required increases by 50%, therefore increasing the manufacturing costs. An optimized cure cycle is required to minimize process time and cure induced defects simultaneously.