Corrosione atmosferica in area urbana-costiera di un acciaio Cor-Ten: studio del rilascio in ambiente dei metalli di lega

Cor-Ten is a particular kind of steel, belonging to low-alloyed steel; thanks to his aesthetic features and resistance to atmospheric corrosion, this material is largely used in architectural, artistic and infrastructural applications. After environmental exposure, Cor-Ten steel exhibits the characteristic ability to self-protect from corrosion, by the development of a stable and adherent protective layer. However, some environmental factors can influence the formation and stability of the patina. In particular, exposure of Cor-Ten to polluted atmosphere (NOx, SOx, O3) or coastal areas (marine spray) may cause problems to the protective layer and, as a consequence, a release of alloying metals, which can accumulate near the structures. Some of these metals, such as Cr and Ni, could be very dangerous for soils and water because of their large toxicity. The aim of this work was to study the corrosion behavior of Cor-Ten exposed to an urban-coastal site (Rimini, Italy). Three different kinds of commercial surface finish (bare and pre-patinated, with or without a beeswax covering) were examined, both in sheltered and unsheltered exposure conditions. Wet deposition brushing the specimens surface (leaching solutions) are monthly collected and analyzed to evaluate the extent of metal release and the form in which they leave the surface, for example, as water-soluble compounds or non-adherent corrosion products. Five alloying metals (Fe, Cu, Cr, Mn and Ni) and nine ions (Cl-, NO3-, NO2-, SO42-, Na+, Ca2+, K+, Mg2+, NH4+) are determined through Atomic Absorption Spectroscopy and Ion Chromatography, respectively. Furthermore, the evolution and the behaviour of the patina are periodically followed by surface investigations (SEM-EDS and Raman Spectroscopy). After two years of exposure, the results show that Bare Cor-Ten, cheaper than the other analyzed specimens, even though undergoes the greater mass variation, his metal release is comparable to the release of the pre-patinated samples. The behavior of pre-patinated steel, with or without beeswax covering, do not show particular difference. This exposure environment doesn’t allow a completely stabilization of the patina; nevertheless an estimate of metal release after 10 years of exposure points out that the environmental impact of Cor-Ten is very low: for example, the release of chromium in the soluble fraction is less than 10 mg if we consider an exposed wall of 10 m2.

Double Dyke System - Natural engineering solutions

According to various studies, the effects of climate change will be a danger to ecosystems and the population, especially in coastal areas, increasing the risk of floods. Authorities are taking action to prevent future disasters using traditional engineering solutions. These solutions can have high environmental and economic costs, fixing the coastline, increasing the salinization of aquifers, and can be subject to failure mechanisms. For this reason, studies were made to use natural engineering solutions for coastal protection, instead of traditional solutions, to achieve the UN SDGs. Coastal ecosystems have the natural ability to repair and restore themselves, increasing soil elevation, and attenuating waves. One of these solutions is the Double Dyke System, consisting of creating a salt marsh between the first dyke and a second inland. The goal is to protect the coasts and to restore ecosystems. The purpose of this study is to compare the costs of natural engineering solutions with traditional ones. It is assumed that these solutions may be more effective and less expensive in the long run. For this evaluation, a suitability analysis of the polders in the Dutch Zeeland region to assess the costs and benefits under different SLR scenarios was made. A saline intrusion model was also created to analyze the effects of a salt marsh on the aquifers. From the analyzes conducted, the implementation of the DDS turns out to be the cheapest coastal defense system in all SLR scenarios. The presence of a salt marsh could also have a positive impact on the prevention of saline intrusion in the various scenarios considered. The DDS could have a positive economic and environmental impact in the long term, reducing the investment costs for coastal defense and bringing important benefits for the protection of man and nature. Despite the results, more studies are needed on the efficiency of this defense system and on the economic evaluation of non-marketable ecosystem services.

Citizen science as a tool for the environmental quality assessment of the Mediterranean coastal habitats

The growing need to assess the environmental status of the Mediterranean coastal marine habitats and the large availability of data collected by Reef Check Italia onlus (RCI) volunteers suggest the possibility to develop innovative and reliable indices that may support decision makers in applying conservation strategies. The aims of this study were to check the reliability of data collected by RCI volunteers, analyse the spatial and temporal distribution of RCI available data, resume the knowledge on the biology and ecology of the monitored species, and develop innovative indices to asses the ecological quality of Mediterranean subtidal rocky shores and coralligenous habitats. Subtidal rocky shores and coralligenous were chosen because these are the habitats more attractive for divers; therefore mlst data are referring to them, moreover subtidal rocky bottom are strongly affected by coastal urbanisation, land use, fishing and tourist activities, that increase pollution, turbidity and sedimentation. Non-indigenous species (NIS) have been recognized as a major threat to the integrity of Mediterranean native communities because of their proliferation, spread and impact on resident communities. Monitoring of NIS’ spreading dynamics at the basin spatial scale is difficult but urgent. According to a field test, the training provided by RCI appears adequate to obtain reliable data by volunteers. Based on data collected by RCI volunteers, three main categories of indices were developed: indices based on species diversity, indices on the occurrence non-indigenous species, and indices on species sensitive toward physical, chemical and biological disturbances. As case studies, indices were applied to stretches of coastline defined according to management criteria (province territories and marine protected areas). The assessments of ecological quality in the Tavolara Marine Protected Area using the species sensitivities index were consisten with those previously obtained with traditional methods.

Monitoring of macro- and microlitter in the Venice lagoon and coastal area

Marine litter and plastics are a significant and growing marine contaminant that has become a global problem. Macrolitter is subject to fragmentation and degradation due to physical, chemical and biological processes, leading to the formation of micro-litter, the so-called microplastics. The purpose of this research is to assess marine litter pollution by using remote sensing tools to identify areas of macrolitter accumulation and to evaluate the concentrations of microplastics in different environmental matrices: water, sediment and biota (i.e. mussels and fish) and to contribute to the European project MAELSTROM (Smart technology for MArinE Litter SusTainable RemOval and Management). The aim is to monitor the presence of macro- and microlitter at two sites of the Venice coastal area: an abandoned mussel farm at sea and a lagoon site near the artificial Island of Sacca Fisola; The results showed that both study areas are characterised by high amounts of marine litter, but the type of observed litter is different. In fact, in the mussel farm area, most of the litter is linked to aquaculture activities (ropes, nets, mooring blocks and floating buoys). In the Venice lagoon site, the litter comes more from urban activities and from the city of Venice (car tyres, crates, wrecks, etc.). Microplastics is present in both sites and in all the analysed matrices. Generally, higher microplastics concentrations were found at Sacca Fisola (i.e., in surface waters, mussels and fish). Moreover, some differences were also observed in shapes and colours comparing the two sites. At Sacca Fisola, white irregular fragments predominate in water samples, blue filaments in sediment and mussels, and transparent irregular fragments in fish. At the Mussel Farm, blue filaments predominate in water, sediment and mussels, while flat black fragments predominate in fish. These differences are related to the different types of macrolitter that characterised the two areas.