Growth performance, gut health, and metabolism of broilers under thermoneutral and heat stress conditions: multidisciplinary studies on the effects of nutritional strategies and genotype

This PhD project aimed to (i) investigate the effects of three nutritional strategies (supplementation of a synbiotic, a muramidase, or arginine) on growth performance, gut health, and metabolism of broilers fed without antibiotics under thermoneutral and heat stress conditions and to (ii) explore the impacts of heat stress on hypothalamic regulation of feed intake in three broiler lines from diverse stages of genetic selection and in the red jungle fowl, the ancestor of domestic chickens. Synbiotic improved feed efficiency and footpad health, increased Firmicutes and reduced Bacteroidetes in the ceca of birds kept in thermoneutral conditions, while did not mitigate the impacts of heat stress on growth performance. Under optimal thermal conditions, muramidase increased final body weight and reduced cumulative feed intake and feed conversion ratio in a dose-dependent way. The highest dose reduced the risk of footpad lesions, cecal alpha diversity, the Firmicutes to Bacteroidetes ratio, and butyrate producers, increased Bacteroidaceae and Lactobacillaceae, plasmatic levels of bioenergetic metabolites, and reduced the levels of pro-oxidant metabolites. The same dose, however, failed to reduce the effects of heat stress on growth performance. Arginine supplementation improved growth rate, final body weight, and feed efficiency, increased plasmatic levels of arginine and creatine and hepatic levels of creatine and essential amino acids, reduced alpha diversity, Firmicutes, and Proteobacteria (especially Escherichia coli), and increased Bacteroidetes and Lactobacillus salivarius in the ceca of thermoneutral birds. No arginine-mediated attenuation of heat stress was found. Heat stress altered protein metabolism and caused the accumulation of antioxidant and protective molecules in oxidative stress-sensitive tissues. Arginine supplementation, however, may have partially counterbalanced the effects of heat stress on energy homeostasis. Stable gene expression of (an)orexigenic neuropeptides was found in the four chicken populations studied, but responses to hypoxia and heat stress appeared to be related to feed intake regulation.

Optimization of an innovative T6 heat treatment for the AlSi10Mg alloy processed by Laser-based Powder Bed Fusion: effect on microstructure, mechanical properties, and tribological behavior

Laser-based Powder Bed Fusion (L-PBF) technology is one of the most commonly used metal Additive Manufacturing (AM) techniques to produce highly customized and value-added parts. The AlSi10Mg alloy has received more attention in the L-PBF process due to its good printability, high strength/weight ratio, corrosion resistance, and relatively low cost. However, a deep understanding of the effect of heat treatments on this alloy's metastable microstructure is still required for developing tailored heat treatments for the L-PBF AlSi10Mg alloy to overcome the limits of the as-built condition. Several authors have already investigated the effects of conventional heat treatment on the microstructure and mechanical behavior of the L-PBF AlSi10Mg alloy but often overlooked the peculiarities of the starting supersatured and ultrafine microstructure induced by rapid solidification. For this reason, the effects of innovative T6 heat treatment (T6R) on the microstructure and mechanical behavior of the L-PBF AlSi10Mg alloy were assessed. The short solution soaking time (10 min) and the relatively low temperature (510 °C) reduced the typical porosity growth at high temperatures and led to a homogeneous distribution of fine globular Si particles in the Al matrix. In addition, it increased the amount of Mg and Si in the solid solution available for precipitation hardening during the aging step. The mechanical (at room temperature and 200 °C) and tribological properties of the T6R alloy were evaluated and compared with other solutions, especially with an optimized direct-aged alloy (T5 alloy). Results showed that the innovative T6R alloy exhibits the best mechanical trade-off between strength and ductility, the highest fatigue strength among the analyzed conditions, and interesting tribological behavior. Furthermore, the high-temperature mechanical performances of the heat-treated L-PBF AlSi10Mg alloy make it suitable for structural components operating in mild service conditions at 200 °C.

Biological analysis of the in-vitro effects of homologous recombination inhibition and its use in cancer treatment through synthetic lethality

Synthetic lethality represents an anticancer strategy that targets tumor specific gene defects. One of the most studied application is the use of PARP inhibitors (e.g. olaparib) in BRCA1/2-less cancer cells. In BRCA2-defective tumors, olaparib (OLA) inhibits DNA single-strand break repair, while BRCA2 mutations hamper homologous recombination (HR) repair. The simultaneous impairment of those pathways leads BRCA-less cells to death by synthetic lethality. The projects described in this thesis were aimed at extending the use of OLA in cancer cells that do not carry a mutation in BRCA2 by combining this drug with compounds that could mimic a BRCA-less environment via HR inhibition. We demonstrated the effectiveness of our “fully small-molecule induced synthetic lethality” by using two different approaches. In the direct approach (Project A), we identified a series of neo-synthesized compounds (named RAD51-BRCA2 disruptors) that mimic BRCA2 mutations by disrupting the RAD51-BRCA2 interaction and thus the HR pathway. Compound ARN 24089 inhibited HR in human pancreatic adenocarcinoma cell line and triggered synthetic lethality by synergizing with OLA. Interestingly, the observed synthetic lethality was triggered by tackling two biochemically different mechanisms: enzyme inhibition (PARP) and protein-protein disruption (RAD51-BRCA2). In the indirect approach (Project B), we inhibited HR by interfering with the cellular metabolism through inhibition of LDH activity. The obtained data suggest an LDH-mediated control on HR that can be exerted by regulating either the energy supply needed to this repair mechanism or the expression level of genes involved in DNA repair. LDH inhibition also succeeded in increasing the efficiency of OLA in BRCA-proficient cell lines. Although preliminary, these results highlight a complex relationship between metabolic reactions and the control of DNA integrity. Both the described projects proved that our “fully small-molecule-induced synthetic lethality” approach could be an innovative approach to unmet oncological needs.