Strategies and procedures for the development of intermodal freight transport in Europe: the role of motorways of the sea services and railway terminals

Since the birth of the European Union on 1957, the development of a single market through the integration of national freight transport networks has been one of the most important points in the European Union agenda. Increasingly congested motorways, rising oil prices and concerns about environment and climate change require the optimization of transport systems and transport processes. The best solution should be the intermodal transport, in which the most efficient transport options are used for the different legs of transport. This thesis examines the problem of defining innovative strategies and procedures for the sustainable development of intermodal freight transport in Europe. In particular, the role of maritime transport and railway transport in the intermodal chain are examined in depth, as these modes are recognized to be environmentally friendly and energy efficient. Maritime transport is the only mode that has kept pace with the fast growth in road transport, but it is necessary to promote the full exploitation of it by involving short sea shipping as an integrated service in the intermodal door-to-door supply chain and by improving port accessibility. The role of Motorways of the Sea services as part of the Trans-European Transport Network is is taken into account: a picture of the European policy and a state of the art of the Italian Motorways of the Sea system are reported. Afterwards, the focus shifts from line to node problems: the role of intermodal railway terminals in the transport chain is discussed. In particular, the last mile process is taken into account, as it is crucial in order to exploit the full capacity of an intermodal terminal. The difference between the present last mile planning models of Bologna Interporto and Verona Quadrante Europa is described and discussed. Finally, a new approach to railway intermodal terminal planning and management is introduced, by describing the case of "Terminal Gate" at Verona Quadrante Europa. Some proposals to favour the integrate management of "Terminal Gate" and the allocation of its capacity are drawn up.

Procedures of quality control and data analysis of multi-site ground-based observations for the absolute flux calibration of Gaia

The Gaia space mission is a major project for the European astronomical community. As challenging as it is, the processing and analysis of the huge data-flow incoming from Gaia is the subject of thorough study and preparatory work by the DPAC (Data Processing and Analysis Consortium), in charge of all aspects of the Gaia data reduction. This PhD Thesis was carried out in the framework of the DPAC, within the team based in Bologna. The task of the Bologna team is to define the calibration model and to build a grid of spectro-photometric standard stars (SPSS) suitable for the absolute flux calibration of the Gaia G-band photometry and the BP/RP spectrophotometry. Such a flux calibration can be performed by repeatedly observing each SPSS during the life-time of the Gaia mission and by comparing the observed Gaia spectra to the spectra obtained by our ground-based observations. Due to both the different observing sites involved and the huge amount of frames expected (≃100000), it is essential to maintain the maximum homogeneity in data quality, acquisition and treatment, and a particular care has to be used to test the capabilities of each telescope/instrument combination (through the “instrument familiarization plan”), to devise methods to keep under control, and eventually to correct for, the typical instrumental effects that can affect the high precision required for the Gaia SPSS grid (a few % with respect to Vega). I contributed to the ground-based survey of Gaia SPSS in many respects: with the observations, the instrument familiarization plan, the data reduction and analysis activities (both photometry and spectroscopy), and to the maintenance of the data archives. However, the field I was personally responsible for was photometry and in particular relative photometry for the production of short-term light curves. In this context I defined and tested a semi-automated pipeline which allows for the pre-reduction of imaging SPSS data and the production of aperture photometry catalogues ready to be used for further analysis. A series of semi-automated quality control criteria are included in the pipeline at various levels, from pre-reduction, to aperture photometry, to light curves production and analysis.

Reexamining the Role of Incarceration and Stigma in Criminal Law

One of the ways by which the legal system has responded to different sets of problems is the blurring of the traditional boundaries of criminal law, both procedural and substantive. This study aims to explore under what conditions does this trend lead to the improvement of society's welfare by focusing on two distinguishing sanctions in criminal law, incarceration and social stigma. In analyzing how incarceration affects the incentive to an individual to violate a legal standard, we considered the crucial role of the time constraint. This aspect has not been fully explored in the literature on law and economics, especially with respect to the analysis of the beneficiality of imposing either a fine or a prison term. We observed that that when individuals are heterogeneous with respect to wealth and wage income, and when the level of activity can be considered a normal good, only the middle wage and middle income groups can be adequately deterred by a fixed fines alone regime. The existing literature only considers the case of the very poor, deemed as judgment proof. However, since imprisonment is a socially costly way to deprive individuals of their time, other alternatives may be sought such as the imposition of discriminatory monetary fine, partial incapacitation and other alternative sanctions. According to traditional legal theory, the reason why criminal law is obeyed is not mainly due to the monetary sanctions but to the stigma arising from the community’s moral condemnation that accompanies conviction or merely suspicion. However, it is not sufficiently clear whether social stigma always accompanies a criminal conviction. We addressed this issue by identifying the circumstances wherein a criminal conviction carries an additional social stigma. Our results show that social stigma is seen to accompany a conviction under the following conditions: first, when the law coincides with the society's social norms; and second, when the prohibited act provides information on an unobservable attribute or trait of an individual -- crucial in establishing or maintaining social relationships beyond mere economic relationships. Thus, even if the social planner does not impose the social sanction directly, the impact of social stigma can still be influenced by the probability of conviction and the level of the monetary fine imposed as well as the varying degree of correlation between the legal standard violated and the social traits or attributes of the individual. In this respect, criminal law serves as an institution that facilitates cognitive efficiency in the process of imposing the social sanction to the extent that the rest of society is boundedly rational and use judgment heuristics. Paradoxically, using criminal law in order to invoke stigma for the violation of a legal standard may also serve to undermine its strength. To sum, the results of our analysis reveal that the scope of criminal law is narrow both for the purposes of deterrence and cognitive efficiency. While there are certain conditions where the enforcement of criminal law may lead to an increase in social welfare, particularly with respect to incarceration and stigma, we have also identified the channels through which they could affect behavior. Since such mechanisms can be replicated in less costly ways, society should first try or seek to employ these legal institutions before turning to criminal law as a last resort.

L’istituto della riabilitazione tra cancellazione del reato e riparazione alla vittima: la sua applicazione nelle realtà europee italiana e belga

La realizzazione di questa ricerca ha come obiettivo principe lo studio approfondito dell’istituto della riabilitazione penale all’interno del panorama legislativo italiano, con riferimento al contesto bolognese, e nella legislazione belga; inoltre si pone come scopo l’analisi dell’interazione autore-vittima del reato, con una particolare attenzione al risarcimento elargito alla persona offesa dal reato e alla figura della vittima prima nel sistema penale, poi nel procedimento specifico che porta alla riabilitazione del condannato. Il punto di partenza del lavoro di ricerca intrapreso è costituito da un’accurata ricerca bibliografica inerente agli argomenti trattati, al fine di poter approfondire una buona parte della letteratura italiana e belga esistente in materia. La fase successiva della ricerca è stata quella di reperire informazioni riguardanti l’ambito di studio da approfondire, cioè la riabilitazione, secondo una direttrice empirica. Pertanto, per quanto concerne la realtà italiana, sono stati analizzati, tramite una griglia di rilevazione costruita ad hoc, i fascicoli processuali relativi alla riabilitazione presenti negli archivi del Tribunale di Sorveglianza di Bologna (2004-2009); la situazione belga è invece stata studiata reperendo dati, riferiti alla réhabilitation pénal, rintracciati presso il “Service Public Fédéral Justice - Bureau Permanent Statistiques et Mesure de la charge de travail (BPSM)” (2008-2009), sia livello nazionale che delle cinque Corti di appello. Inoltre, al fine di ottenere un ulteriore punto di vista empirico riguardante l’istituto della riabilitazione penale, sono state effettuate delle interviste semi-strutturate al Presidente del Tribunale di Sorveglianza Dott. Francesco Maisto e al Sostituto Procuratore Generale di Liège Mr. Nicolas Banneux. Infatti l’esperienza lavorativa e il particolare ruolo ricoperto da questi “osservatori privilegiati”, competenti di riabilitazione e particolarmente sensibili alle tematiche criminologiche e vittimologiche, li pone direttamente in contatto con l’istituto e la procedura della riabilitazione, determinando in loro una profonda padronanza dell’oggetto di ricerca.

Novel Synthetic Procedures in Organocatalysis

The main aim of my PhD project was the design and the synthesis of new pyrrolidine organocatalysts. New effective ferrocenyl pyrrolidine catalysts, active in benchmark organocatalytic reactions, has been developed. The ferrocenyl moiety, in combination with simple ethyl chains, is capable of fixing the enamine conformation addressing the approach trajectory of the nucleophile in the reaction. The results obtained represent an interesting proof-of-concept, showing for the first time the remarkable effectiveness of the ferrocenyl moiety in providing enantioselectivity through conformational selection. This approach could be viably employed in the rational design of ligands for metal or organocatalysts. Other hindered secondary amines has been prepared from alkylation of acyclic chiral nitroderivatives with alcohols in a highly diastereoselective fashion, giving access to functionalized, useful organocatalytic chiral pyrrolidines. A family of new pyrrolidines bearing sterogenic centers and functional groups can be readily accessible by this methodology. The second purpose of the project was to study in deep the reactivity of stabilized carbocations in new metal-free and organocatalytic reactions. By taking advantage of the results from the kinetic studies described by Mayr, a simple and effective procedure for the direct formylation of aryltetrafluoroborate salts, has been development. The coupling of a range of aryl- and heteroaryl- trifluoroborate salts with 1,3-benzodithiolylium tetrafluoroborate, has been attempted in moderate to good yields. Finally, a simple and general methodology for the enamine-mediated enantioselective α-alkylation of α-substituted aldehydes with 1,3-benzodithiolylium tetrafluoroborate has been reported. The introduction of the benzodithiole moiety permit the installation of different functional groups due to its chameleonic behaviour.

Optimization of purification procedures in organic semiconductor synthesis for improving the performances of organic field-effect transistors

The aim of the research activity focused on the investigation of the correlation between the degree of purity in terms of chemical dopants in organic small molecule semiconductors and their electrical and optoelectronic performances once introduced as active material in devices. The first step of the work was addressed to the study of the electrical performances variation of two commercial organic semiconductors after being processed by means of thermal sublimation process. In particular, the p-type 2,2′′′-Dihexyl-2,2′:5′,2′′:5′′,2′′′-quaterthiophene (DH4T) semiconductor and the n-type 2,2′′′- Perfluoro-Dihexyl-2,2′:5′,2′′:5′′,2′′′-quaterthiophene (DFH4T) semiconductor underwent several sublimation cycles, with consequent improvement of the electrical performances in terms of charge mobility and threshold voltage, highlighting the benefits brought by this treatment to the electric properties of the discussed semiconductors in OFET devices by the removal of residual impurities. The second step consisted in the provision of a metal-free synthesis of DH4T, which was successfully prepared without organometallic reagents or catalysts in collaboration with Dr. Manuela Melucci from ISOF-CNR Institute in Bologna. Indeed the experimental work demonstrated that those compounds are responsible for the electrical degradation by intentionally doping the semiconductor obtained by metal-free method by Tetrakis(triphenylphosphine)palladium(0) (Pd(PPh3)4) and Tributyltin chloride (Bu3SnCl), as well as with an organic impurity, like 5-hexyl-2,2':5',2''-terthiophene (HexT3) at, in different concentrations (1, 5 and 10% w/w). After completing the entire evaluation process loop, from fabricating OFET devices by vacuum sublimation with implemented intentionally-doped batches to the final electrical characterization in inherent-atmosphere conditions, commercial DH4T, metal-free DH4T and the intentionally-doped DH4T were systematically compared. Indeed, the fabrication of OFET based on doped DH4T clearly pointed out that the vacuum sublimation is still an inherent and efficient purification method for crude semiconductors, but also a reliable way to fabricate high performing devices.

Development of new analytical procedures aimet at the characterization of artistic samples

In this thesis, new advances in the development of spectroscopic based methods for the characterization of heritage materials have been achieved. As concern FTIR spectroscopy new approaches aimed at exploiting near and far IR region for the characterization of inorganic or organic materials have been tested. Paint cross-section have been analysed by FTIR spectroscopy in the NIR range and an “ad hoc” chemometric approach has been developed for the elaboration of hyperspectral maps. Moreover, a new method for the characterization of calcite based on the use of grinding curves has been set up both in MIR and in FAR region. Indeed, calcite is a material widely applied in cultural heritage, and this spectroscopic approach is an efficient and rapid tool to distinguish between different calcite samples. Different enhanced vibrational techniques for the characterisation of dyed fibres have been tested. First a SEIRA (Surface Enhanced Infra-Red Absorption) protocol has been optimised allowing the analysis of colorant micro-extracts thanks to the enhancement produced by the addition of gold nanoparticles. These preliminary studies permitted to identify a new enhanced FTIR method, named ATR/RAIRS, which allowed to reach lower detection limits. Regarding Raman microscopy, the research followed two lines, which have in common the aim of avoiding the use of colloidal solutions. AgI based supports obtained after deposition on a gold-coated glass slides have been developed and tested spotting colorant solutions. A SERS spectrum can be obtained thanks to the photoreduction, which the laser may induce on the silver salt. Moreover, these supports can be used for the TLC separation of a mixture of colorants and the analyses by means of both Raman/SERS and ATR-RAIRS can be successfully reached. Finally, a photoreduction method for the “on fiber” analysis of colorant without the need of any extraction have been optimised.