Using national FADN database to describe Italian farms and arable fields. A comparison of sustainability level between organic versus conventional regimes.

The study defines a new farm classification and identifies the arable land management. These aspects and several indicators are taken into account to estimate the sustainability level of farms, for organic and conventional regimes. The data source is Italian Farm Account Data Network (RICA) for years 2007-2011, which samples structural and economical information. An environmental data has been added to the previous one to better describe the farm context. The new farm classification describes holding by general informations and farm structure. The general information are: adopted regime and farm location in terms of administrative region, slope and phyto-climatic zone. The farm structures describe the presence of main productive processes and land covers, which are recorded by FADN database. The farms, grouped by homogeneous farm structure or farm typology, are evaluated in terms of sustainability. The farm model MAD has been used to estimate a list of indicators. They describe especially environmental and economical areas of sustainability. Finally arable lands are taken into account to identify arable land managements and crop rotations. Each arable land has been classified by crop pattern. Then crop rotation management has been analysed by spatial and temporal approaches. The analysis reports a high variability inside regimes. The farm structure influences indicators level more than regimes, and it is not always possible to compare the two regimes. However some differences between organic and conventional agriculture have been found. Organic farm structures report different frequency and geographical location than conventional ones. Also different connections among arable lands and farm structures have been identified.

Geotechnical characterization of mixed sandy and silty soils using piezocone tests: Analysis of partial drainage phenomena and rate effects on the experimental soil response

The cone penetration test (CPT), together with its recent variation (CPTU), has become the most widely used in-situ testing technique for soil profiling and geotechnical characterization. The knowledge gained over the last decades on the interpretation procedures in sands and clays is certainly wide, whilst very few contributions can be found as regards the analysis of CPT(u) data in intermediate soils. Indeed, it is widely accepted that at the standard rate of penetration (v = 20 mm/s), drained penetration occurs in sands while undrained penetration occurs in clays. However, a problem arise when the available interpretation approaches are applied to cone measurements in silts, sandy silts, silty or clayey sands, since such intermediate geomaterials are often characterized by permeability values within the range in which partial drainage is very likely to occur. Hence, the application of the available and well-established interpretation procedures, developed for ‘standard’ clays and sands, may result in invalid estimates of soil parameters. This study aims at providing a better understanding on the interpretation of CPTU data in natural sand and silt mixtures, by taking into account two main aspects, as specified below: 1)Investigating the effect of penetration rate on piezocone measurements, with the aim of identifying drainage conditions when cone penetration is performed at a standard rate. This part of the thesis has been carried out with reference to a specific CPTU database recently collected in a liquefaction-prone area (Emilia-Romagna Region, Italy). 2)Providing a better insight into the interpretation of piezocone tests in the widely studied silty sediments of the Venetian lagoon (Italy). Research has focused on the calibration and verification of some site-specific correlations, with special reference to the estimate of compressibility parameters for the assessment of long-term settlements of the Venetian coastal defences.