Characterization of L-type Calcium Channel Binding-Site of a new class of Calcium modulators by a Multidisciplinary approach

Many potential diltiazem related L-VDCC blockers were developed using a multidisciplinary approach. This current study was to investigate and compare diltiazem with to the newly developed compounds by mouse Langendorff-perfused heart, Ca2+-transient and on recombinant L-VDCC. Twenty particular compounds were selected by the ligand-based virtual screening procedure (LBVS). From these compounds, five of them (5b, M2, M7, M8 and P1) showed a potent and selective inotropic activity on guinea-pig left atria driven 1 Hz. Further assays displayed an interesting negative inotropic effect of M2, M8, P1 and M7 on guinea pig isolated left papillary muscle driven at 1 Hz, a relevant vasorelaxant activity of 5b, M2, M7, M8 and P1 on K+-depolarized guinea-pig ileum longitudinal smooth muscle and a significant inhibition of contraction of 5b, M2, M8 and P1 on carbachol stimulated ileum longitudinal smooth muscle. Wild-type human heart and rabbit lung α1 subunits were expressed (combined with the regulatory α2δ and β3 subunits) in Xenopus Leavis oocytes using a two-electrode voltage clamp technique. Diltiazem is a benzothiazepine Ca2+ channel blocker used clinically for its antihypertensive and antiarrhythmic effects. Previous radioligand binding assays revealed a complex interaction with the benzothiazepine binding site for M2, M7 and M8. (Carosati E. et al. J. Med Chem. 2006, 49; 5206). In agreement with this findings, the relative order of increased rates of contraction and relaxation at lower concentrations s(≤10-6M) in unpaced hearts was M7>M2>M8>P1. Similar increases in Ca2+ transient were observed in cardiomyocytes. Diltiazem showed negative inotropic effects whereas 5b had no significant effect. Diltiazem blocks Ca2+current in a use-dependent manner and facilitates the channel by accelerating the inactivation and decelerating the recovery from inactivation. In contrast to diltiazem, the new analogs had no pronounced use-dependence. Application of 100 μM M8, M2 showed ~ 10% tonic block; in addition, M8, M2 and P1 shifted the steady state inactivation in hyperpolarized direction and the current inactivation time was significantly decreased compared with control (219.6 ± 11.5 ms, 226 ± 14.5 vs. 269 ± 12.9 vs. 199.28 ± 8.19 ms). Contrary to diltiazem, the recovery from the block by M8 and M2 was comparable to control. Only P1 showed a significantly decrease of the time for the recovery from inactivation. All of the compounds displayed the same sensitivity on the Ca2+ channel rabbit lung α1 except P1. Taken together, these findings suggest that M8, M2 and P1 might directly decrease the binding affinity or allow rapid dissociation from the benzothiazepine binding site.

A candidate gene approach to identify DNA markers associated with meat quality and production traits: investigation of several cathepsin genes in Italian heavy pigs.

The cathepsin enzymes represent an important family of lysosomal proteinases with a broad spectrum of functions in many, if not in all, tissues and cell types. In addition to their primary role during the normal protein turnover, they possess highly specific proteolytic activities, including antigen processing in the immune response and a direct role in the development of obesity and tumours. In pigs, the involvement of cathepsin enzymes in proteolytic processes have important effects during the conversion of muscle to meat, due to their influence on meat texture and sensory characteristics, mainly in seasoned products. Their contribution is fundamental in flavour development of dry-curing hams. However, several authors have demonstrated that high cathepsin activity, in particular of cathepsin B, is correlated to defects of these products, such as an excessive meat softness together with abnormal free tyrosine content, astringent or metallic aftertastes and formation of a white film on the cut surface. Thus, investigation of their genetic variability could be useful to identify DNA markers associated with these dry cured hams parameters, but also with meat quality, production and carcass traits in Italian heavy pigs. Unfortunately, no association has been found between cathepsin markers and meat quality traits so far, in particular with cathepsin B activity, suggesting that other genes, besides these, affect meat quality parameters. Nevertheless, significant associations were observed with several carcass and production traits in pigs. A recent study has demonstrated that different single nucleotide polymorphisms (SNPs) localized in cathepsin D (CTSD), F (CTSF), H and Z genes were highly associated with growth, fat deposition and production traits in an Italian Large White pig population. The aim of this thesis was to confirm some of these results in other pig populations and identify new cathepsin markers in order to evaluate their effects on cathepsin activity and other production traits. Furthermore, starting from the data obtained in previous studies on CTSD gene, we also analyzed the known polymorphism located in the insulin-like growth factor 2 gene (IGF2 intron3-g.3072G>A). This marker is considered the causative mutation for the quantitative trait loci (QTL) affecting muscle mass and fat deposition in pigs. Since IGF2 maps very close to CTSD on porcine chromosome (SSC) 2, we wanted to clarify if the effects of the CTSD marker were due to linkage disequilibrium with the IGF2 intron3-g.3072G>A mutation or not. In the first chapter, we reported the results from these two SSC2 gene markers. First of all, we evaluated the effects of the IGF2 intron3-g.3072G>A polymorphism in the Italian Large White breed, for which no previous studies have analysed this marker. Highly significant associations were identified with all estimated breeding values for production and carcass traits (P<0.00001), while no effects were observed for meat quality traits. Instead, the IGF2 intron3-g.3072G>A mutation did not show any associations with the analyzed traits in the Italian Duroc pigs, probably due to the low level of variability at this polymorphic site for this breed. In the same Duroc pig population, significant associations were obtained for the CTSD marker for all production and carcass traits (P < 0.001), after excluding possible confounding effects of the IGF2 mutation. The effects of the CTSD g.70G>A polymorphism were also confirmed in a group of Italian Large White pigs homozygous for the IGF2 intron3-g.3072G allele G (IGF2 intron3-g.3072GG) and by haplotype analysis between the markers of the two considered genes. Taken together, all these data indicated that the IGF2 intron3-g.3072G>A mutation is not the only polymorphism affecting fatness and muscle deposition in pigs. In the second chapter, we reported the analysis of two new SNPs identified in cathepsin L (CTSL) and cathepsin S (CTSS) genes and the association results with meat quality parameters (including cathepsin B activity) and several production traits in an Italian Large White pig population. Allele frequencies of these two markers were evaluated in 7 different pig breeds. Furthermore, we mapped using a radiation hybrid panel the CTSS gene on SSC4. Association studies with several production traits, carried out in 268 Italian Large White pigs, indicated positive effects of the CTSL polymorphism on average daily gain, weight of lean cuts and backfat thickness (P<0.05). The results for these latter traits were also confirmed using a selective genotype approach in other Italian Large White pigs (P<0.01). In the 268 pig group, the CTSS polymorphism was associated with feed:gain ratio and average daily gain (P<0.05). Instead, no association was observed between the analysed markers and meat quality parameters. Finally, we wanted to verify if the positive results obtained for the cathepsin L and S markers and for other previous identified SNPs (cathepsin F, cathepsin Z and their inhibitor cystatin B) were confirmed in the Italian Duroc pig breed (third chapter). We analysed them in two groups of Duroc pigs: the first group was made of 218 performance-tested pigs not selected by any phenotypic criteria, the second group was made of 100 Italian Duroc pigs extreme and divergent for visible intermuscular fat trait. In the first group, the CTSL polymorphism was associated with weight of lean cuts (P<0.05), while suggestive associations were obtained for average daily gain and backfat thickness (P<0.10). Allele frequencies of the CTSL gene marker also differed positively among the visible intermuscular extreme tails. Instead, no positive effects were observed for the other DNA markers on the analysed traits. In conclusion, in agreement with the present data and for the biological role of these enzymes, the porcine CTSD and CTSL markers: a) may have a direct effect in the biological mechanisms involved in determining fat and lean meat content in pigs, or b) these markers could be very close to the putative functional mutation(s) present in other genes. These findings have important practical applications, in particular the CTSD and CTSL mutations could be applied in a marker assisted selection (MAS) both in the Italian Large White and Italian Duroc breeds. Marker assisted selection could also increase in efficiency by adding information from the cathepsin S genotype, but only in the Italian Large White breed.

Theoretical and numerical study of the laser-plasma ion acceleration

The laser driven ion acceleration is a burgeoning field of resarch and is attracting a growing number of scientists since the first results reported in 2000 obtained irradiating thin solid foils by high power laser pulses. The growing interest is driven by the peculiar characteristics of the produced bunches, the compactness of the whole accelerating system and the very short accelerating length of this all-optical accelerators. A fervent theoretical and experimental work has been done since then. An important part of the theoretical study is done by means of numerical simulations and the most widely used technique exploits PIC codes (“Particle In Cell'”). In this thesis the PIC code AlaDyn, developed by our research group considering innovative algorithms, is described. My work has been devoted to the developement of the code and the investigation of the laser driven ion acceleration for different target configurations. Two target configurations for the proton acceleration are presented together with the results of the 2D and 3D numerical investigation. One target configuration consists of a solid foil with a low density layer attached on the irradiated side. The nearly critical plasma of the foam layer allows a very high energy absorption by the target and an increase of the proton energy up to a factor 3, when compared to the ``pure'' TNSA configuration. The differences of the regime with respect to the standard TNSA are described The case of nearly critical density targets has been investigated with 3D simulations. In this case the laser travels throughout the plasma and exits on the rear side. During the propagation, the laser drills a channel and induce a magnetic vortex that expanding on the rear side of the targer is source of a very intense electric field. The protons of the plasma are strongly accelerated up to energies of 100 MeV using a 200PW laser.

Late Quaternary geological evolution of the Montenegro and Northern Albania continental margins

The object of this work has been the analysis of natural processes controlling the geological evolution of the Montenegro and Northern Albania Continental Margin (MACM) during the Late Quaternary. These include the modern sediment dispersal system and oceanographic regime, the building and shaping of the shelf margin at the scale of 100 kyr and relative to the most recent transition between glacial and interglacial periods. The analysis of the new data shows that the MACM is a shelf-slope system formed by a suite of physiographic elements, including: an inner and an outer continental shelf, separated by two tectonically-controlled morphological highs; a lobated drowned mid-shelf paleodelta, formed during the last sea level fall and low stand; an upper continental slope, affected by gravity-driven instability and a system of extensional faults with surficial displacement, featuring an orientation coherent with the regional tectonics. The stratigraphic study of the MACM shows a clear correspondence between the Late Pleistocene/Holocene mud-wedge and the low reflectivity sectors of the inner shelf. Conversely, most of the outer shelf and part of the continental slope expose deposits from the last sea level low stand, featuring a general sediment starving condition or the presence of a thin postglacial sediments cover. The MACM shows uplift in correspondence of the Kotor and Bar ridges, and subsidence in the outer shelf and upper slope sectors. In fact, seaward of these tectonic ridges, the sparker seismic profile show the presence of four well-defined seismo-stratigraphic sequences, interpreted as forced regression deposits, formed during the last four main glacial phases. In this way, the MACM records the 100 kyr scale sea level fluctuations on its seismo-stratigraphic architecture over the last 350 kyr. Over such time range, through the identification of the paleoshoreline deposits, we estimated an average subsidence rate of about 1.2 mm/yr.