Experimental assessment of environmental decay effects in masonry via non destructive diagnostic techniques and mechanical tests

Environmental decay in porous masonry materials, such as brick and mortar, is a widespread problem concerning both new and historic masonry structures. The decay mechanisms are quite complex dependng upon several interconnected parameters and from the interaction with the specific micro-climate. Materials undergo aesthetical and substantial changes in character but while many studies have been carried out, the mechanical aspect has been largely understudied while it bears true importance from the structural viewpoint. A quantitative assessment of the masonry material degradation and how it affects the load-bearing capacity of masonry structures appears missing. The research work carried out, limiting the attention to brick masonry addresses this issue through an experimental laboratory approach via different integrated testing procedures, both non-destructive and mechanical, together with monitoring methods. Attention was focused on transport of moisture and salts and on the damaging effects caused by the crystallization of two different salts, sodium chloride and sodium sulphate. Many series of masonry specimens, very different in size and purposes were used to track the damage process since its beginning and to monitor its evolution over a number of years Athe same time suitable testing techniques, non-destructive, mini-invasive, analytical, of monitoring, were validated for these purposes. The specimens were exposed to different aggressive agents (in terms of type of salt, of brine concentration, of artificial vs. open-air natural ageing, …), tested by different means (qualitative vs. quantitative, non destructive vs. mechanical testing, punctual vs. wide areas, …), and had different size (1-, 2-, 3-header thick walls, full-scale walls vs. small size specimens, brick columns and triplets vs. small walls, masonry specimens vs. single units of brick and mortar prisms, …). Different advanced testing methods and novel monitoring techniques were applied in an integrated holistic approach, for quantitative assessment of masonry health state.

In vitro application of biocontrol agents to improve the safety and quality of grapevine products

Pathogenic fungi are responsible for vine diseases affecting the grapevine yield and the organoleptic quality of the final wine products. Using of biocontrol agents can represent a sustainable alternative to the use of synthetic fungicides whose intense use can have negative effects on the ecosystem and cause increase resistant pathogen population to synthetic agents. The principal aim of my PhD thesis was the isolation and characterization of new yeast strains and Bacillus subtilis SV108 as biocontrol agent and the comprehension of the mechanism of their antimicrobial action. Accordingly, twenty wild yeast and one selected bacterium isolated among 62 samples, isolated from different Italian and Malaysian regions and molecularly identified, were evaluated in a preliminary screening test on agar. Results showed the highest effects on inhibiting mycelial growth by Starmerella bacillaris FE08.05, Metschnikowia pulcherrima GP8 and Hanseniaspora uvarum GM19. On the other side, Bacillus subtilis SV108 showed the ability of inhibit the mycelial growth of selected fungi by producing antimicrobial compounds on Malt Extract Broth medium recovered by sodium dodecyl sulphate polyacrylamide gel electrophoresis (SDS-PAGE) and identified by electrospray ionization (ESI) tandem mass spectrometer Triple TOF 5600. Moreover, in order to analyze the volatile fraction of compounds, the quantitative analysis of the VOCs profiles was performed by GC/MS/SPME. The analysis highlighted the presence of isoamyl and phenylethyl alcohols and an overall higher presence of low-chain fatty acids and volatile ethyl esters. All the data collected suggest that the tested yeasts, found among the epiphytic microbiota associated with grape berries, can be potentially effective for the biological control of pathogenic moulds. On the other hand, the proteomic study conducted on B. subtilis SV108 revealed that there are two cyclic antifungal peptides which can explain the antimicrobial effect of Bacillus subtilis SV108 acting as biocontrol agent against fungal pathogens in grapevine.