Valutazione del contributo emissivo in condizioni non-stazionarie alle emissioni totali di una stufa a pellet domestica

The aim of this work is to evaluate the emissions of the main pollutants of a pellet stove, by trying to simulate the real use in domestic operations. All the operating phases of this system were considered: ignition, partial load, increase in power, and nominal load. In each phase, quantity and type of some pollutants in emissions were determined: the main pollutant gases (CO, NOx, SO2, H2S and volatile organic compounds (VOCs)), total dust (PM) and its content of polycyclic aromatic hydrocarbons (PAHs), regulated heavy metals (Ni, Cd, As and Pb), main soluble ions and Total Carbon (TC). Results show that emission factors of TSP, CO, and of the main determined pollutants (TC, Cd and PAHs) are higher during ignition phase. In particular, this phase prevalently contributes to PAHs emissions. During increase in power phase, gas and particulate emissions do not appreciably differ from nominal load ones; nevertheless, PAH emission factors are higher than steady state ones, but lower than ignition phase. Moreover, during not-steady state phases, PAH mixture is more toxic than during steady state phases. In conclusion, this study allowed to go deeper in pellet stove environmental impact, by pointing out how the different operating conditions can modify the emissions. These are different from certificated data, which are based exclusively on measurements in steady state conditions.

The contribution of the Finite Volume Point Dilution Method to the determination of solute mass flux in an alluvial aquifer.

Groundwater represents one of the most important resources of the world and it is essential to prevent its pollution and to consider remediation intervention in case of contamination. According to the scientific community the characterization and the management of the contaminated sites have to be performed in terms of contaminant fluxes and considering their spatial and temporal evolution. One of the most suitable approach to determine the spatial distribution of pollutant and to quantify contaminant fluxes in groundwater is using control panels. The determination of contaminant mass flux, requires measurement of contaminant concentration in the moving phase (water) and velocity/flux of the groundwater. In this Master Thesis a new solute flux mass measurement approach, based on an integrated control panel type methodology combined with the Finite Volume Point Dilution Method (FVPDM), for the monitoring of transient groundwater fluxes, is proposed. Moreover a new adsorption passive sampler, which allow to capture the variation of solute concentration with time, is designed. The present work contributes to the development of this approach on three key points. First, the ability of the FVPDM to monitor transient groundwater fluxes was verified during a step drawdown test at the experimental site of Hermalle Sous Argentau (Belgium). The results showed that this method can be used, with optimal results, to follow transient groundwater fluxes. Moreover, it resulted that performing FVPDM, in several piezometers, during a pumping test allows to determine the different flow rates and flow regimes that can occurs in the various parts of an aquifer. The second field test aiming to determine the representativity of a control panel for measuring mass flus in groundwater underlined that wrong evaluations of Darcy fluxes and discharge surfaces can determine an incorrect estimation of mass fluxes and that this technique has to be used with precaution. Thus, a detailed geological and hydrogeological characterization must be conducted, before applying this technique. Finally, the third outcome of this work concerned laboratory experiments. The test conducted on several type of adsorption material (Oasis HLB cartridge, TDS-ORGANOSORB 10 and TDS-ORGANOSORB 10-AA), in order to determine the optimum medium to dimension the passive sampler, highlighted the necessity to find a material with a reversible adsorption tendency to completely satisfy the request of the new passive sampling technique.