Experimental assessment of environmental decay effects in masonry via non destructive diagnostic techniques and mechanical tests

Environmental decay in porous masonry materials, such as brick and mortar, is a widespread problem concerning both new and historic masonry structures. The decay mechanisms are quite complex dependng upon several interconnected parameters and from the interaction with the specific micro-climate. Materials undergo aesthetical and substantial changes in character but while many studies have been carried out, the mechanical aspect has been largely understudied while it bears true importance from the structural viewpoint. A quantitative assessment of the masonry material degradation and how it affects the load-bearing capacity of masonry structures appears missing. The research work carried out, limiting the attention to brick masonry addresses this issue through an experimental laboratory approach via different integrated testing procedures, both non-destructive and mechanical, together with monitoring methods. Attention was focused on transport of moisture and salts and on the damaging effects caused by the crystallization of two different salts, sodium chloride and sodium sulphate. Many series of masonry specimens, very different in size and purposes were used to track the damage process since its beginning and to monitor its evolution over a number of years Athe same time suitable testing techniques, non-destructive, mini-invasive, analytical, of monitoring, were validated for these purposes. The specimens were exposed to different aggressive agents (in terms of type of salt, of brine concentration, of artificial vs. open-air natural ageing, …), tested by different means (qualitative vs. quantitative, non destructive vs. mechanical testing, punctual vs. wide areas, …), and had different size (1-, 2-, 3-header thick walls, full-scale walls vs. small size specimens, brick columns and triplets vs. small walls, masonry specimens vs. single units of brick and mortar prisms, …). Different advanced testing methods and novel monitoring techniques were applied in an integrated holistic approach, for quantitative assessment of masonry health state.

Testing the effectiveness of phytoscreening to monitor shallow groundwater contamination by chlorinated ethenes

The research presented herein aims to investigate the strengths and weaknesses of a relatively new technique called phytoscreening. Parallel to the well-known phytoremediation, it consists of exploiting the absorbing potential of trees to delineate groundwater contamination plumes, especially for chlorinated ethenes (i.e., PCE, TCE, 1,2-cis DCE, and VC). The latter are prevalent contaminants in groundwater but their fate and transport in surface ecosystems, such as trees, are still poorly understood and subjected to high variability. Moreover, the analytical validity of tree-coring is still limited in many countries due to a lack of knowledge of its application opportunities. Tree-cores are extracted from trunks and generally analyzed by gas chromatography/mass spectrometry. A systematic review of former literature on phytoscreening for chlorinated ethenes is presented in this PhD thesis to evaluate the factors influencing the effectiveness of the technique. Besides, we tested the technique by probing eight sites contaminated by chlorinated ethenes in Italy (Emilia-Romagna) in different hydrogeological and seasonal settings. We coupled the technique with the assessment of gaseous-phase concentrations directly on-site, inserting detector tubes or a photoionization detector in the tree-holes left by the coring tool. Finally, we applied rank order statistic analysis on field data along with literature data to assess under which conditions phytoscreening should be applied to either screen or monitor environmental contamination issues. A relatively high correlation exists between tree-core and groundwater concentrations (Spearman’s ρ > 0.6), being higher for compounds with higher sorption, for sites with shallower and thinner aquifers, and when sampling specific tree types with standardized sampling and extraction protocols. These results indicate the opportunities for assessing the occurrence, type, and concentration of solvents directly from the stem of trees. This can reduce the costs of characterization surveys, allowing rapid identification of hotspots and plume direction and thus optimizing the drilling of boreholes.