Magnetohydrodynamic Effects On Mixed Convection Flows In Channels And Ducts

This work focuses on magnetohydrodynamic (MHD) mixed convection flow of electrically conducting fluids enclosed in simple 1D and 2D geometries in steady periodic regime. In particular, in Chapter one a short overview is given about the history of MHD, with reference to papers available in literature, and a listing of some of its most common technological applications, whereas Chapter two deals with the analytical formulation of the MHD problem, starting from the fluid dynamic and energy equations and adding the effects of an external imposed magnetic field using the Ohm's law and the definition of the Lorentz force. Moreover a description of the various kinds of boundary conditions is given, with particular emphasis given to their practical realization. Chapter three, four and five describe the solution procedure of mixed convective flows with MHD effects. In all cases a uniform parallel magnetic field is supposed to be present in the whole fluid domain transverse with respect to the velocity field. The steady-periodic regime will be analyzed, where the periodicity is induced by wall temperature boundary conditions, which vary in time with a sinusoidal law. Local balance equations of momentum, energy and charge will be solved analytically and numerically using as parameters either geometrical ratios or material properties. In particular, in Chapter three the solution method for the mixed convective flow in a 1D vertical parallel channel with MHD effects is illustrated. The influence of a transverse magnetic field will be studied in the steady periodic regime induced by an oscillating wall temperature. Analytical and numerical solutions will be provided in terms of velocity and temperature profiles, wall friction factors and average heat fluxes for several values of the governing parameters. In Chapter four the 2D problem of the mixed convective flow in a vertical round pipe with MHD effects is analyzed. Again, a transverse magnetic field influences the steady periodic regime induced by the oscillating wall temperature of the wall. A numerical solution is presented, obtained using a finite element approach, and as a result velocity and temperature profiles, wall friction factors and average heat fluxes are derived for several values of the Hartmann and Prandtl numbers. In Chapter five the 2D problem of the mixed convective flow in a vertical rectangular duct with MHD effects is discussed. As seen in the previous chapters, a transverse magnetic field influences the steady periodic regime induced by the oscillating wall temperature of the four walls. The numerical solution obtained using a finite element approach is presented, and a collection of results, including velocity and temperature profiles, wall friction factors and average heat fluxes, is provided for several values of, among other parameters, the duct aspect ratio. A comparison with analytical solutions is also provided, as a proof of the validity of the numerical method. Chapter six is the concluding chapter, where some reflections on the MHD effects on mixed convection flow will be made, in agreement with the experience and the results gathered in the analyses presented in the previous chapters. In the appendices special auxiliary functions and FORTRAN program listings are reported, to support the formulations used in the solution chapters.

CFD modeling of two-phase boiling flows in the slug flow regime with an interface capturing technique

The objective of this thesis was to improve the commercial CFD software Ansys Fluent to obtain a tool able to perform accurate simulations of flow boiling in the slug flow regime. The achievement of a reliable numerical framework allows a better understanding of the bubble and flow dynamics induced by the evaporation and makes possible the prediction of the wall heat transfer trends. In order to save computational time, the flow is modeled with an axisymmetrical formulation. Vapor and liquid phases are treated as incompressible and in laminar flow. By means of a single fluid approach, the flow equations are written as for a single phase flow, but discontinuities at the interface and interfacial effects need to be accounted for and discretized properly. Ansys Fluent provides a Volume Of Fluid technique to advect the interface and to map the discontinuous fluid properties throughout the flow domain. The interfacial effects are dominant in the boiling slug flow and the accuracy of their estimation is fundamental for the reliability of the solver. Self-implemented functions, developed ad-hoc, are introduced within the numerical code to compute the surface tension force and the rates of mass and energy exchange at the interface related to the evaporation. Several validation benchmarks assess the better performances of the improved software. Various adiabatic configurations are simulated in order to test the capability of the numerical framework in modeling actual flows and the comparison with experimental results is very positive. The simulation of a single evaporating bubble underlines the dominant effect on the global heat transfer rate of the local transient heat convection in the liquid after the bubble transit. The simulation of multiple evaporating bubbles flowing in sequence shows that their mutual influence can strongly enhance the heat transfer coefficient, up to twice the single phase flow value.

Paleosecular variation of the magnetic field recorded in Pleistocene-holocene volcanics from Pantelleria (italy) and Azores archipelago (portugal): implications for local volcanic history

The primary goal of volcanological studies is to reconstruct the eruptive history of active volcanoes, by correlating and dating volcanic deposits, in order to depict a future scenario and determine the volcanic hazard of an area. However, alternative methods are necessary where the lack of outcrops, the deposit variability and discontinuity make the correlation difficult, and suitable materials for an accurate dating lack. In this thesis, paleomagnetism (a branch of Geophysics studying the remanent magnetization preserved in rocks) is used as a correlating and dating tool. The correlation is based on the assumption that coeval rocks record similar paleomagnetic directions; the dating relies upon the comparison between paleomagnetic directions recorded by rocks with the expected values from references Paleo-Secular Variation curves (PSV, the variation of the geomagnetic field along time). I first used paleomagnetism to refine the knowledge of the pre – 50 ka geologic history of the Pantelleria island (Strait of Sicily, Italy), by correlating five ignimbrites and two breccias deposits emplaced during that period. Since the use of the paleomagnetic dating is limited by the availability of PSV curves for the studied area, I firstly recovered both paleomagnetic directions and intensities (using a modified Thellier method) from radiocarbon dated lava flows in São Miguel (Azores Islands, Portugal), reconstructing the first PSV reference curve for the Atlantic Ocean for the last 3 ka. Afterwards, I applied paleomagnetism to unravel the chronology and characteristics of Holocene volcanic activity at Faial (Azores) where geochronological age constraints lack. I correlated scoria cones and lava flows yielded by the same eruption on the Capelo Peninsula and dated eruptive events (by comparing paleomagnetic directions with PSV from France and United Kingdom), finding that the volcanics exposed at the Capelo Peninsula are younger than previously believed, and entirely comprised in the last 4 ka.

Analisi degli aspetti di qualità nella gestione dei sistemi di drenaggio urbano attraverso modellazione numerica e indagini di campo

In order to protect river water quality, highly affected in urban areas by continuos as intermittent immissions, it is necessary to adopt measures to intercept and treat these polluted flows. In particular during rain events, river water quality is affected by CSOs activation. Built in order to protect the sewer system and the WWTP by increased flows due to heavy rains, CSOs divert excess flows to the receiving water body. On the basis of several scientific papers, and of direct evidences as well, that demonstrate the detrimental effect of CSOs discharges, also the legislative framework moved towards a stream standard point of view. The WFD (EU/69/2000) sets new goals for receiving water quality, and groundwater as well, through an integrated immission/emissions phylosophy, in which emission limits are associated with effluent standards, based on the receiving water characteristics and their specific use. For surface waters the objective is that of a “good” ecological and chemical quality status. A surface water is defined as of good ecological quality if there is only slight departure from the biological community that would be expected in conditions of minimal anthropogenic impact. Each Member State authority is responsible for preparing and implementing a River Basin Management Plan to achieve the good ecological quality, and comply with WFD requirements. In order to cope with WFD targets, and thus to improve urban receiving water quality, a CSOs control strategy need to be implemented. Temporarily storing the overflow (or at least part of it) into tanks and treating it in the WWTP, after the end of the storm, showed good results in reducing total pollutant mass spilled into the receiving river. Italian State Authority, in order to comply with WFD statements, sets general framework, and each Region has to adopt a Water Remediation Plan (PTA, Piano Tutela Acque), setting goals, methods, and terms, to improve river water quality. Emilia Romagna PTA sets 25% reduction up to 2008, and 50% reduction up to 2015 fo total pollutants masses delivered by CSOs spills. In order to plan remediation actions, a deep insight into spills dynamics is thus of great importance. The present thesis tries to understand spills dynamics through a numerical and an experimental approach. A four months monitoring and sampling campaign was set on the Bologna sewer network, and on the Navile Channel, that is the WWTP receiving water , and that receives flows from up to 28 CSOs during rain events. On the other hand, the full model of the sewer network, was build with the commercial software InfoWorks CS. The model was either calibrated with the data from the monitoring and sampling campaign. Through further model simulations interdependencies among masses spilled, rain characteristics and basin characteristics are looked for. The thesis can be seen as a basis for further insighs and for planning remediation actions.

Effetti degli accordi Euro-Mediterrani sul comparto dell'ortofrutta fresca

In 1995, the European Union (EU) Member States and 12 Mediterranean countries launched in Barcelona a liberalization process that aims at establishing a free trade area (to be realized by 2010) and at promoting a sustainable and balanced economic development by the adoption of a new generation of Agreements: the Euro-Mediterranean Agreements (EMA). For the Mediterranean partner countries, the main concern is a better access for their fruit and vegetable exports to the European market. These products represent the main exports of these countries, and the EU is their first trading partner. On the other side, for the EU the main issue is not only the promotion of its products, but also the protection of its fruit and vegetables producers. Moreover, the trade with third countries is the key element of the Common Market Organization of the sector. Fruit and vegetables represent a very sensitive sector since their high seasonality, high perishability, and especially since the production of the Mediterranean countries is often similar to the European Mediterranean’s countries one. In fact, the agreements define preferences at the entrance of the EU market providing limited concessions for each partner, for specific products, limited quantities and calendars. This research tries to analyze the bilateral trade volume for fresh fruit and vegetables in the European and Italian markets in order to assess the effects of Mediterranean liberalization on this sector. Free trade of agricultural products represents a very actual topic in international trade and the Mediterranean countries, recognised as big producers of fruit and vegetables, as big exporters of their crops and actually significantly present on the European market, could be high competitors with the inward production because the outlet could be the same. The goal of this study is to provide some considerations about the competitiveness of mediterranean fruit and vegetables productions after Barcelona Process, in a first step for the European market and then also for the Italian one. The aim is to discuss the influence of the euro-mediterranean agreements on the fruit and vegetables trade between 10 foreign Mediterranean countries (Algeria, Egypt, Israel, Jordan, Libya, Lebanon, Morocco, Tunisia, Syria, and Turkey) and 15 EU countries in the period 1995-2007, by means of a gravity model, which is a widespread methodology in international trade analysis. The basic idea of gravity models is that bilateral trade from one country to another (as the dependent variable) can be explained by a set of factors: - factors that capture the potential of a country to export goods and services; - factors that capture the propensity of a country to imports goods and services; - any other forces that either attract or inhibit bilateral trade. This analysis compares only imports’ flows by Europe and by Italy (in volumes) from Mediterranean countries, since the exports’ flows toward those foreign countries are not significant, especially for Italy. The market of fruit and vegetables appears as a high heterogeneous group so it is very difficult to show a synthesis of the analysis performed and the related results. In fact, this sector includes the so called “poor products” (such as potatoes and legumes), and the “rich product”, such as nuts or exotic fruit, and there are a lot of different goods that arouse a dissimilar consumer demand which directly influence the import requirements. Fruit and vegetables sector includes products with extremely different biological cycles, leading to a very unlike seasonality. Moreover, the Mediterranean area appears as a highly heterogeneous bloc, including countries which differ from the others for economic size, production potential, capability to export and for the relationships with the EU. The econometric estimation includes 68 analyses, 34 of which considering the European import and 34 the Italian import and the products are examined in their aggregated form and in their disaggregated level. The analysis obtains a very high R2 coefficient, which means that the methodology is able to assess the import effects on fruit and vegetables associated to the Association Agreements, preferential tariffs, regional integration, and others information involved in the equation. The empirical analysis suggests that fruits and vegetables trade flows are well explained by some parameters: size of the involved countries (especially GDP and population of the Mediterranean countries); distances; prices of imported products; local production for the aggregated products; preferential expressed tariffs like duty free; sub-regional agreements that enforce the export capability. The euro-mediterranean agreements are significant in some of the performed analysis, confirming the slow and gradual evolution of euro- Mediterranean liberalization. The euro-mediterranean liberalization provides opportunities from one side, and imposes a new important challenge from the other side. For the EU the chance is that fruit and vegetables imported from the mediterranean area represent a support for local supply and a possibility to increase the range of products existing on the market. The challenge regards the competition of foreign products with the local ones since the types of productions are similar and markets coincide, especially in the Italian issue. We need to apply a strategy based not on a trade antagonism, but on the realization of a common plane market with the Mediterranean countries. This goal could be achieved enhancing the industrial cooperation in addition to commercial relationships, and increasing investments’ flows in the Mediterranean countries aiming at transforming those countries from potential competitors to trade partners and creating new commercial policies to export towards extra European countries.

Un approccio innovativo alla pianificazione della mobilità ciclabile

L’approccio innovativo di questa tesi alla pianificazione ciclabile consiste nell’integrare le linee guida per la redazione di un biciplan con aspetti, metodologie e strumenti nuovi, per rendere più efficace la programmazione di interventi. I limiti del biciplan risiedono nella fase di pianificazione e di monitoraggio, quindi, nel 1° capitolo, vengono esaminate le differenze esistenti tra la normativa americana (AASHTO) e quella italiana (D.P.R. 557/99). Nel 2° capitolo vengono analizzati gli indicatori usati nella fase di monitoraggio e la loro evoluzione fino alla definizione degli attuali indici per la determinazione del LOS delle infrastrutture ciclabili: BLOS e BCI. L’analisi è integrata con le nuove applicazioni di questi indici e con lo studio del LOS de HCM 2010. BCI e BISI sono stati applicati alla rete di Bologna per risolvere problemi di pianificazione e per capire se esistessero problemi di trasferibilità. Gli indici analizzati prendono in considerazione solo il lato offerta del sistema di trasporto ciclabile; manca un giudizio sui flussi, per verificare l’efficacia delle policy. Perciò il 3° capitolo è dedicato alla metodologia sul monitoraggio dei flussi, mediante l’utilizzo di comuni traffic counter per le rilevazioni dei flussi veicolari. Dal monitoraggio è possibile ricavare informazioni sul numero di passaggi, periodi di punta, esistenza di percorsi preferiti, influenza delle condizioni climatiche, utili ai progettisti; si possono creare serie storiche di dati per controllare l’evoluzione della mobilità ciclabile e determinare l’esistenza di criticità dell’infrastruttura. L’efficacia della pianificazione ciclabile è legata al grado di soddisfazione dell’utente e all’appetibilità delle infrastrutture, perciò il progettista deve conoscere degli elementi che influenzano le scelte del ciclista. Nel 4° capitolo sono analizzate le tecniche e gli studi sulle scelte dell’itinerario dei ciclisti, e lo studio pilota fatto a Bologna per definire le variabili che influenzano le scelte dei ciclisti e il loro peso.