Intrinsic uncoupling in the ATP synthase of Escherichia coli. Studies on WT and ε-truncated mutants

The H+/ATP ratio in the catalysis of ATP synthase has generally been considered a fixed parameter. However, Melandri and coworkers have recently shown that, in the ATP synthase of the photosynthetic bacterium Rb.capsulatus, this ratio can significantly decrease during ATP hydrolysis when the concentration of either ADP or Pi is maintained at a low level (Turina et al., 2004). The present work has dealt with the ATP synthase of E.coli, looking for evidence of this phenomenon of intrinsic uncoupling in this organism as well. First of all, we have shown that the DCCD-sensitive ATP hydrolysis activity of E.coli internal membranes was strongly inhibited by ADP and Pi, with a half-maximal effect in the submicromolar range for ADP and at 140 µM for Pi. In contrast to this monotonic inhibition, however, the proton pumping activity of the enzyme, as estimated under the same conditions by the fluorescence quenching of the ΔpH-sensitive probe ACMA, showed a clearly biphasic progression, both for Pi, increasing from 0 up to approximately 200 µM, and for ADP, increasing from 0 up to a few µM. We have interpreted these results as indicating that the occupancy of ADP and Pi binding sites shifts the enzyme from a partially uncoupled state to a fully coupled state, and we expect that the ADP- and Pi-modulated intrinsic uncoupling is likely to be a general feature of prokaryotic ATP synthases. Moreover, the biphasicity of the proton pumping data suggested that two Pi binding sites are involved. In order to verify whether the same behaviour could be observed in the isolated enzyme, we have purified the ATP synthase of E.coli and reconstituted it into liposomes. Similarly as observed in the internal membrane preparation, in the isolated and reconstituted enzyme it was possible to observe inhibition of the hydrolytic activity by ADP and Pi (with half-maximal effects at few µM for ADP and at 400 µM for Pi) with a concomitant stimulation of proton pumping. Both the inhibition of ATP hydrolysis and the stimulation of proton pumping as a function of Pi were lost upon ADP removal by an ADP trap. These data have made it possible to conclude that the results obtained in E.coli internal membranes are not due to the artefactual interference of enzymatic activities other than the ones of the ATP synthase. In addition, data obtained with liposomes have allowed a calibration of the ACMA signal by ΔpH transitions of known extent, leading to a quantitative evaluation of the proton pumping data. Finally, we have focused our efforts on searching for a possible structural candidate involved in the phenomenon of intrinsic uncoupling. The ε-subunit of the ATP-synthase is known as an endogenous inhibitor of the hydrolysis activity of the complex and appears to undergo drastic conformational changes between a non-inhibitory form (down-state) and an inhibitory form (up-state)(Rodgers & Wilce, 2000; Gibbons et al., 2000). In addition, the results of Cipriano & Dunn (2006) indicated that the C-terminal domain of this subunit played an important role in the coupling mechanism of the pump, and those of Capaldi et al. (2001), Suzuki et al. (2003) were consistent with the down-state showing a higher hydrolysis-to-synthesis ratio than the up-state. Therefore, we decided to search for modulation of pumping efficiency in a C-terminally truncated ε mutant. A low copy number expression vector has been built, carrying an extra copy of uncC, with the aim of generating an ε-overexpressing E.coli strain in which normal levels of assembly of the mutated ATP-synthase complex would be promoted. We have then compared the ATP hydrolysis and the proton pumping activity in membranes prepared from these ε-overexpressing E.coli strains, which carried either the WT ε subunit or the ε88-stop truncated form. Both strains yielded well energized membranes. Noticeably, they showed a marked difference in the inhibition of hydrolysis by Pi, this effect being largely lost in the truncated mutant. However, pre-incubation of the mutated enzyme with ADP at low nanomolar concentrations (apparent Kd = 0.7nM) restored the hydrolysis inhibition, together with the modulation of intrinsic uncoupling by Pi, indicating that, contrary to wild-type, during membrane preparation the truncated mutant had lost the ADP bound at this high-affinity site, evidently due to a lower affinity (and/or higher release) for ADP of the mutant relative to wild type. Therefore, one of the effects of the C-terminal domain of ε appears to be to modulate the affinity of at least one of the binding sites for ADP. The lack of this domain does not appear so much to influence the modulability of coupling efficiency, but instead the extent of this modulation. At higher preincubated ADP concentrations (apparent Kd = 117nM), the only observed effects were inhibition of both hydrolysis and synthesis, providing a direct proof that two ADP-binding sites on the enzyme are involved in the inhibition of hydrolysis, of which only the one at higher affinity also modulates the coupling efficiency.

Fiber beam-columns models with flexure-shear interaction for nonlinear analysis of reinforced concrete structures

The aim of this study was to develop a model capable to capture the different contributions which characterize the nonlinear behaviour of reinforced concrete structures. In particular, especially for non slender structures, the contribution to the nonlinear deformation due to bending may be not sufficient to determine the structural response. Two different models characterized by a fibre beam-column element are here proposed. These models can reproduce the flexure-shear interaction in the nonlinear range, with the purpose to improve the analysis in shear-critical structures. The first element discussed is based on flexibility formulation which is associated with the Modified Compression Field Theory as material constitutive law. The other model described in this thesis is based on a three-field variational formulation which is associated with a 3D generalized plastic-damage model as constitutive relationship. The first model proposed in this thesis was developed trying to combine a fibre beamcolumn element based on the flexibility formulation with the MCFT theory as constitutive relationship. The flexibility formulation, in fact, seems to be particularly effective for analysis in the nonlinear field. Just the coupling between the fibre element to model the structure and the shear panel to model the individual fibres allows to describe the nonlinear response associated to flexure and shear, and especially their interaction in the nonlinear field. The model was implemented in an original matlab® computer code, for describing the response of generic structures. The simulations carried out allowed to verify the field of working of the model. Comparisons with available experimental results related to reinforced concrete shears wall were performed in order to validate the model. These results are characterized by the peculiarity of distinguishing the different contributions due to flexure and shear separately. The presented simulations were carried out, in particular, for monotonic loading. The model was tested also through numerical comparisons with other computer programs. Finally it was applied for performing a numerical study on the influence of the nonlinear shear response for non slender reinforced concrete (RC) members. Another approach to the problem has been studied during a period of research at the University of California Berkeley. The beam formulation follows the assumptions of the Timoshenko shear beam theory for the displacement field, and uses a three-field variational formulation in the derivation of the element response. A generalized plasticity model is implemented for structural steel and a 3D plastic-damage model is used for the simulation of concrete. The transverse normal stress is used to satisfy the transverse equilibrium equations of at each control section, this criterion is also used for the condensation of degrees of freedom from the 3D constitutive material to a beam element. In this thesis is presented the beam formulation and the constitutive relationships, different analysis and comparisons are still carrying out between the two model presented.

Development and applications of hollow fiber flow field-flow fractionation in the bioanalytical field. Studies of aggregation phenomena in complex protein samples

Recent advances in the fast growing area of therapeutic/diagnostic proteins and antibodies - novel and highly specific drugs - as well as the progress in the field of functional proteomics regarding the correlation between the aggregation of damaged proteins and (immuno) senescence or aging-related pathologies, underline the need for adequate analytical methods for the detection, separation, characterization and quantification of protein aggregates, regardless of the their origin or formation mechanism. Hollow fiber flow field-flow fractionation (HF5), the miniaturized version of FlowFFF and integral part of the Eclipse DUALTEC FFF separation system, was the focus of this research; this flow-based separation technique proved to be uniquely suited for the hydrodynamic size-based separation of proteins and protein aggregates in a very broad size and molecular weight (MW) range, often present at trace levels. HF5 has shown to be (a) highly selective in terms of protein diffusion coefficients, (b) versatile in terms of bio-compatible carrier solution choice, (c) able to preserve the biophysical properties/molecular conformation of the proteins/protein aggregates and (d) able to discriminate between different types of protein aggregates. Thanks to the miniaturization advantages and the online coupling with highly sensitive detection techniques (UV/Vis, intrinsic fluorescence and multi-angle light scattering), HF5 had very low detection/quantification limits for protein aggregates. Compared to size-exclusion chromatography (SEC), HF5 demonstrated superior selectivity and potential as orthogonal analytical method in the extended characterization assays, often required by therapeutic protein formulations. In addition, the developed HF5 methods have proven to be rapid, highly selective, sensitive and repeatable. HF5 was ideally suitable as first dimension of separation of aging-related protein aggregates from whole cell lysates (proteome pre-fractionation method) and, by HF5-(UV)-MALS online coupling, important biophysical information on the fractionated proteins and protein aggregates was gathered: size (rms radius and hydrodynamic radius), absolute MW and conformation.